Resumen del contenido incluido en la página 1
UNVENTED GAS
CAST IRON STOVE
INSTALLATION AND OPERATING
INSTRUCTIONS
SINGLE DOOR MODELS:
CSVF20SNV CSVF30SNV
CSVF20SPV CSVF30SPV
DOUBLE DOOR MODELS:
VFCS20DNV VFCS30DNV
VFCS20DPV VFCS30DPV
Natural Gas or
Propane/LPG
Milli-Volt Control
WARNINGS
WARNINGS
If the information in this manual is not followed
exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
– Do not store or use gasoline or other flammable
This appliance may be installe
Resumen del contenido incluido en la página 2
CONTENTS Important Safety Information .......................... 3 Rock Wool Installation.................................... 18 Flame Appearance .......................................... 19 Product Features .............................................. 5 Checking Pilot Flame .................................. 19 Dimensions ....................................................... 6 Checking the Burner Flame ........................ 0 Getting Started .......................................
Resumen del contenido incluido en la página 3
IMPORTANT SAFETY INFORMATION INSTALLER OWNER Please leave these instructions with the appliance. Please retain these instructions for future reference. IMPORTANT Read these instructions carefully before installing or trying to operate this vent-free gas heater. • Any change to this heater or its controls can be dangerous. • Improper installation or use of the heater can cause serious injury or death from fire, burns, explosion or carbon monoxide poisoning. • Do not allow fans to blow directly i
Resumen del contenido incluido en la página 4
IMPORTANT SAFETY INFORMATION Continued from page 3 20. Input ratings are shown in BTU per hour and are for elevations up to 2,000 feet. For elevations above 2,000 16. Keep room area clear and free from combustible materi- feet, input ratings should be reduced 4 percent for each als, gasoline and other flammable vapors and liquids. 1,000 feet above sea level. Refer to the National Fuel 17. Unvented gas heaters are a supplemental
Resumen del contenido incluido en la página 5
PRODUCT FEATURES On/Off Switch Handle Optional Remote Receiver Piezo Hi/Lo Knob Off/Pilot/On Knob Fan Switch Door Figure 1 - Cast Iron Stove (Single Door) Break-Away Handle On/Off Switch Optional Remote Receiver Piezo Hi/Lo Knob Off/Pilot/On Knob Store Break-Away Optional Handle Here Figure 2 - Cast Iron Stove Fan Switch (Double Door) 58D6002 ON OFF ON OFF
Resumen del contenido incluido en la página 6
DIMENSIONS A C B Figure 3 - Dimensions CSVF20S/VFCS20D CSVF30S/VFCS30D 1 3 A 1 /4" 6 /4" 1 B 3" 8 / " 1 3 C 16 / " 19 /4" 6 58D6002
Resumen del contenido incluido en la página 7
MAk E SURE YOU HAVE RECEIVED ALL PARTS: Check your packing list to verify that all listed parts have be en receiv ed. Y ou should have the following: • Cast Iron Stove with Burner Assembly • Installation/Operating Instructions • Ceramic Fiber Logs • Touch-up Paint Millivolt controlled heater designed to be operated with optional devices for ON/OFF functions. • Hand-Held Remote with Manual Receiver • Wall Switch with 15' Wire Gloves are reco
Resumen del contenido incluido en la página 8
PRODUCT SPECIFICATIONS NATURAL GAS 1 NOTE: An external regulator is required to reduce supply pressure to a maximum of 10 /2" w.c. on Natural Gas systems operating at higher pressure. MILLIVOLT PRESSURE Regulator Pressure Setting: 3.5" w .c. Pilot Regulator: 3.5" w .c. Gas Inlet Pressure: Max. 10 1/2" w . c. Min. 5" w .c. Gas Rate Model Number Type Max. BTU/Hr Min. BTU/Hr CSVF 0SNV/VFCS 0DNV (G-EBL-ES-EMB) Milli-Volt 10,000 6,000 CSVF30SNV/VFCS30DNV (G-E
Resumen del contenido incluido en la página 9
GENERAL INSTALLATION INFORMATION Do not install the heater … • Where curtains, furniture, clothing, or other flammable objects are less than 42" from the front of the heater. • In high traffic areas. • In windy or drafty areas. CODES Adhere to all local codes or , in their absence, the latest edition of THE NA TIONAL FUEL GAS CODE ANSI Z223.1 or NFP A54 which can be obtained from… American National Standards Institute, Inc. 1430 Broadway New Y ork, NY 10018 or Nati
Resumen del contenido incluido en la página 10
L L 2 1 GENERAL INSTALLATION INFORMATION Counter Cast Iron Stove Figure 4 - Example of a Large Room with 1/2 Wall Divider The following formula can be used to determine the maximum heater rating per the definition of unconfined space: BTU/Hr = (L1 + L ) Ft x (W) Ft x (H) Ft x 1000 0 Consider two connecting rooms with an open area between, with the following dimensions: 1 L1 = 1 / Ft., L = 1 Ft., W = 1 Ft., H = 8 Ft. 1 BTU/Hr = (1 / + 1 ) x (1 ) x (8) x 1000 = 800
Resumen del contenido incluido en la página 11
