Manual de instrucciones de Paradyne IP DSLAM Multiplexer Module MUM200-2

Resumen del contenido incluido en la página 1

Installation Instructions

MUM200-2
IP DSLAM Multiplexer Module with Dual Uplink Interface Capacity




Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when
CAUTION
handling this equipment.


1.0 INSTALLATION

1.1 Unpack and Inspect the Multiplexer Uplink Module (MUM)
If there is visible damage, do not attempt to install the MUM200-2; contact Customer Support at 1-
877-638-2638 (001-603-427-0600 for international customers)

Resumen del contenido incluido en la página 2

Secure the UIM faceplate to the MUM200-2 faceplate using the (2) provided beige flathead screws. 1.3 Install the MUM200-2 in an IP DSLAM Chassis The IPD12000 is a fourteen slot chassis; slots 1-12 are reserved for interface modules (such as the SIM2000-24) and slots 13-14 are reserved for MUMs. Although not required for operational purposes, if redundancy is desired two MUMs may be installed in the IPD12000, one each in slot 13 and slot 14. The IPD4000 is a five slot chassis; slots

Resumen del contenido incluido en la página 3

Verify the connection: the Lnk (link) LED on the UIM-DS3 and UIM-E3 faceplate will flash green to indicate a network connection has been established. For further information refer to the Installation Instructions for each individual UIM model. 2.0 IP DSLAM MANAGEMENT The MUM200-2 provides IP DSLAM management capability via Net to Net's web-based Network Management System (NMS) and a scaled-down version of Simple Network Management Protocol (SNMP). For access and configuration i

Resumen del contenido incluido en la página 4

3.2 Regulatory Compliance for Class A Equipment The following regulatory compliance information applies to a MUM200-2 as installed in one of Net to Net Technologies' IP DSLAMs. 3.2.1 US Federal Communications Commission (FCC) Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated