Resumen del contenido incluido en la página 1
Cisco 10005 ESR AC Power Supply
Installation
March 30, 2001
This installation note provides procedures for installing and replacing AC power
supply modules in a Cisco 10005 edge services router (ESR).
Contents
The following sections are included in this installation note:
• Product Description, page 2
� Prerequisites and Preparation, page 2
� Adding or Replacing an AC Power Supply, page 7
� FCC Class B Compliance, page 13
� Related Documentation, page 14
� Obtaining Documentation, page 15
�
Resumen del contenido incluido en la página 2
C CA AUTIO UTION N THIS UNIT HAS MORE THAN ONE POWER SUPPLY CORD. DISCONNECT TWO (2) POWER SUPPLY CORDS BEFORE SERVICING TO AVOID ELECTRIC SHOCK. 100-240V 50/60 HZ 15-7A Product Description Product Description The AC power supply (Figure 1) provides power conversion directly from the facility AC input power (100 to 240 VAC nominal) to the –48V VDC used internally by the system. Power is delivered to the power supply by the AC power cord. The AC power supply is provided with an IEC 320/C20 A
Resumen del contenido incluido en la página 3
Prerequisites and Preparation � Have access to the following documents during the installation: – Technology of Edge Aggregation: Cisco 10000 Series Edge Services Router (shipped with your router and available for viewing or download at Cisco.com) – Cisco 10005 ESR Hardware Installation Guide – Cisco 10000 Series ESR Troubleshooting Guide (an online document available for viewing or download at Cisco.com) – Cisco 10000 Series ESR Software Configuration Guide (an online document available f
Resumen del contenido incluido en la página 4
Prerequisites and Preparation Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. (To see translations of the warnings that appear in this publication, refer to the appendix “Translated Safety Warnings” in the installation guide that accompanied this device.) Waarschuwing Dit waarschuwing
Resumen del contenido incluido en la página 5
Prerequisites and Preparation Warnung Dieses Warnsymbol bedeutet Gefahr. Sie befinden sich in einer Situation, die zu einer Körperverletzung führen könnte. Bevor Sie mit der Arbeit an irgendeinem Gerät beginnen, seien Sie sich der mit elektrischen Stromkreisen verbundenen Gefahren und der Standardpraktiken zur Vermeidung von Unfällen bewußt. (Übersetzungen der in dieser Veröffentlichung enthaltenen Warnhinweise finden Sie im Anhang mit dem Titel “Translated Safety Warnings” (Übersetzung
Resumen del contenido incluido en la página 6
Prerequisites and Preparation ¡Advertencia! Este símbolo de aviso significa peligro. Existe riesgo para su integridad física. Antes de manipular cualquier equipo, considerar los riesgos que entraña la corriente eléctrica y familiarizarse con los procedimientos estándar de prevención de accidentes. (Para ver traducciones de las advertencias que aparecen en esta publicación, consultar el apéndice titulado “Translated Safety Warnings,” en la guía de instalación que se acompaña con este disp
Resumen del contenido incluido en la página 7
Adding or Replacing an AC Power Supply Adding or Replacing an AC Power Supply This section describes how to add or replace an AC power supply in a Cisco 10005 chassis. It contains these procedures: � Installing a Second AC Power Supply � Replacing an AC Power Supply � Troubleshooting the Installation Installing a Second AC Power Supply Warning Never install an AC power module and a DC power module in the same chassis. Follow these steps to install a second AC power supply for redundancy: Ste
Resumen del contenido incluido en la página 8
RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX TX TX RX RX TX TX RX RX TX TX TX TX RX RX RX RX TX TX RX RX TX TX RX RX TX TX RX RX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX CRITICAL CRITICAL MI
Resumen del contenido incluido en la página 9
CAUTION CAUTION Adding or Replacing an AC Power Supply Step 6 Snug up the strain relief device that secures the power cord to the power supply. To do this, tighten the screw underneath the connector (Figure 3). Figure 3 Tightening AC Power Cord Strain Relief Warning Do not over-tighten the strain relief devices that secure the power cords to the power supplies. Because this chassis cannot be switched off completely, you must disconnect the power cords to remove power from the chassis. Th
Resumen del contenido incluido en la página 10
RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX MINOR MINOR MAJOR MA
