Resumen del contenido incluido en la página 1
IN1100, IN1102
Regulatory models: W1100, W1102
010-1712-04
Resumen del contenido incluido en la página 2
Declaration of Conformity FCC Warning Manufacturer: InFocus Corporation 13190 SW 68th Parkway, Portland, Oregon This device complies with part 15 of the FCC Rules. Operation is subject to the 97223-8368 USA following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may We declare under our sole responsibility that this projector conform to the cause undesired operation. following direc
Resumen del contenido incluido en la página 3
3’ / 1 m Important Operating Considerations for Safety Table of Contents Introduction 3 • Place the projector in a horizontal position no greater than 15 degrees Positioning the projector 5 off axis. Projector and device connector guide 6 • Locate the projector in a well-ventilated area without any obstructions Connecting a computer source 9 to intake or exhaust vents. Do not place the projector on a tablecloth or Required computer connections other soft covering that may block the vents. (
Resumen del contenido incluido en la página 4
Introduction Your new digital projector is simple to connect, easy to use, and touch keypad straightforward to maintain. The IN1100 has native XGA 1024x768 resolution, and the IN1102 has WXGA 1280x800 resolution. This guide applies to all products. They are compatible with a wide variety of computers and video devices. Product specifications To read the latest specifications on your multimedia projector, be sure to visit our website at www.infocus.com, as specifications are subject to chang
Resumen del contenido incluido en la página 5
Connector panel The projector provides the following connectors: composite •VESA computer computer video •S-video S-video audio in •Composite video DisplayLink connector • Audio in • USB DisplayLink connector, for computer video input. This USB connection also provides slide advance (and mouse control when used with an optional remote control only) security lock 4
Resumen del contenido incluido en la página 6
Positioning the projector Table 1: (IN1100) To determine where to position the projector, consider the size and shape of Range of distance to the screen for a given screen size your screen, the location of your power outlets, and the distance between the projector and the rest of your equipment. Here are some general guidelines: Distance to screen Maximum Minimum • Position the projector on a flat surface at a right angle to the screen. The Diagonal Screen distance Distance projector must
Resumen del contenido incluido en la página 7
Projector and device connector guide The following illustration and table should help you find the connectors to use and obtain the best resolution possible from your input devices, such as computers, standard VCRs, DVD players (progressive and interlaced), HDTV sources (1080i, 1080p and 720p HDTV formats), TV and satellite tuners, camcorders, video games (progressive and interlaced), and laser disc players. composite computer video S-video audio in DisplayLink connector security lock 6
Resumen del contenido incluido en la página 8
Attach to Adapter or If Your Device Video Device Video Compatibility Labeled Connector For Setup Instructions, see Comments Connector Is on Projector NTSC, PAL, and Composite video Video 2 Composite video connection on Not for progressive Standard Broadcast TV (not SECAM formats or S-video or Video 1 page 13. (i.e. HDTV) sources. HDTV) via: cable, digital cable, See page 8. satellite TV, DVD, or VCR S-video connection on page 13 NTSC, PAL, and Composite video Video 2 Composite video conne
Resumen del contenido incluido en la página 9
Attach to Adapter or If Your Device Video Device Video Compatibility Labeled Connector For Setup Instructions, see Comments Connector Is on Projector 1080i, 1080p, 720p VGA Computer 2 VESA connection on page 13 HDTV (High Definition TV) Component 480i Component video Computer 2 via Component video connection on optional VESA to page 13 Component adapter 1080i, 1080p, 720p VGA Computer 2 VESA connection on page 13 Progressive DVD Component 480p Component video Computer 2 via Component video
Resumen del contenido incluido en la página 10
Connecting a computer source connect USB cable Required computer connections (DisplayLink or VESA) If your computer has Windows XP SP2 or newer*, connect the USB cable between your computer's USB port and the projector's DisplayLink connector, then follow the instructions on the screen. See the DisplayLink Manager User's Guide for more information (www.infocus.com/support/ MOLEX MOLEX displaylink). * For the latest information about support for other operating systems (including Apple), go t
Resumen del contenido incluido en la página 11
