Manual de instrucciones de PYLE Audio PYLE PRO PPHP1259

Resumen del contenido incluido en la página 1










































Resumen del contenido incluido en la página 2

Introduction Thank you for purchasing this Pyle Pro speaker The loudspeaker is designed to provide you years of high performance in any application that you require. Please read this manual carefully to fully maximize the performance of the speaker. Maintenance and Safety · Do not expose the speaker to moisture. · Avoid hot and cold temperature extremes. · Clean using a damp cloth. Make sure that no moisture contacts the drivers. · Do not attempt to service the unit. Refer serv

Resumen del contenido incluido en la página 3

There is an integrated 35mm speaker stand adapter on the bottom side of the cabinet. Use the knob to secure the speaker to the stand. Connections Your PPHP1259 speaker has a speakon jack as well as a ¼” jack. The jacks are wired in parallel, which allows you to daisy chain additional speakers. Thus you can use one amplifier channel to power multiple speakers. Make certain that the wires you are using are at least 12 gauge unshielded speaker cable (the lower the number, the thicker

Resumen del contenido incluido en la página 4

Operation When powering on your equipment, make sure the volume level on the amplifier is turned all the way down. This is to avoid the “popping” noise, which could damage your speaker. The placement of speakers can be a bit tricky. Besides for the practical considerations, there are acoustic issues as well. Avoid placing the speaker in a corner, as this will cause the low frequencies to sound “muddy”. Similarly, but to a lesser degree, placing the speaker directly against the wall wil

Resumen del contenido incluido en la página 5

Troubleshooting No Sound:
 Check connections
 Try a different speaker cable
 Check levels on amplifier
 Confirm amplifier is getting a signal (check signal LED, or use headphone output) Intermittent Output:
 Check connections
 Try a different speaker cable Weak Bass:
 Check the polarity of the speaker connection. It may be reversed.
 Listen with headphones to confirm the amplifier is being sent a good signal. Distorted Sound:
 Check if the amplifi

Resumen del contenido incluido en la página 6

Typical Setup Parallel Setup


  6

Resumen del contenido incluido en la página 7

Recommended Accessories










 


  



 

   
)& , -.)
  & 
  ! " 
/0 -&

" #$

   . 
   1"23








 
%&'(
)& "


 

** 




 

)& , -.)
  &