Resumen del contenido incluido en la página 1
MP7640 Multimedia Projector
Operator’s Guide
MP7640 Projecteur multimédia Guide de l'opérateur
MP7640 Multimedia-Projektor Benutzerhandbuch
Proyector de Multimedia MP7640 Manual del Usuario
MP7640 Proiettore Multimediale Manuale dell'operatore
MP7640 Bruksanvisning för multimediaprojektor
MP7640 Multimedia Projector Gebruiksaanwijzing
™
3M Multimedia Projector MP7640
© 3M IPC 2000
1
Resumen del contenido incluido en la página 2
™ 3M Multimedia Projector MP7640 © 3M IPC 2000 2
Resumen del contenido incluido en la página 3
Table of Contents Please click on any section to jump to that section. Introduction Safeguards .................................................................................... 4 Thank You for Choosing 3M .......................................................... 6 Warranty ........................................................................................ 6 Section 1: Unpack Contents of Shipping Box.............................................................. 7 Optional Accessories ...
Resumen del contenido incluido en la página 4
Introduction Intended Use ™ Before operating the machine, please read this entire manual thoroughly. The 3M Multimedia Projector MP7640 was designed, built, and tested for use indoors, using 3M lamps, 3M ceiling mount hardware, and nominal local voltages. The use of other replacement lamps, outdoor operation, operation in environments containing heavy cigarette smoke or different voltages has not been tested and could damage the projector or peripheral equipment and/or create a potentially unsaf
Resumen del contenido incluido en la página 5
Introduction Location of Product Safety Labels The following safety labels are used on or within the MP7640 projector to alert you to items or areas requiring your attention. CAUTION/VORSICHT/MESURE DE PRÉCAUTION/ATTENZIONE/PRECAUCIÓN Turning the knob too much makes it come off. / Der Verstellknopf löst sich wenn er überdreht wird. / Si vous manipulez excessivament la poignée, elle se detachera. / Se si gira troppo la manipola si stacca. / Grandola demasiado la manivela se desprende. HL HIGH T
Resumen del contenido incluido en la página 6
Introduction Thank You for Choosing 3M Thank you for choosing 3M multimedia projection equipment. This product has been produced in accordance with 3M’s highest quality and safety standards to ensure smooth and troublefree use in the years to come. For optimum performance, please follow the operating instructions carefully. We hope you will enjoy using this high performance product in your meetings, presentations, and training sessions. Warranty Limited Warranty 3M warrants this product against
Resumen del contenido incluido en la página 7
Section 1: Unpack Contents of Shipping Box ™ The 3M MP7640 Multimedia Projector is shipped with the necessary cables required for standard VCR, PC, ™ Macintosh or laptop computer connections. Carefully unpack and verify that you have all of the items shown below. If any of these items are missing, please contact your place of purchase. STANDBY/ON VIDEO RGB MP7640 Operator’s Guide MENU SELECT MENU RESET POSITION © 3M IPC July 2000 Rev. B Acrobat® Reader copyright © 1987-1996 Adobe Systems
Resumen del contenido incluido en la página 8
Section 2: Product Description Machine Characteristics The MP7640 Multimedia Projector integrates ultra-high bright lamp and polysilicon LCD display technology into a single unit. It accepts input from one computer source and two video/audio sources, and projects a bright, super-crisp image. Switching your presentation from a computer input to a video input, then back to a computer input simply requires the push of a button on the remote control keypad or control panel keypad. The MP7640 Multi
Resumen del contenido incluido en la página 9
Section 2: Product Description Part Identification List 2 STANDBY/ON VIDEO RGB 1 MENU SELECT MENU POSITION RESET MAGNIFY FREEZE VOLUME MUTE AUTO TIMER BLANK 3 4 12 5 8 7 15 14 11 10 9 6 13 Figure 2.1 Identifying MP7640 Parts 1. Basic remote control transmitter 8. Zoom knob 2. Control panel keypad (see below) 9. Focus ring a) STANDBY/ON button 10. Projection lens b) ON, LAMP, TEMP indicators 11. Sliding lens door c) INPUT, MUTE, RESET buttons 12. Height adjustment foot d) MENU disk button 13. Ter
Resumen del contenido incluido en la página 10
Section 2: Product Description System Setup—Connecting to Various Equipment AC Power VCR with S jack Laptop Computer Desktop Computer VCR Figure 2.2 Cable Connections Turn power off to all devices before making connections. Never plug anything into the projector or computer while any device is in operation. Caution The MP7640 must be powered down when making connections. The mouse emulation may not work if the unit is not powered down before the mouse cable connections are made. ™ 3M Multimedia
Resumen del contenido incluido en la página 11
