Manual de instrucciones de American Standard LAKELAND 4114.1

Resumen del contenido incluido en la página 1

0





1





2




3




4





5





6




Installation
Instructions
LAKELAND
4114.100
SINGLE CONTROL KITCHEN
PULL-OUT FAUCET
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
Certified to comply with ANSI A112.18.1M
please read these instructions carefully before you begin.
M968470 REV. 1.4
TOOLS REQUIRED
Phillips Screwdriver
Regular Screwdriver
Adjustable Wre

Resumen del contenido incluido en la página 2

Installation Instructions LAKELAND 4114.100 SINGLE CONTROL KITCHEN PULL-OUT FAUCET Thank you for selecting American-Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-- Certified to comply with ANSI A112.18.1M please read these instructions carefully before you begin. M968470 REV. 1.4 TOOLS REQUIRED Phillips Screwdriver Regular Screwdriver Adjustable Wrench Plumbers' Putty or Caulking INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON 1 Tur

Resumen del contenido incluido en la página 3

MAKE WATER SUPPLY CONNECTIONS 2 Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply to Hot (Marked with a Red Line) and right supply to Cold wall supply. Use 2 adjustable wrench to tighten connections. Do not over tighten. 1 Faucet supplies are 21" long from faucet base. COLD Note: If additional supply length is required, installer must purchase HOT additional p

Resumen del contenido incluido en la página 4

0 1 2 3 4 5 6 CHECK CONNECTIONS FOR LEAKS. 5 Move HANDLE down into "off" position. Turn on water supplies and check connections for leaks. Operate HANDLE (2) up and down, left and right to flush water lines thoroughly. Operate HAND SPRAY and check connections for leaks. CHECK CONNECTIONS FOR LEAKS SERVICE 6 If faucet drips, operate HANDLE several times from "off" to "on." Do not apply excessive force. Clogged CARTRIDGE outlets