Resumen del contenido incluido en la página 1
Installation Instructions
30” Free-Standing Gas Range
Instructions d’installation
Cuisinière à gaz autonome de 76,2 cm (30 po)
316469105 Rev B
Resumen del contenido incluido en la página 2
Anchor
Resumen del contenido incluido en la página 3
INSTALLATION INSTRUCTIONS FOR FREESTANDING GAS RANGE INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. FOR YOUR SAFETY: Refer to your serial plate for applicable agency certification — Do not store or use gasoline or other flammab
Resumen del contenido incluido en la página 4
INSTALLATION INSTRUCTIONS FOR FREESTANDING GAS RANGE Important Notes to the Installer Never leave children alone or unattended 1. Read all instructions contained in these installation in the area where an appliance is in use. As children grow, instructions before installing range. teach them the proper, safe use of all appliances. Never leave 2. Remove all packing material from the oven compartments the oven door open when the range is unattended. before connecting the gas and electrical supply
Resumen del contenido incluido en la página 5
INSTALLATION INSTRUCTIONS FOR FREESTANDING GAS RANGE A. Locate the Bracket Using the Template - (Bracket may Before Starting be located on either the left or right side of the appliance. Use Tools You Will Need the information below to locate the bracket if template is not For leveling legs and Anti-Tip Bracket: available). Mark the floor or wall where left or right side of the range will be located. If rear of appliance is against the wall or Adjustable wrench or channel lock pliers no fu
Resumen del contenido incluido en la página 6
INSTALLATION INSTRUCTIONS FOR FREESTANDING GAS RANGE C. Level & Position Appliance - Level appliance by adjusting the (4) leveling legs with a wrench. NOTE: A minimum clearance of 1/8" is required between the bottom of the appliance and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments. Slide appliance back into position. Visually check that rear leveling leg is inserted into and fully secured by the Anti-Tip Bracket by removing lower panel or storage
Resumen del contenido incluido en la página 7
INSTALLATION INSTRUCTIONS FOR FREESTANDING GAS RANGE the 1/2" flare union adapter with an adjustable wrench before tightening the gas supply fitting and/or appliance conduit (Refer to Fig. 4e). d) Install flare union adapter to external manual shut-off valve. e) Attach appliance conduit to flare union on shut-off valve. f) Make sure service shut-off valve on pressure regulator is in the "ON" position (See Fig. 4f). g) Check for leaks. Turn the gas supply on to the appliance and use a liquid lea
Resumen del contenido incluido en la página 8
INSTALLATION INSTRUCTIONS FOR FREESTANDING GAS RANGE 6. Assembly of the Surface Burner Heads, Burner PLEASE READ CAREFULLY! For personal Caps and Burner Grates: safety, this product must be properly grounded. It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates are Grounding Instructions installed correctly. The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard Your appliance was
Resumen del contenido incluido en la página 9
INSTALLATION INSTRUCTIONS FOR FREESTANDING GAS RANGE REMEMBER — DO NOT ALLOW SPILLS, FOOD, Test to verify if “LO or LOW” setting should be adjusted (right front position ONLY): CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always a. Push in and turn knob to (lite) until burner ignites. keep the Burner Caps and Burner Heads in place whenever b. Push in and quickly turn knob to LOWEST POSITION. the surface burners are in use. c. If burner goes out, reset control
Resumen del contenido incluido en la página 10
INSTALLATION INSTRUCTIONS FOR FREESTANDING GAS RANGE After removing all packing materials and literature from the oven: To determine if the broil burner flame is proper, set the oven to a) Set oven to BAKE at 300ºF. See Use & Care Manual for broil. If the flame is yellow in color, increase air shutter opening operating instructions. size. (See "2" in illustration above.) If the flame is a distinct blue, b) Within 60 seconds the oven burner should ignite. Check for reduce the air shutter opening
Resumen del contenido incluido en la página 11
Anchor Anchor
Resumen del contenido incluido en la página 12
