Manual de instrucciones de Creda NP200 75-772904

Resumen del contenido incluido en la página 1

Creda Newera Profile and Profile Plus Panel Heaters
Installation and Operating Instructions














Model with Model with controls Model with no Dimensions
Wattage (W)
controls white silver controls white (mm)
500 NPP50 75-773001 NPP50S 75-773011 NP50 75-772901 442 x 430 x 80
1000 NPP100 75-773002 NPP100S 75-773012 NP100 75-772902 680 x 430 x 80
1500 NPP150 75-773003 NPP150S 75-773013 NP150 75-772903 680 x 430 x 80
2000 NPP200 75-773004 NPP200S 75-773014 NP200 75-77

Resumen del contenido incluido en la página 2

Bathroom Installation IMPORTANT – If the heater is installed in a room containing a bath or shower, it must be so installed that switches and other controls cannot be touched by a person using a bath or shower. Wall Mounting IMPORTANT – DO NOT locate the heater immediately below a fixed socket outlet or connection box. The wall bracket supplied with the appliance should be fitted using the screws and wall plugs provided. The heater should be positioned observing the minimum clearances ar

Resumen del contenido incluido en la página 3

View of Controls Diagram D No Controls Models – 75-772901, 75-772902, 75-772903, 75-772904 and 75-772905 These models can be installed in association with a separate room thermostat control. Bracket release for cleaning For safety, the heater should be switched off at the mains before proceeding. To release the panel heater from the bracket, the rear catch must be pressed down while pulling the heater forward gently. It is recommended to use a narrow tool for this purpose. A pencil

Resumen del contenido incluido en la página 4

The Panel - How it works A heating element within the metal case warms its front face for direct radiation into the room and a gentle circulation of warm air around the room. The built-in thermostat with its adjustment knob located behind the controls door, controls the room temperature by sensing this from the air passing upwards through the panel. The knob selection provides settings from 1 to 6 and each increase in number equates to approximately 7°C temperature difference. Position 1