Section 2: Product Description Remote Control Transmitter Identification STANDBY/ON VIDEO RGB STANDBY/ON Turn on Main Power switch. Press STANDBY/ON button to begin projection mode (lamp on) VIDEO and RGB or press and hold button for one Press the VIDEO or RGB button to select the second to switch to standby input source. Press again to select the next mode (lamp off). source. MENU SELECT Press to select menu items. MENU SELECT POSITION* MENU Buttons Press button, then use Menu directional Press
Resumen del contenido incluido en la página 12
Section 2: Product Description Changing Remote Control Battery This battery contains lithium. Consult your local hazardous waste regulations and Caution dispose of this battery in the proper manner. This remote control transmitter uses a lithium battery located in a sliding holder inserted into the bottom of the transmitter. 1. Turn the remote control transmitter over to access the battery holder. 2. Push the smaller tab inward as indicated below. 3. Slide the battery holder out of the bottom of
Resumen del contenido incluido en la página 13
Section 3: Basic Operations Projector Start-up STANDBY/ON INPUT MUT Figure 3.1 Projector Controls 1. Make all equipment and cable connections with the power off. 2. Turn on the MAIN POWER SWITCH of the projector. The ON indicator will light up orange. 3. Press the STANDBY/ON button . The ON indicator will blink green during warm-up and lamp ignition, then stay green to indicate correct operation. When power is turned off, there is a 60-second reset period before the STANDBY/ON button
Resumen del contenido incluido en la página 14
Section 4: Adjustments and Functions How to Use Height Adjustment Foot Adjust the image elevation and projection angle (within 0 to 10°) using the height adjustment foot at the front of the projector. 1. Raise the front end of the projector so the foot is not touching the tabletop. 2. Push the lock button on the left side of the projector to unlock the foot. 3. Extend or retract the foot to the desired height. 4. Release the lock button to lock the foot into position. 5. For finer adjustment, ro
Resumen del contenido incluido en la página 15
Section 4: Adjustments and Functions Plug & Play Function Plug & Play is a system configured with peripheral equipment (including a computer and display), and a compatible operating system. This allows the user to connect various peripheral equipment successfully without having to adjust settings manually. The equipment and projector exchange this information automati- cally. This projector is VESA DDC (Display Data Channel) 1/2B compatible. Plug & Play is possible by connecting to a computer th
Resumen del contenido incluido en la página 16
Section 4: Adjustments and Functions Menu Navigation MENU SELECT Figure 4.3 Menu disk button on projector and Menu buttons from basic remote control transmitter 1. Press MENU disk button on projector or remote control MENU buttons. On-screen menus are displayed on the projected image. 2. Select the menu to be adjusted using the MENU disk button or remote control Menu buttons . Selected Menu is then highlighted. 3. Select the menu item to be adjusted using the MENU disk button or any of
Resumen del contenido incluido en la página 17
Section 4: Adjustments and Functions SETUP Submenu The SETUP sub-menu is used to adjust and move the image position. The projector will display either the RGB (Figure 4.5) or Video (Figure 4.6) submenu, according to the input source being projected. SETUP INPUT IMAGE OPT. SETUP INPUT IMAGE OPT. BRIGHT BRIGHT CONTRAST CONTRAST SHARPNESS V POSIT 121 COLOR H POSIT 57 TINT H PHASE 7 H SIZE H SIZE COLOR BAL R COLOR BAL R 800 COLOR BAL B COLOR BAL B ASPECT Figure 4.5 RGB signal input Figure 4.6 Video
Resumen del contenido incluido en la página 18
Section 4: Adjustments and Functions INPUT Submenu The INPUT submenu is used to select the RGB or video input source. The RGB values are shown in Figure 4.7. The Video values are shown in Figure 4.8. SETUP INPUT IMAGE OPT. SETUP INPUT IMAGE OPT. RGB FH: 48.3 KHz RGB FV: 60 Hz VIDEO VIDEO AUTO NTSC AUTO AUTO PAL SECAM NTSC4.43 M-PAL N-PAL Figure 4.7 RGB Input Submenu Figure 4.8 Video Input Submenu SETUP INPUT IMAGE OPT. RGB VIDEO AUTO EXECUTE CANCEL Figure 4.9 Auto Input Submenu Adjustment Value
Resumen del contenido incluido en la página 19
Section 4: Adjustments and Functions IMAGE Submenu The IMAGE submenu is used to change the image characteristics. SETUP INPUT INPUT IMAGE OPT. SETUP INPUT INPUT IMAGE OPT. KEYSTONE KEYSTONE –0 BLANK BLANK MIRROR MIRROR START UP START UP SETUP INPUT INPUT IMAGE OPT. SETUP INPUT INPUT IMAGE OPT. KEYSTONE KEYSTONE BLANK BLANK MIRROR MIRROR NORMAL H: INVERT TURN ON START UP START UP V: INVERT TURN OFF H&V: INVERT Figure 4.10 Image Adjustment Screens Adjustment
Resumen del contenido incluido en la página 20
Section 4: Adjustments and Functions OPT. Submenu The OPT. submenu allows you to control communication function. SETUP INPUT INPUT IMAGE OPT. SETUP INPUT INPUT IMAGE OPT. VOLUME 8 VOLUME MENU COLOR MENU COLOR TIMER TIMER LANGUAGE LANGUAGE AUTO OFF AUTO OFF SYNC ON G SYNC ON G SETUP INPUT INPUT IMAGE OPT. SETUP INPUT INPUT IMAGE OPT. VOLUME VOLUME MENU COLOR MENU COLOR TIMER TIMER ENGLISH 15 min. LANGUAGE LANGUAGE FRAN AIS DEUTSCH AUTO OFF AUTO OFF ESPA OL SYNC ON G SYNC ON G ITALIANO NORSK NEDER
