Resumen del contenido incluido en la página 1
Installation
Instructions
®
Advantium 240V
Built-In SpeedCook
Ovens
PSB9240DF
PSB9240SF
ZSC2200
ZSC2201
ZSC2202
Español
For a Spanish version of this manual, visit
our Website at GEAppliances.com.
49-40690-1
Para consultar una version en español de
MFL59060908
este manual de instrucciones, visite nuestro
07-13 GE
sitio de internet GEAppliances.com.
Resumen del contenido incluido en la página 2
Safety Information CONTENTS BEFORE YOU BEGIN Design Information Read these instructions completely and carefully. Models Available ......................................................................2 IMPORTANT Save these instructions for Product Dimensions and Clearances ............................4 Tools and Parts Required ....................................................4 local inspector’s use. Parts Supplied ...........................................................................4
Resumen del contenido incluido en la página 3
Información de seguridad ANTES DE COMENZAR Lea estas instrucciones por completo y con detenimiento. IMPORTANTE Guarde estas instrucciones para el uso de inspectores locales. IMPORTANTE Cumpla con todos los códigos y ordenanzas vigentes. Nota al instalador Asegúrese de dejar estas instrucciones con el Consumidor. Nota al consumidor Mantenga estas instrucciones con el Manual del Propietario para referencia futura. Nivel de capacidad La instalación de este aparato requiere capacidade
Resumen del contenido incluido en la página 4
Design Information PRODUCT DIMENSIONS AND CLEARANCES NOTE: Appearance will vary by model. 21-1/2” 29-3/4” 1-3/5 19” 1” 1-1/10 13” ADVANCE PLANNING TOOLS AND PARTS REQUIRED These ovens may be installed directly into a 30” wide (NOT SUPPLIED) oven cabinet. #2 Phillips screwdriver Cutout dimensions are NOT the same for installation Hand held drill with or without an accessory storage drawer. Make High speed drill bit, 3/32" diameter sure to use the correct cutout when preparing the
Resumen del contenido incluido en la página 5
Installation Preparation ELECTRICAL REQUIREMENTS ADVERTENCIA El encendido eléctrico al circuito paralelo deberá estar Single Speedcook Installation apagado mientras se realizan las conexiones de línea. Product rating is 120/208 or 120/240 volt, 60 Hz, Use conductores de cobre únicamente. 30 amps. This product must be connected to a supply circuit of the proper voltage and frequency and Este electrodoméstico requiere que se realice una conexión protected by a time delay fuse or circuit
Resumen del contenido incluido en la página 6
Installation Preparation Preparation WITHOUT an Accessory Storage Drawer PREPARE THE OPENING PREPARE THE OPENING (CONT.) The Advantium 240V can be installed in Installation over a GE/Monogram combination with other GE/Monogram appliances. Warming Drawer: Always follow each product’s Installation 30” 23-1/2” Construct Instructions to complete the installation. Solid Bottom Min. 3/8” Single Advantium 240V Installation: Plywood Order a 30” wide single oven cabinet or cut the Supported
Resumen del contenido incluido en la página 7
Installation Preparation Preparation WITHOUT an Accessory Storage Drawer PREPARE THE OPENING (CONT.) PREPARE THE OPENING (CONT.) Installation over a GE/Monogram Oven: Installation over a GE/Monogram Oven and Warming Drawer: 30” 23-1/2” Construct Solid Construct Bottom Min. Solid Bottom 30” 23-1/2” 3/8” Plywood Min. 3/8” Supported by Plywood 2x4 or 2x2 Supported by Runners all 2x4 or 2x2 25-1/4” Four Sides Runners all 25-1/4” Four Sides 17-1/2” 2” Min. (3” recommended) 2” Min.
