Manual de instrucciones de Vector BD051605

Resumen del contenido incluido en la página 1

VEC1028POB
POWER ON BOARD 2 YEAR LIMITED WARRANTY PROGRAM
This limited warranty program is the only one that applies to this product, and it sets forth all the
responsibilities of Power on Board, regarding this product. There is no other warranty, other than those
described herein.
This Power on Board product is warranted, to the original purchaser only, to be free of defects in materials
and workmanship for two years from the date of purchase without additional charge. The warranty does
not ex

Resumen del contenido incluido en la página 2

Compressor/Inflator Safety IMPORTANT SAFETY INSTRUCTIONS 1. Never attempt to disable or block the inflation and deflation ports while pump is operating. WARNINGS 2. Never cover unit at any time. 1. RISK OF EXPLOSIVE GAS MIXTURES — WORKING IN THE VICINITY OF A LEAD-ACID 3. Never leave the pump unattended while in use. BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING 4. Never allow sand, small rocks or other debris to be sucked into the inflation or deflation ports. NORMAL BATTERY

Resumen del contenido incluido en la página 3

TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 AC and DC Charging/Recharging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Viewing Battery Charge Status . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 120 Volt AC Charging . . . . . . . . . . .

Resumen del contenido incluido en la página 4

Front Panel Protective Features BATTERY CHARGE BATTERY CHARGE LEVEL • Automatic Overload — Built-in protection against overload — in the event the LEVEL INDICATORS PUSHBUTTON AC outlet draws more than 400 watts, power to the unit’s outlet will automatically shut off. JUMP-START SAFETY ON/OFF SWITCH • Ground Fault Circuit Interrupter (GFCI) — The GFCI protects the unit and the user by sensing imbalances in a circuit caused by current leakage to the ground and shuts down the unit’s AC outlet to

Resumen del contenido incluido en la página 5

120 Volt AC Charging Jump-Starting Instructions 1. Lift the AC Charger cover located on the back of This jump-starter is equipped with a manual safety switch that only allows jump-start the Power Center and connect a standard energy to flow when proper connections are made to battery and frame. household extension cord to the unit. Plug the Connect — RED clamp first, then BLACK clamp. Disconnect — BLACK clamp first, other end of the cord into a standard North then RED clamp. American 120 volt A

Resumen del contenido incluido en la página 6

USING THE 12 VOLT DC PORTABLE POWER SUPPLY USING THE EMERGENCY AREA LIGHT 1. Flip open the 12 Volt DC Outlet cover on the upper The Area Light is controlled by an ON/OFF pushbutton. Make sure the light is turned right side of the unit. OFF when the unit is being recharged or stored. 2. Insert the 12 volt DC plug from the appliance into the outlet. USING THE AIR COMPRESSOR/INFLATOR 3. Turn on the appliance and operate normally. The built-in 12 volt DC Air Compressor is the ultimate CAUTION infla

Resumen del contenido incluido en la página 7

4. Monitor the pressure gauge. When desired pressure is reached, slide the Air Deflating Compressor/Inflator Switch to OFF; open thumb latch and remove connector 1. Open the valve on your product completely to release air. from valve stem. 2. Fasten the Inflator/Deflator Hose (stored in the compartment on the back of the 5. Store the compressor hose and tire fitting in storage compartment. unit — see page 2) to the Deflator Port inside the Air Panel. 3. Attach the appropriate nozzle to the free

Resumen del contenido incluido en la página 8

SPECIFICATIONS 12 Volt DC Specifications Battery: 12 volt DC rechargeable, maintenance-free Internal Battery Type: Sealed, AGM lead-acid Internal Battery Capacity: 12 volt, 19Ah/20 hour rate Area Light : Light Emitting Diode (LED) Jumper Cables: Heavy duty welding cable with 450 amp clamps Accessory Outlet Protection: Self-resetting overload protection DC Charging Adapter: 12 volt DC AC Power Specifications Output Power: Continuous — 400 watts Output Voltage: 120 VAC RMS Output Frequency: 60