CLEARANCES / HEIGHT REQUIREMENTS The dimensions shown in Figure 5 are minimum clearances to maintain in installing this heater. Left and right clearances are determined when facing the front of the heater. Follow these instructions carefully to ensure safe installation. Failure to follow instructions exactly can create a fire hazard. The appliance cannot be installed on a carpet, tile or other combustible material other than wood flooring, the appliance shall be installed on a metal, wood or
Resumen del contenido incluido en la página 12
CLEARANCES / HEIGHT REQUIRMENTS C B A Figure 6 - Placing Stove in Alcove Tested Minimum Alcove Dimensions Height From Hearth Width Depth A B C VF20 38½" 3" 36" VF30 " 34" 36" Note: Maintain minimum side and back clearances when placing stove in alcove. 1 58D6002 ON OFF
Resumen del contenido incluido en la página 13
LOGS LOGS PILOT REMOTE CONTROL OFF LOGS PILOT REMOTE CONTROL OFF REMOVING UNIT FROM CRATE 1. Remove two (2) straps. See Figure 7. Plastic Straps Bag 2. Open plastic bag and slide to bottom of unit. See Figure 8. 3. Lift up on ash lip and pivot down to open control door. See Figure 9. 4. L i f t u p o n f r o n t . P i v o t b o t t o m o f f r o n t o u t . R e m o v e front. See Figure 9. 5. Lift screen to remove. 6. Remove l
Resumen del contenido incluido en la página 14
CONNECTING THE GAS NOTICE: A qualified gas appliance installer must connect the heater to the gas supply. Consult all local codes. Use new black iron or steel pipe. Internally tinned copper or copper tubing can be used per National Fuel Code, section 2.6.3, providing gas meets hydrogen sulfide limits, and where permitted by local codes. Gas piping system must be sized to provide minimum inlet pressure (Listed on Data Plate) at the maximum flow rate (BTU/Hr). Undue pressure loss will occur i
Resumen del contenido incluido en la página 15
CHECk ING GAS PRESSURE and CONNECTING REMOTE RECEIVER The heater gas inlet connection is 3/8" NPT at the valve. The inlet is located on left side of stove. Remove front control Connecting directly to an unregulated plate to better access the inlet. propane/L.P.G. tank can cause an W h e n t i g h t e n i n g u p t h e j o i n t t o t h e v a l v e , h o l d t h e v a l v e s e c u r e l y explosion. with a wrench to prevent movem
Resumen del contenido incluido en la página 16
ELECTRICAL WIRING (MILLI-VOLT) The milli-volt valve is a self-powered combination gas con trol THAT DOES NOT REQUIRE 110 VAC TO OPERATE. ODS Pilot Label all wires prior to On/Off disconnection when Switch servicing controls. ODS Wiring errors can cause Pilot improper and dangerous Wall operation. Verify proper Switch Millivolt operation after servicing. Valve On/Off 3 Switch Spade Terminal 1 2 Optional Wall Switch or CONNECTION Remote 1 = TP 2 = TP, TH 3 = TH Switch Figure 13
Resumen del contenido incluido en la página 17
PILOT REMOTE CONTROL OFF LOG PLACEMENT Before you begin — This unit is supplied with four ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers. The positioning of the logs are critical to the safe and clean operation of this heater. Sooting and other problems may result
Resumen del contenido incluido en la página 18
PILOT REMOTE CONTROL OFF LOG PLACEMENT VF20 INSTALLING LOGS ON GRATE (See Figure 15) 1. Install back log (#1) on back of burner assembly . 2. Install front log (#2) on 2 pegs on burner assembly . Figure 15 - Installing Logs to Grate (VF20) ROCk WOOL INSTALLATION (VF30 UNITS ONLY) 1. Break rock wool into dime-sized pieces. ➞ 2. Place rock evenly across rock wool tray and front burner as shown in Figure 16. • Rock wool depth must not be more than 1". • D
Resumen del contenido incluido en la página 19
FLAME APPEARANCE Flames from the pilot, front and rear burner should be visually checked as soon as the heater is installed. In addition, periodically check the flames visually during operation. CHECk ING PILOT FLAME The pilot flame must always be present when the heater is in operation. It should just touch the top of the ther- mocouple tip for natural. See Figure 17 for correct pilot flame. If the pilot flame does not touch the thermocouple, then the bu
Resumen del contenido incluido en la página 20
PILOT REMOTE CONTROL OFF FLAME APPEARANCE CHECk ING BURNER FLAME In normal operation at full rate after 15 minutes, the following flame appearances should be observed: The left and right rear flames should be yellow and extend 1"-2" above middle logs. The yellow flames should not contact the logs. There should be glowing embers on the front surface of the middle log. Note: The flames and embers will be an opaque orange color during the burn off time. M
