Resumen del contenido incluido en la página 1
SERIES II 16 AMP POWER CONDITIONERS
Resumen del contenido incluido en la página 2
SERIES II 16 AMP POWER CONDITIONERS Furman Series II Features • SMP+ : advanced surge protection, extreme voltage shutdown, ultra-low clamping voltage • LiFT (Linear Filtering Technology) with zero ground contamination • E Models have 10 IEC rear panel outlets and one front panel outlet • PE models have 5 IEC rear panel outlets with a front panel circuit breaker, and 3 PowerCon rear panel outlets • BNC connector on the rear panel allows you to attach any standard (12VAC 0.5 amp) gooseneck lam
Resumen del contenido incluido en la página 3
SERIES II 16 AMP POWER CONDITIONERS to 380 VAC, by shutting off the incoming power I N T R O D U C T I O N until the over-voltage condition is corrected. Thank you for purchasing a Furman Series II Power Conditioner, and congratulations on LiFT (Linear Filtering Technology) choosing the best protection for your electronics. Series II Power Conditioners feature Furman’s Unfortunately, traditional AC filter / conditioners revolutionary SMP+ circuitry, as well as our have been designed for un
Resumen del contenido incluido en la página 4
SERIES II 16 AMP POWER CONDITIONERS 5. Route the power cord and other cables WA R N I N G where they are not likely to be walked on, To reduce the risk of electrical shock, do not tripped over, or stressed. Pay particular expose this equipment to rain or moisture. attention to the condition of the plugs, and Dangerous high voltages are present inside the to cords and cables at the point where they enclosure. Do not remove the covers. Refer exit your Series II unit. Replace damaged se
Resumen del contenido incluido en la página 5
SERIES II 16 AMP POWER CONDITIONERS ADDITIONAL F E A T U R E S PL-PRO PE II PL-PRO SERIES II E & PE All PL-PRO Series II models include an 8 foot, These models offer a 20-segment LED bar 1.5mm x 3 gauge heavy-duty power cable. A graph meter that displays incoming voltage rear mounted BNC jack accepts any standard between 180 and 256 volts in 4-volt steps. The (12 VAC 0.5 amp) gooseneck lamp for rear normal range voltages are indicated in green, rack illumination. with moderately and ex
Resumen del contenido incluido en la página 6
Voltmeter PL-PRO E II Switched Outlet Rear Light Switch Light Tube Dimmer Power Switch/Circuit Breaker LED Light Tubes PL-PRO PE II Circuit Breaker for IECs Rear Light Switch Light Tube Dimmer Voltmeter PL-PRO DE II Digital Voltmeter Switched Outlet 2 3 0 Light Tube Dimmer Rear Light Switch LED Light Tubes Power Switch/Circuit Breaker PL-PRO PDE II Circuit Breaker for IECs 2 3 0 Rear Light Switch Light Tube Dimmer Digital Voltmeter PM-PRO E II Switched Outlet 2 3 0 0 0 . 5 Rear Light Switch Digi
Resumen del contenido incluido en la página 7
SERIES II 16 AMP POWER CONDITIONERS lamp can be powered on or off with the rear O P E R AT I O N light power switch located on the far left of the front panel. Retractable Rack Lights, Rear Panel Lamp Series II front panel LED lamps must be and Dimmer Control: replaced by qualified Furman service The PL-PRO E II, PL-PRO PE II, PL-PRO personnel. DE II and PL-PRO PDE II include a dimmer control for the two retractable front panel light Multi-Segment LED voltmeter: tubes. Turn it cloc
Resumen del contenido incluido en la página 8
SERIES II 16 AMP POWER CONDITIONERS 2. If all of the LED’s on the voltmeter NOTE: Your Series II Power Conditioner does flash, the input voltage is marginally not compensate for high or low line voltage. high. The PL-PRO’s outlets will remain If you frequently move your rack to different powered unless the incoming voltage rises locations, derive power from generators, use above the Extreme Voltage Shutdown cutoff long extension cords, travel internationally, or voltage of 270 – 280 vol
Resumen del contenido incluido en la página 9
SERIES II 16 AMP POWER CONDITIONERS Protection OK Indicator: Action Needed: Remove one piece of equipment from the Series II unit, open the Although the Furman SMP+ circuit assures hinged switch / breaker cover, and reset the virtually impregnable protection against switch to the on position. transient voltage spikes and surges, Nature occasionally creates electrical forces that 2.) Symptom: No power to the AC outlets, are beyond the capacity of any TVSS device “Protection OK” indicator
Resumen del contenido incluido en la página 10
SERIES II 16 AMP POWER CONDITIONERS DEFINITIONS THREE YEAR LIMITED WARRANTY SPIKE: A pulse of energy on the power line. Spikes can have voltages as high as 6000 Furman Sound, Inc., having its principal place volts. Though they are usually of very short of business at 1997 South McDowell Blvd., duration, their energy can be considerable, Petaluma, CA 94954 (“Manufacturer”) warrants enough to damage sensitive solid-state its 16 amp Series II Power Conditioners (the components in audio a
Resumen del contenido incluido en la página 11
SERIES II 16 AMP POWER CONDITIONERS Manufacturer shall, at its own expense, furnish obligation with respect to the Products or a replacement Product or, at Manufacturer’s any part thereof, whether based on contract, option, repair the defective Product. Return tort, strict liability or otherwise. Under no shipping charges back to Purchaser will be circumstances, whether based on this Limited paid by Manufacturer. Warranty or otherwise, shall Manufacturer be liable for incidental, special,
Resumen del contenido incluido en la página 12
Make sure to pick up one of Furman’s goose- SPECIFICATIONS neck lights – the perfect accessory for your Current rating: Series II Power Conditioner. 16 amps Operating Voltage: 180 to 280 VAC (UK version, 260 VAC) Over Voltage Shutdown: 280 VAC typically (UK version, 260 VAC) Voltmeter Accuracy: GN-LED PL-PRO E II / PE II: ±4 VAC, calibrated with internal trimpot adjustments PL-PRO DE II / PDE II & PM-PRO E II / PE II: ±1.5 VAC Current Meter Accuracy: GN- I PM-PRO E II / PE II: ±0.5 amp Spi