Displaying an image press Power button Touch the Power button. The Power button blinks green and the fans start to run. When the lamp comes on, the start up screen displays and the Power button is steady green. It can take a minute for the image to achieve full brightness. ? No start up screen? Get help on page 15. turn on computer or Turn on your computer or video device. video device The image should appear on the projection screen. If it doesn’t, press the Source button on the projector’s
Resumen del contenido incluido en la página 12
Adjusting the image release button adjust height If necessary, adjust the height of the projector by pressing the elevator foot release button to extend the foot. If necessary, rotate the leveling foot located at the rear of the projector. Avoid placing your hands near the hot exhaust vent at the side of the elevator foot projector. Position the projector the desired distance from the screen at a 90 degree adjust distance angle to the screen. See page 5 for a table listing screen sizes and di
Resumen del contenido incluido en la página 13
Connecting a video device 4:3 screen 16:9 screen You can connect video devices such as VCRs, DVD players, camcorders, digital cameras, video game consoles, HDTV receivers, and TV tuners to the projector. You can connect the audio directly to the projector to get sound 4:3 Do Not Use from the built-in speaker, or you can bypass the projector’s audio system mode and connect the audio directly from your source to a stereo system. You can connect the projector to most video devices that can out
Resumen del contenido incluido en la página 14
Component video connection Video device connections If your HD video device has component connectors, an optional No video cables are provided with the projector. You can order cables from Component to VESA adapter can be used. Plug the component cable into InFocus or provide your own. the video device. Plug the other end of the component cable into the adapter and plug the adapter into the Computer 2 connector. Component offers the Composite video connection highest quality video output. P
Resumen del contenido incluido en la página 15
The Status Indicator Panel on top of the projector indicates the state of the Shutting down the projector projector and can help you troubleshoot. The projector automatically displays a black screen after no active source is detected for 30 minutes. This black screen helps preserve the life of the projector. The image returns when an active source is detected or a remote or keypad button is pressed. Table 3: Status indicator light behavior and meaning Screen Save Time You can make the black
Resumen del contenido incluido en la página 16
A A Problem Solution Result No start up screen Plug power cord into the projector press power Correct image button Only start up screen appears If your computer is using the projector's Computer image projected DisplayLink connector, see the DisplayLink User's Guide for troubleshooting information. Press the Source button activate laptop’s external port Restart laptop 15 Startup Screen Startup Screen A A
Resumen del contenido incluido en la página 17
A A A A Problem Solution Result No computer image, just the words “Signal out Press the Auto Image button on keypad adjust computer refresh Computer image projected of range” rate in Control Panel > Display > Settings > Advanced > Adapter (location varies by operating system) You may also need to set a different resolution on your computer, as shown in the following problem, “image fuzzy or cropped” Only my laptop’s background appears, not the If your computer is using the DisplayLink connect
Resumen del contenido incluido en la página 18
Problem Solution Result Image fuzzy or cropped Set your computer’s display resolution to the native resolution of Image clear and not cropped the projector (Start > Settings > Control Panel > Display > Settings tab) For a laptop, A A disable laptop A monitor or turn- on dual-display mode Image not centered on screen Move projector, adjust zoom, adjust height Correct image Adjust horizontal or vertical position in Advanced Picture menu 17 A
Resumen del contenido incluido en la página 19
Problem Solution Result Image not square Adjust Keystone on keypad Square image Image not sharp Adjust Sharpness in the Basic Picture menu Correct image AB AB Image does not fit 4:3 or 16:9 screen Change aspect ratio to 4:3 or 16:9 in Basic Picture > Aspect ratio Correct image menu 18
Resumen del contenido incluido en la página 20
A B A B Problem Solution Result Image reversed left to right Turn off Rear Project in Setup menu Correct image A AB Projected colors don’t match source Adjust color, tint, brightness, contrast in the Basic Picture menu Correct image COLOR COLOR The video embedded in my PowerPoint If your computer is using the projector's DisplayLink connector, Embedded video plays correctly presentation does not play on the screen see the DisplayLink User's Guide for video troubleshooting information. Turn off
