Manual de instrucciones de Xantech RF2IR2W

Resumen del contenido incluido en la página 1

RF2IR2W
RF To IR/RS232 Converter-2Way





Quick Start
Installation Instructions



- 1 -

Resumen del contenido incluido en la página 2

ATTENTION: Requires the XTR39 to operate. - 2 -

Resumen del contenido incluido en la página 3

Welcome! The RF2IR2W base station is the ultimate Xantech accessory to the Xantech XTR39 Color LCD remote color. It’s a receiver that accepts the Radio Frequency output of the XTR39 remote and translate it into IR and RS232 command signals that can control virtually any IR or RS232 electronic device. It can also receive Data Dictionary RS232 commands and transmit them via RF back to the XTR39 allowing for real-time feedback on the XTR39 display for volume feedback and device status.

Resumen del contenido incluido en la página 4

RF2IR2W Diagram (Front) IR and RF LED behavior: IR LED RF LED RF2IR2W Action On Flash Emit IR Commands Flash Flash Output RS232 Commands Off Flash Receive RS232 Commands Quick Start Instructions Step 1. Plug the (4) 283M emitters (included) into the RF2IR2W. Next, place the 283M emitter head directly over the IR eye on the source component to be controlled. Step 2. Plug the RS232 Adapter Cable into the RF2IR2W port labeled RS232. Next, connect the DB9 plug to the sou

Resumen del contenido incluido en la página 5

Step 3. Plug the power supply into the RF2IR2W port labeled 12VDC. The IR and RF LED lights will illuminate for 10 seconds. This is part of the start-up sequence. After the LED lights turn ‘off’, the RF2IR2W is ready to be used. Step 4. Follow the XTR39 Instructions, RF2IR2W Addendum and follow the steps to setup the XTR39. - 5 -

Resumen del contenido incluido en la página 6

Locating the RF2IR2W Thanks to Xantech’s superior antenna design, the RF2IR2W can be placed in several locations. Key Location Points: • The RF2IR2W should be placed on a flat, stable surface. • For optimal performance, the RF2IR2W should be placed at a height greater than 3 feet above the floor. The ideal height should be level to the XTR39 transmitter. • Avoid placing the RF2IR2W near corners of a room. • Avoid placing the RF2IR2W next to microwave ovens. • Using a lower Ch