Resumen del contenido incluido en la página 11
RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX TX TX RX RX RX RX TX TX RX RX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX RX RX TX TX CRITICAL CRITICAL MI
Resumen del contenido incluido en la página 12
CA CAUTION UTION Adding or Replacing an AC Power Supply Step 8 Snug up the strain relief device that secures the power cord to the power supply. To do this, tighten the screw underneath the connector (Figure 6). Figure 6 Tightening AC Power Cord Strain Relief Warning Do not over-tighten the strain relief devices that secure the power cords to the power supplies. Because this chassis cannot be switched off completely, you must disconnect the power cords to remove power from the chassis. The
Resumen del contenido incluido en la página 13
FCC Class B Compliance Troubleshooting the Installation Table 1 contains troubleshooting tips for an AC-powered Cisco 10005 ESR. Table 1 Troubleshooting AC-Powered Systems Symptom Steps to Take System fails to power Check that: on � All power cords are properly connected to the Cisco 10005 and at the power connection end. � The power switches are in the | (On) position. � The Power LED is on (green). � The fan assembly is fully inserted (Fan Status LED is green). Power supply Fault � Make su
Resumen del contenido incluido en la página 14
Related Documentation You can determine whether your equipment is causing interference by turning it off. If the interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures: � Turn the television or radio antenna until the interference stops. � Move the equipment to one side or the other of the televisi
Resumen del contenido incluido en la página 15
Obtaining Documentation � Cisco 10000 Series ESR Useful Links � Cisco 10000 technical reference documents Hardware Documents for Cisco 10008 Routers � Cisco 10008 ESR Hardware Installation Guide � Cisco 10008 ESR AC Power Entry Module Installation � Cisco 10008 ESR DC Power Entry Module Installation � Cisco 10008 ESR Blower Module Installation Hardware Documents for Cisco 10005 Routers � Cisco 10005 ESR Hardware Installation Guide � Cisco 10005 ESR Hardware Overview and Maintenance Guide (onli
Resumen del contenido incluido en la página 16
Obtaining Documentation Documentation CD-ROM Cisco documentation and additional literature are available in a CD-ROM package, which ships with your product. The Documentation CD-ROM is updated monthly and may be more current than printed documentation. The CD-ROM package is available as a single unit or through an annual subscription. Ordering Documentation Cisco documentation is available in the following ways: � Registered Cisco Direct Customers can order Cisco Product documentation from
Resumen del contenido incluido en la página 17
Obtaining Technical Assistance Obtaining Technical Assistance Cisco provides Cisco.com as a starting point for all technical assistance. Customers and partners can obtain documentation, troubleshooting tips, and sample configurations from online tools. For Cisco.com registered users, additional troubleshooting tools are available from the TAC website. Cisco.com Cisco.com is the foundation of a suite of interactive, networked services that provides immediate, open access to Cisco informatio
Resumen del contenido incluido en la página 18
Obtaining Technical Assistance Contacting TAC by Using the Cisco TAC Website If you have a priority level 3 (P3) or priority level 4 (P4) problem, contact TAC by going to the TAC website: http://www.cisco.com/tac P3 and P4 level problems are defined as follows: � P3—Your network performance is degraded. Network functionality is noticeably impaired, but most business operations continue. � P4—You need information or assistance on Cisco product capabilities, product installation, or basic pro
Resumen del contenido incluido en la página 19
Obtaining Technical Assistance Cisco 10005 ESR AC Power Supply Installation 78-12652-01 19
Resumen del contenido incluido en la página 20
Obtaining Technical Assistance Use this document in conjunction with the documents listed in the “Related Documentation” section. AccessPath, AtmDirector, Browse with Me, CCDA, CCDE, CCDP, CCIE, CCNA, CCNP, CCSI, CD-PAC, CiscoLink, the Cisco NetWorks logo, the Cisco Powered Network logo, Cisco Systems Networking Academy, the Cisco Systems Networking Academy logo, Fast Step, Follow Me Browsing, FormShare, FrameShare, GigaStack, IGX, Internet Quotient, IP/VC, iQ Breakthrough, iQ Expertise, iQ
