Resumen del contenido incluido en la página 1
HDO2200
DLP™ Projector
Users Manual v1.0
D Series
9
Resumen del contenido incluido en la página 2
Copyright This publication, including all photographs, illustrations and software, is protected under international copy- right laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author. © Copyright 2012 Disclaimer The information in this document is subject to change without notice. The manufacturer makes no repre- sentations or warranties with respect to the contents hereof and specifi
Resumen del contenido incluido en la página 3
DLP Projector —User ’s Manual DLP Projector —User ’s Manual DLP Projector —User ’s Manual Important Safety Information Important: It is strongly recommended that you read this section carefully before using the projector. These safety and usage instructions will ensure that you enjoy many years of safe use of the projector. Keep this manual for future reference. Symbols Used Warning symbols are used on the unit and in this manual to alert you of hazardous situations. The follow
Resumen del contenido incluido en la página 4
Preface Preface Preface Projector Installation Notice Place the projector in a horizontal position The tilt angle of the projector should not exceed 15 degrees, nor should the projector be installed in any way other than the desktop and ceiling mount, otherwise lamp life could decrease dramatically. Allow at least 50 cm clearance around the exhaust vent. Ensure that the intake vents do not recycle hot air from the exhaust vent. When opera
Resumen del contenido incluido en la página 5
DLP Projector —User ’s Manual DLP Projector —User ’s Manual DLP Projector —User ’s Manual Replacing the Lamp Replacing the lamp can be hazardous if done incorrectly. See Replacing the Projection Lamp on page 37 for clear and safe instructions for this procedure. Before replacing the lamp: Unplug the power cord. Allow the lamp to cool for about one hour. Caution: In rare cases the lamp bulb may burn out during normal operation and cause glass dust or shards to be discharged
Resumen del contenido incluido en la página 6
Preface Preface Preface Table of Contents GETTING STARTED .......................................................................................................................................................... 1 PACKING CHECKLIST ........................................................................................................................................................... 1 VIEWS OF PROJECTOR PARTS...........................................................................
Resumen del contenido incluido en la página 7
DLP Projector —User ’s Manual DLP Projector —User ’s Manual DLP Projector —User ’s Manual SPECIFICATIONS............................................................................................................................................................. 46 SPECIFICATIONS................................................................................................................................................................. 46 PROJECTION DISTANCE VS. PROJECTION SIZE .........
Resumen del contenido incluido en la página 8
DLP Projector – User ’s Manual DLP Projector – User ’s Manual DLP Projector – User ’s Manual GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included: DLP PROJECTOR REMOTE CONTROL VGA CABLE POWER CORD (WITH TWO AAA BATTERIES) CD-ROM WARRANTY CARD (THIS USER ’S MANUAL) Contact your dealer immediately if any items are missing, appear damaged, or if the
Resumen del contenido incluido en la página 9
DLP Projector —User ’s Manual DLP Projector —User ’s Manual DLP Projector —User ’s Manual Views of Projector Parts Front-right View 1 2 3 4 5 6 7 ITEM LABEL DESCRIPTION SEE PAGE: 1. Height-adjuster button Push to release height adjuster 13 Height adjuster Adjusts level of projector 2. Lens Projection Lens 3. IR receiver Receive IR signal from remote control 4. 6 Focus ring Focu
Resumen del contenido incluido en la página 10
DLP Projector – User ’s Manual DLP Projector – User ’s Manual DLP Projector – User ’s Manual Top view —On-screen Display (OSD) buttons and LEDs SEE ITEM LABEL DESCRIPTION PAGE: 1. Turns the projector On or Off. (Power button) 11 2. BLANK Displays a blank screen and mutes audio ◄ (Left cursor) / Navigates and changes settings in the OSD 3. Volume- Quick Menu – For Volume Enter Enter or confirm highlighted OSD menu item 4. 16
Resumen del contenido incluido en la página 11
DLP Projector —User ’s Manual DLP Projector —User ’s Manual DLP Projector —User ’s Manual Rear view ITEM LABEL DESCRIPTION SEE PAGE: AC IN Connect the POWER CABLE 1. 11 (USB) For servicing purpose only 2. COMPONENT IN Connect a component video enabled device 3. S-VIDEO IN Connect the S-VIDEO CABLE from a video device 4. VIDEO IN Connect the COMPOSITE CABLE from a video device 5.
