Manual de instrucciones de Henkel KEEN KHT-900

Resumen del contenido incluido en la página 1

Henkel, Inc.

P.O. Box 1322


Hammond, LA

70404

(985) 345-2171

www.keenovens.com

Resumen del contenido incluido en la página 2

Henkel, Inc. P.O. Box 1322 * Hammond, Louisiana * 70404 * (985) 345-2171 www.keenovens.com Model KHT-900 Oven Installation Instructions & Repair Parts List One Year Limited Warranty Henkel, Inc. warrants its products against defects in material and workmanship. Henkel, Inc. will either repair or replace without charge any properly installed product which fails under normal operating conditions within one year from date of installation, provided it is returned to ou

Resumen del contenido incluido en la página 3

Recommended Spare Parts When it is critical to have continuous operation of this unit; we suggest having the following spare parts on hand: Heating Element Assembly Contactor General Information The model KHT-900 is a high temperature oven designed for rebaking electrodes. Temperatures range from 0º - 999º F. The diagonally compartmented shelf design allows greater capacity with less oven weight. These units are constructed of steel, treated, and then painted with a chemical resi

Resumen del contenido incluido en la página 4

• Do not store combustible material on or around the unit. • Do not operate this unit empty. • When using the unit at a distance where an extension cord becomes necessary, a 3-conductor grounding cord of adequate size must be used for safety, and to prevent loss of power and overheating. Use only a UL listed extension cord suitable for outdoor use. Make certain wire size is large enough for A/C amperage rating of unit. Installation Remove wooden crating material from upper portion

Resumen del contenido incluido en la página 5

oven an optimum temperature. The diagonal shelf design accommodates 50 lb. electrode containers eliminating the need to remove rods from the containers. The diagonal shelf design compartments also allow air to circulate freely throughout the oven. Guide to Storage See the enclosed guide to storage. This guide may be used in the absence of storage information from the electrode manufacturer. In critical situations, contact your electrode manufacturer. Scheduled Maintenance The ma

Resumen del contenido incluido en la página 6

Corrective Maintenance CHANGING HEATING ELEMENTS 1. Disconnect oven from power source. 2. Remove back cover and insulation. 3. Remove electrical leads from elements and inspect leads for damage. When removing or installing leads on elements, use a backup wrench. 4. From inside of oven, remove element cover. Unscrew element brackets, and remove elements from oven. 5. Install and rewire elements, being sure all connections are tight and insulated. CHANGING THE CONTROLLER 1. Dis

Resumen del contenido incluido en la página 7

KHT-900 ACCESSORIES LIST ** Please state model number and serial number and specify voltage and wattage when ordering repair parts, spare parts, or accessory parts. All necessary attaching hardware is supplied with each part ordered. (Item numbers refer to pictorial drawings below for repair parts.) Model KHT-900 Repair Parts List ITEM # QUANTITY DESCRIPTION PART NUMBER 1 1 Door Latch 430110 2 1 Grab Handle 430109 3 2 Vent Plug 490108 4 2 Handy Box 301033 5 2 Pilot Lig