Manual de instrucciones de Code Alarm Professional Series CA 5050

Resumen del contenido incluido en la página 1

PROFESSIONAL
SERIES
CA 5050
Owner’s Guide
Remote Start System with
Keyless Entry
IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is
applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR
SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information.
2009 Audiovox Electronics Corporation. All rights reserved. 1

Resumen del contenido incluido en la página 2

Table of Contents Using Your Remote Control ............................................................... 3 Using the Keyless Entry ................................................................... 3 Activating Trunk Release (optional) ................................................ 3 Using the Progressive Car Finder Feature ...................................... 3 Using the Personal Protection Alarm ............................................... 3 Valet Mode ..............................

Resumen del contenido incluido en la página 3

Using Your Remote Control Using the Keyless Entry The button is used to lock the vehicle's doors, the button is used to unlock the vehicle's doors. To lock or unlock the doors simply press and release the desired function button one time. For your convenience, the parking lights will flash once when the doors are unlocked and twice when the door are locked. NOTE: The system is defaulted with Silent Choice enabled, which requires a second press of the or button to activate an audible locking

Resumen del contenido incluido en la página 4

Remote Starting Your Vehicle To activate the remote vehicle start function, press and release the button 2 times within 2 seconds. The system will sound, the parking lights will flash 1 time and the system will check the vehicle to ensure it is safe to start. If all safety parameters are correct, the vehicle will start within 5 seconds. The vehicle’s parking lights will turn on (or flash depending on system settings) as a visual indication that the vehicle has started and is running. Pres

Resumen del contenido incluido en la página 5

Operating the 2 / 3 Hour Start Up Timer Mode The system has the ability to start the vehicle every 2 or 3 hours for a 48 hour period. This feature is especially useful in cold climates where the only means to keep the engine and engine fluids warm is to periodically start the engine. The default setting is 3 hour, selection between 2 or 3 hour is made in option programming. WARNING! Be certain that the vehicle is outdoors before using this or any remote starting device. A running engine prod

Resumen del contenido incluido en la página 6

Remote Start Safety Features For safety and security reasons, the system will shutdown or prevent the remote vehicle starter from activating if any of the following occur: 1. The vehicle hood is open. 2. The brake pedal is pressed prior to turning the ignition key to the ON position. 3. The engine is over-reved (tach checking only). 4. Valet mode is active. Transmitter Button Functions Replacing Remote Control Batteries 1-Way Remote Control: The batteries (model CR2016) inside each remote co

Resumen del contenido incluido en la página 7

Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGI- NALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts d

Resumen del contenido incluido en la página 8

Audiovox Electronics Corporation. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including any interference that may cause undesired operation. Warning! Changes or modifications not expressly approved by the party responsible for