Manual de instrucciones de a/d/s/ HT60ic

Resumen del contenido incluido en la página 1

HT60ic
HT80ic
owner's manual
analog and digital systems

Resumen del contenido incluido en la página 2

table of contents introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 about this manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 ins

Resumen del contenido incluido en la página 3

tweeter protection A solid state device reduces power to the tweeter when the loudspeaker is operated at unsafe power levels. It resets automatically when power is reduced to a safe level. Note: the tweeter protector provides a significant level of protection. However it does not guarantee that the tweeter cannot be damaged. Always be careful when operating the speakers at a high volume level. tweeter attenuation switch A 3-position switch located on the tweeter plate serves as a high frequency

Resumen del contenido incluido en la página 4

general mounting suggestions Avoid placing the speaker within two feet (0.6 meters) of a corner. The acoustic reflections from surfaces near the speakers can detract from the sound quality. Do not place the speaker behind heavy fabrics; if you cannot see through a fabric, you cannot hear through it. The ceiling speakers are designed for "infinite baffle" operation. The area behind the speaker installation should be at least one-half cubic foot in volume to ensure proper performance. If the area

Resumen del contenido incluido en la página 5

installation preparation Use the supplied template to outline the mounting hole. Cut the mounting hole and remove any debris from the area. Take the necessary steps to keep debris from falling into the back of the speaker. Route the wires from the amplifier to the speaker installation location. Strip about 1/2" of the insulation from the wire conductors. Twist the wire strands of the conductors into neat bundles. Insert the wires into the provided gold spring connectors to secure the wires. fina

Resumen del contenido incluido en la página 6

specifications HT60ic HT80ic frequency response (Hz) 65-20 kHz 58-20 kHz impedance 4 ohm 4 ohm sensitivity 1W/1M (dB) 88 dB 88 dB max bezel diameter 9-1/4" (23.5 cm) 10-7/8" (27.6 cm) mounting hole 7-11/16" (19.5 cm) 9-7/16" (24.0 cm) rear clearance 3-1/2" (8.9 cm) 4-1/8" (10.5 cm) recommended power 20-80 watts 20-80 watts woofer 6-1/2" (16.5 cm) 8" (20.3 cm) tweeter 1" (25 mm) dome 1" (25 mm) dome (Specifications subject to change without notice) 6

Resumen del contenido incluido en la página 7

warranty information LIMITED FIVE YEAR CONSUMER WARRANTY FOR PRODUCT INSTALLED BY AN AUTHORIZED LICENSED DEALER Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of five years from the date of purchase from the dealer as indicated by the date code marking of the product PROVIDED the product was sold by an authorized Directed dealer. During this five year period, there wi

Resumen del contenido incluido en la página 8

Directed Electronics, Inc. All rights reserved G39630/35 10-04