Resumen del contenido incluido en la página 8
Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING PREPARE THE OPENING (CONT.) The Advantium 240V can be installed in Single Advantium 240V Installation (cont.) combination with other GE/Monogram appliances. When installed over a single oven or a warming Always follow each product’s Installation draw
Resumen del contenido incluido en la página 9
Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING (CONT.) PREPARE THE OPENING (CONT.) Installation over a GE/Monogram Oven: Installation over a GE/Monogram Oven and Warming Drawer: Construct 23-1/2” Construct Solid 30” Solid Bottom 30” 23-1/2” Bottom Min. Min. 3/8” 3/8” Plywood Plywood Supported
Resumen del contenido incluido en la página 10
Installation Instructions 1 REMOVE THE PACKAGING AND PARTS by handle or conduit. Two people are required to lift this oven. Owner’s Manual Rack Owner’s Manual Installation Instructions Bottom Trim Cooking Guide 6 Brass Screws 5 Color Matched Screws (3 required, 3 extra) (4 required, 1 extra) Cook Book Cooking Guide IMPORTANT: If installing the Advantium 240V Oven with an accessory storage drawer, read the storage drawer assembly instructions to assembl
Resumen del contenido incluido en la página 11
Installation Instructions GROUNDING INSTRUCTIONS 2 ROUTE CONDUIT THROUGH CUTOUT This appliance must be connected to a grounded, CAUTION: Two people are required to metallic, permanent wiring system, or an equipment lift the oven into the opening. Grasp the bottom grounding connector should be run with the circuit at front and rear. Discard foam base. DO NOT USE conductors and connected to the equipment HANDLE OR CONDUIT TO LIFT THE OVEN. DAMAGE grounding terminal or lead on the applia
Resumen del contenido incluido en la página 12
Installation Instructions 3 4 INSTALL MOUNTING SCREWS INSTALL BOTTOM TRIM NOTE: If installing the Advantium 240 Oven with an accessory storage drawer, the bottom trim is not required. Proceed to Step 4. Align bottom trim tabs to slots in the bottom of the oven. Slide the oven the remaining way into the opening so that the side flanges and control panel are against the cabinet frame. Make sure that the oven Secure the bottom trim to the bottom of the oven is centered in the open
Resumen del contenido incluido en la página 13
Assembly Instructions ® Advantium 240V Built-In Accessory Storage Drawer JX2200, JX2201, ZX2201 MODELS AVAILABLE BEFORE YOU BEGIN Models: Read these instructions completely and carefully. Read JX2200BB–Black the Installation Instructions for the Advantium 240V oven JX2201SS–Stainless Steel completely and carefully for cutout dimensions and step-by-step instructions. Monogram Models: IMPORTANT Save these instructions for ZX2201SS–Stainless Steel local inspector’s use. NOTE: Advantium 2
Resumen del contenido incluido en la página 14
ASSEMBLY TO ADVANTIUM 240V BUILT-IN SPEEDCOOK OVEN ASSEMBLING THE OVEN TO DRAWER 1 REMOVE PACKAGING AND PARTS (CONT.) Remove the front two bottom screws on each C side of the oven and the top center screw on each side of the storage drawer. Side Supports (2) Assembly Instructions Screws (2 Sets) 2 ASSEMBLING THE OVEN TO DRAWER Place storage drawer on a surface with the A front of drawer hanging over the edge of the surface. Not placing the front edge of drawer over the edg
Resumen del contenido incluido en la página 15
Notes 15
Resumen del contenido incluido en la página 16
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. GE Appliances & Lighting Appliances NOTE: Product improvement is a continuing endeavor at General Electric Company General Electric. Therefore, materials, appearance and specifications are subject to change without notice. Louisville, KY 40225 GEAppliances.com Printed in Korea
Resumen del contenido incluido en la página 17
Instrucciones de instalación Hornos de cocción rápida empotrados ® de 240V Advantium PSB9240DF PSB9240SF ZSC2200 ZSC2201 ZSC2202 49-40690-1 MFL59060908 06-13 GE
Resumen del contenido incluido en la página 18
Información de seguridad CONTENIDOS ANTES DE COMENZAR Lea estas instrucciones por completo y con Información de diseño detenimiento. Modelos disponibles ..............................................................2 Dimensiones y distancias del producto .......................3 IMPORTANTE Guarde estas instrucciones Herramientas y piezas requeridas ..................................3 para el uso de inspectores locales. Piezas provistas .........................................................
Resumen del contenido incluido en la página 19
Información de diseño DIMENSIONES Y DISTANCIAS DEL PRODUCTO NOTA: La apariencia varía según el modelo. 21-1/2” 29-3/4” 1-3/5 19” 1” 13” 1-1/10 PLANIFICACIÓN PREVIA HERRAMIENTAS Y PIEZAS REQUERIDAS Estos hornos pueden instalarse directamente dentro (NO PROVISTAS) de un gabinete para horno de 30” de ancho. Destornillador de estrella #2 Las dimensiones del recorte NO son iguales para la Perforadora de mano instalación con o sin un cajón de almacenamiento Broca para perforadora de a
Resumen del contenido incluido en la página 20
Preparación para la instalación REQUISITOS ELÉCTRICOS (Cont) REQUISITOS ELÉCTRICOS NO posee un fusible en el circuito neutro o de conexión INSTALACIÓN DE UN SPEEDCOOK INDIVIDUAL a tierra. Un fusible en el circuito neutro o de conexión a La potencia del producto es de 120/208 o 120/240 tierra podría ocasionar una descarga eléctrica. volt, 60 Hz, 30 amperes. Este producto debe ser Consulte a un electricista calificado o personal del servicio conectado a un circuito con el suministro corre
