Manual de instrucciones de Metra Electronics 95-7321

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS FOR PART 95-7321
APPLICATIONS
Hyundai Accent 2006-2010
Kia Rio / RIO 5 2006-2010
Kia Sportage 2005-2010
95-7321
KIT FEATURES
• DDIN Head Unit Provision
• ISO Stacked Head Unit Provision
KIT COMPONENTS
A) DDIN Brackets B) DDIN Trim Plate
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
HARNESS:
• 70-7303 - Hyundai / Kia Harness 2009
• 70-1004 - Hyundai 2006-up/KIA harness 2004-up
ANTENNA ADAPTER:
A
B
• 40-KI11 - KIA antenna adapter 2007-up
• 40-KI10 - KI

Resumen del contenido incluido en la página 2

95-7321 TABLE OF CONTENTS Dash Disassembly ........................................................................ 1-2 Kit Preparation ................................................................................. 3 Kit Assembly ..................................................................................... 4 Metra recommends MECP certified technicians

Resumen del contenido incluido en la página 3

DASH DISASSEMBLY 95-7321 HYUNDAI ACCENT 2006-2010 KIA RIO / RIO 5 2006-2010 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the trim panel surrounding the radio and including the a/c vents. (Figure A) Remove (4) Phillips screws securing 3 the radio. (Figure B) B 1

Resumen del contenido incluido en la página 4

95-7321 DASH DISASSEMBLY KIA SPORTAGE 2005-2010 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the entire panel surrounding the radio and including the A/C controls. Note: Start at bottom of panel. (Figure A) 3 Remove (4) Phillips screws to extract radio from dash. (Figure B) B 2

Resumen del contenido incluido en la página 5

95-7321 KIT PREPARATION A 1 HYUNDAI ACCENT: Cut and remove shaded areas. (Figure A) B 2 KIA RIO: Cut and remove shaded areas. (Figure B) B 3 KIA SPORTAGE: Cut and remove shaded areas. (Figure C) 3

Resumen del contenido incluido en la página 6

95-7321 KIT ASSEMBLY DOUBLE DIN / STACKED ISO DIN HEAD UNIT PROVISION 1 Locate the factory wiring harness in A the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2 Attach the Double DIN brackets to the inside edge of the Double DIN trim plate. (Figure A) Slide the Double DIN head unit or 3 stacked ISO head units into the B bracket/radio housing assembly and secure the Double DIN hea

Resumen del contenido incluido en la página 7

95-7321 NOTES

Resumen del contenido incluido en la página 8

95-7321 INSTRUCTIONS METRA. THE WORLD’S BEST KITS.™ 1-800-221-0932 www.metraonline.com © COPYRIGHT 2010 METRA ELECTRONICS CORPORATION INST95-7321 REV. 04/26/10