Manual de instrucciones de Frigidaire 2020211a1446

Resumen del contenido incluido en la página 1

Installation Instructions
READ BEFORE INSTALLING UNIT
MSII Window Mounting (5,000~8,000 BTU)
INSTALLATION WARNINGS AND CAUTION
The unit is for window mounting only.
Carefully read the installation manual before beginning.
Follow each step as shown.
Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.
Pay attention to danger and safety notices.
To avoid risk of personal injury, property damage, or product damage due to the weight of this d

Resumen del contenido incluido en la página 2

How to Install Installation LEFT + RIGHT FILLER PANEL ASSEMBLY NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/16”). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained! Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper panel for each side.

Resumen del contenido incluido en la página 3

How to Install Installation Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. FIG. 6B FIG. 6A INSIDE INSIDE OUTSIDE OUTSIDE Wooden Windows Vinyl-Clad Windows Extend the side panels out against the window frame (FIG. 7A for wooden windows), (FIG. 7B for Vinyl-Clad windows). FIG. 7A FIG. 7B window frame Plac

Resumen del contenido incluido en la página 4

Installation NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by window itself. Cut foam window seal and insert it into the space between the upper and lower sashes (FIG. 11). FIG. 10 FIG. 11 FOAM SEAL After the completion of the installation, please check the machine’s lean as shown (FIG. 12A & FIG. 12B). It’s necessary for proper condensed water utilization and drainage. FIG. 12A FIG. 12B H H INSIDE OUTSIDE INSIDE OUTSI