Resumen del contenido incluido en la página 1
IN3102 IN3104 IN3106 IN3108
Regulatory models W3220, W3240 and W3260
010-0710-03
Resumen del contenido incluido en la página 2
Declaration of Conformity FCC Warning Manufacturer: InFocus Corporation, 13190 SW 68th Parkway, Portland, Note: This equipment has been tested and found to comply with the limits Oregon 97223-8368 USA for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful We declare under our sole responsibility that this projector conform to the interference in a residential installation. This equipment generates, uses
Resumen del contenido incluido en la página 3
8’/2.4m 2’/0.6m Table of Contents Important Operating Considerations for Safety Introduction 3 • Place the projector in a horizontal position no greater than 15 degrees Positioning the projector 5 off axis. Projector and device connector guide 6 • Locate the projector in a well-ventilated area without any obstructions Connecting a computer source 9 to intake or exhaust vents. Do not place the projector on a tablecloth or Required computer connections other soft covering that may block the v
Resumen del contenido incluido en la página 4
Introduction Your new digital projector is simple to connect, easy to use, and straightforward to maintain. It is a versatile projector that is flexible enough zoom (rear ring) for business presentations and home video viewing too. The IN3102/ touch keypad IN3104 has native XGA 1024x768 resolution, and the IN3106/IN3108 has focus (front ring) WXGA 1280x800 resolution. This guide applies to all products. They are compatible with a wide variety of computers and video devices. Product specifica
Resumen del contenido incluido en la página 5
Connector panel The projector provides both computer and video connection options, including: •VESA computer (2) composite HDMI for video monitor out • HDMI, for computer (1) and for video (1) video computer •S-video audio in S-video •Composite video • Separate audio inputs for video and computer • USB DisplayLink connector, for computer audio/video input. This USB connection also provides slide advance (and mouse control when used with an optional remote control only) The projector also pro
Resumen del contenido incluido en la página 6
Positioning the projector 10 ft high 10 ft high To determine where to position the projector, consider the size and shape of (IN3102 & IN3104) (IN3106 & IN3108) image image your screen, the location of your power outlets, and the distance between the projector and the rest of your equipment. Here are some general guidelines: • Position the projector on a flat surface at a right angle to the screen. The Projection angle Projection angle bottom of image bottom of image projector must be at le
Resumen del contenido incluido en la página 7
Table 2: (IN3106 & IN3108) Range of distance to the screen for a given screen size Distance to screen Minimum Diagonal Screen Maximum Distance (feet/ Size (inches/m) distance (feet/m) m) 80/2.0 9.7/2.9 8.7/2.7 90/2.3 10.9/3.3 9.8/3.0 150/3.8 18.1/5.5 16.3/5.0 6
Resumen del contenido incluido en la página 8
Projector and device connector guide The following illustration and table should help you find the connectors to use and obtain the best resolution possible from your input devices, such as computers, standard VCRs, DVD players (progressive and interlaced), HDTV sources (1080i, 1080p and 720p HDTV formats), TV and satellite tuners, camcorders, video games (progressive and interlaced), and laser disc players. composite HDMI for video monitor out video computer audio in S-video audio out 5 volt
Resumen del contenido incluido en la página 9
Attach to Adapter or If Your Device Video Device Video Compatibility Labeled Connector For Setup Instructions, see Comments Connector Is on Projector NTSC, PAL, and Composite video Video 3 Composite video connection on Not for progressive Standard Broadcast TV (not SECAM formats or S-video or Video 2 page 14. (i.e. HDTV) sources. HDTV) via: cable, digital cable, See page 9. satellite TV, DVD, or VCR S-video connection on page 14 NTSC, PAL, and Composite video Video 3 Composite video conne
Resumen del contenido incluido en la página 10
Attach to Adapter or If Your Device Video Device Video Compatibility Labeled Connector For Setup Instructions, see Comments Connector Is on Projector 1080i, 1080p, 720p VGA Computer 3 or VESA connection on page 14 Computer 2 Component 480i Component video Computer 3 or Component video connection on HDTV Computer 2 via page 14 (High Definition TV) optional VESA to Component adapter HDMI HDMI connection on page 14 1080i, 1080p, 720p VGA Computer 3 or VESA connection on page 14 Computer 2 Compo
Resumen del contenido incluido en la página 11