Resumen del contenido incluido en la página 12
DLP Projector – User ’s Manual DLP Projector – User ’s Manual DLP Projector – User ’s Manual Bottom view ITEM LABEL DESCRIPTION SEE PAGE: Tilt adjustor Rotate adjuster lever to adjust angle position. 1. 13 Ceiling support holes Contact your dealer for information on mounting the projector on a ceiling 2. 3. Height adjustor Adjuster drops down when adjus
Resumen del contenido incluido en la página 13
DLP Projector —User ’s Manual DLP Projector —User ’s Manual DLP Projector —User ’s Manual Remote Control Parts Important: 1. Avoid using the projector with bright fluorescent lighting turned on. Certain high-frequency fluo- rescent lights can disrupt remote control operation. 2. Be sure nothing obstructs the path between the remote control and the projector. If the path be- tween the remote
Resumen del contenido incluido en la página 14
DLP Projector – User ’s Manual DLP Projector – User ’s Manual DLP Projector – User ’s Manual ITEM LABEL DESCRIPTION SEE PAGE: IR transmitter Transmits signals to projector 1. Status LED Lights when the remote control is used 2. Laser Press to operate the on-screen pointer 3. Up Up arrow when connected through USB to a PC (Not available in this series) 4. Right Right arrow when connected through USB to a PC (Not available in this series) 5. Down Down arrow when connected through U
Resumen del contenido incluido en la página 15
DLP Projector —User ’s Manual DLP Projector —User ’s Manual DLP Projector —User ’s Manual Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not necessary to point the remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or the rear of the projector, the remote will function well within a radius of about 7 meters (23 feet) and 15 degrees above or below the projector level. If th
Resumen del contenido incluido en la página 16
DLP Projector – User ’s Manual DLP Projector – User ’s Manual DLP Projector – User ’s Manual SETUP AND OPERATION Inserting the Remote Control Batteries Remove the battery compartment cover 1. by sliding the cover in the direction of the arrow. Insert the battery with the positive side 2. facing up. Replace the cover. 3. Caution: 1. Only use AAA batteries (Alkaline batteries are re
Resumen del contenido incluido en la página 17
DLP Projector —User ’s Manual DLP Projector —User ’s Manual DLP Projector —User ’s Manual Connecting Input Devices A PC or notebook computer and video devices can be connected to the projector at the same time. Video devices include DVD, VCD, and VHS players, as well as movie camcorders and digital still cameras. Check the user manual of the connecting device to confirm it has the appropriate output connector. ITEM LABEL DESCRIPTION
Resumen del contenido incluido en la página 18
DLP Projector – User ’s Manual DLP Projector – User ’s Manual DLP Projector – User ’s Manual Starting and Shutting down the Projector Connect the power cord to the projector. 1. Connect the other end to a wall outlet. The POWER LED will be on. Turn on the connected devices. 2. 3. Ensure the POWER LED displays a solid blue and not a flashing blue. Then press the POWER button to turn on the projector. The projector splash screen displays and
Resumen del contenido incluido en la página 19
DLP Projector —User ’s Manual DLP Projector —User ’s Manual DLP Projector —User ’s Manual When the POWER OFF window ap- 5. pears, press on the control panel or on the remote control. The projec- tor turns off. Caution: Do not unplug the power cord until the READY LED stops flashing –indicating the projector has cooled down. – 12 –
Resumen del contenido incluido en la página 20
DLP Projector – User ’s Manual DLP Projector – User ’s Manual DLP Projector – User ’s Manual Adjusting the Projector Level Take note of the following when setting up the projector: • The projector table or stand should be level and sturdy. • Position the projector so that it is perpendicular to the screen. • Remove the Back Foot Holder on the rear adjuster foot before adjusting the projection angle. • Ensure the cables are in a safe location. You could trip over them. To
