Manual de instrucciones de American Standard PORTSMOUTHTM 7420.92

Resumen del contenido incluido en la página 1

Installation
Instructions
™
PORTSMOUTH 7420.900
7420.901
DECK MOUNT
Series
BATH FILLER
7420.920
7420.921
Series
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
Certified to comply with ANSI A112.18.1M
M965027 REV.1.6
Recommended Tools 2-7/8"
ROUGHING-IN DIMENSIONS
(73mm)
CROSS HANDLE
7-7/8" 6-1/2" to 12"
(165mm to 305mm)
(199mm)
2-1/4" D.
(5

Resumen del contenido incluido en la página 2

VALVE ASSEMBLY 3 9 Install LOCKNUTS (1) and RUBBER WASHERS (2) onto valve shanks. 10 11 MOUNTING Push TUBING (3) ends into VALVE (4) side outlets. Insert VALVES (4) SURFACE into mounting holes from underside of ledge. Press TEE (5) onto SPOUT SHANK (6) making certain that the O-RING (7) is properly seated on SHANK (6). Push COUPLING (8) into TEE (5) and attach to SPOUT SHANK (6) and tighten using a 10mm (3/8'') hex wrench. Tighten COUPLING (8) using a 10mm (3/8") Hex wrench. (FOR 7020.900/920) U

Resumen del contenido incluido en la página 3

HANDSHOWER INSTALLATION (For 2064.901 only) 6 11 Drop SPRAY ESCUTCHEON (1) through the fourth hole of the tub ledge (12" max from SPOUT center) with SPRAY ESCUTCHEON (1) directed towards tub center. Be sure RUBBER RING (2) is properly seated in SPRAY ESCUTCHEON (1). Install RUBBER WASHER (3), BRASS WASHER (4) and LOCKNUT (5) from underside of ledge. 9 Secure SPRAY ESCUTCHEON (1) by tightening LOCKNUT (5). Install SEAL (9) and connect HOSE (10) to outlet nipple at the bottom of TEE (7). Tighten