Connecting a computer source connect USB cable Required computer connections (DisplayLink or VESA) If your computer has Windows XP SP2 or newer*, connect the USB cable between your computer's USB port and the projector's DisplayLink connector, then follow the instructions on the screen. See the DisplayLink Manager MOLEX MOLEX User's Guide for more information. * For the latest information about support for other operating systems (including Apple), go to www.infocus.com/support/displaylink c
Resumen del contenido incluido en la página 12
Displaying an image press Power button Touch the Power button. The Power button blinks green and the fans start to run. When the lamp comes on, the start up screen displays and the Power button is steady green. It can take a minute for the image to achieve full brightness. ? No start up screen? Get help on page 16. turn on computer or Turn on your computer or video device. video device The image should appear on the projection screen. If it doesn’t, press the Source button on the projector’s
Resumen del contenido incluido en la página 13
Adjusting the image adjust height If necessary, adjust the height of the projector by pressing the elevator foot release button to extend the foot. release button If necessary, rotate the leveling foot located at the rear of the projector. elevator Avoid placing your hands near the hot exhaust vent at the side of the foot projector. Position the projector the desired distance from the screen at a 90 degree adjust distance angle to the screen. See page 5 for a table listing screen sizes and d
Resumen del contenido incluido en la página 14
Connecting a video device 4:3 screen 16:9 screen You can connect video devices such as VCRs, DVD players, camcorders, digital cameras, video game consoles, HDTV receivers, and TV tuners to the projector. You can connect the audio directly to the projector to get sound 4:3 Do Not Use from the built-in speaker, or you can bypass the projector’s audio system mode and connect the audio directly from your source to a stereo or home theater system. You can connect the projector to most video dev
Resumen del contenido incluido en la página 15
VESA connection Video device connections If your video device has a 15-pin VGA output, plug one end of the included No video cables are provided with the projector. You can order cables from computer cable into the VGA connector on your video source. This InFocus or provide your own. connector may be labeled “To Monitor” on the video source. Plug the computer cable into the Computer 3 or Computer 2 connector on the Composite video connection projector. Plug the composite video cable’s yello
Resumen del contenido incluido en la página 16
The Status Indicator Panel on top of the projector indicates the state of the Shutting down the projector projector and can help you troubleshoot. The projector automatically displays a black screen after no active source is detected for 30 minutes. This black screen helps preserve the life of the projector. The image returns when an active source is detected or a remote or keypad button is pressed. Table 3: Status indicator light behavior and meaning Screen Save Time You can make the black
Resumen del contenido incluido en la página 17
A A Problem Solution Result No start up screen Correct image Plug power cord into the projector press power button If your computer is using the projector's DisplayLink Computer image projected Only start up screen appears connector, see the DisplayLink User's Guide for troubleshooting information. Press the Source button activate laptop’s external port Restart laptop 16 Startup Screen Startup Screen A A
Resumen del contenido incluido en la página 18
A A A A Prolem Solution Result Press the Auto Image button on keypad adjust computer No computer image, just the words “Signal out of Computer image projected refresh rate in Control Panel > Display > Settings > Advanced range” > Adapter (location varies by operating system) You may also need to set a different resolution on your computer, as shown in the following problem, “image fuzzy or cropped” If your computer is using the DisplayLink connector, use Only my laptop’s background appears
Resumen del contenido incluido en la página 19
Prolem Solution Result Image fuzzy or cropped Set your computer’s display resolution to the native Image clear and not cropped resolution of the projector (Start > Settings > Control Panel > Display > Settings tab) A A A For a laptop, disable laptop monitor or turn- on dual-display mode Image not centered on screen Move projector, adjust zoom, adjust height Correct image Adjust horizontal or vertical position in Advanced Picture menu 18 A
Resumen del contenido incluido en la página 20
Prolem Solution Result Image not square Adjust Keystone on keypad Square image Image not sharp Adjust Sharpness in the Basic Picture menu Correct image Image does not fit 4:3 or 16:9 screen Change aspect ratio to 4:3 or 16:9 in Basic Correct image Picture>Aspect ratio menu 19
