Manual de instrucciones de Nokia BH-213

Resumen del contenido incluido en la página 1

Nokia Bluetooth Headset BH-213
44
1
3
5
2
6
7
9 11
8
10
Issue 1

Resumen del contenido incluido en la página 2

Nokia operates a policy of ongoing DECLARATION OF CONFORMITY development. Nokia reserves the right to Hereby, NOKIA CORPORATION declares make changes and improvements to any that this HS-127W product is in of the products described in this compliance with the essential document without prior notice. requirements and other relevant To the maximum extent permitted by provisions of Directive 1999/5/EC. A applicable law, under no circumstances copy of the Declaration of Conformity shall

Resumen del contenido incluido en la página 3

Export controls laws and regulations from the US and This device may contain commodities, other countries. Diversion contrary to technology or software subject to export law is prohibited. Introduction With the Nokia Bluetooth Headset in line of sight, but they should be BH-213, you can make and receive within 10 metres (33 feet) of each calls while on the move. other. Connections may be subject to interference from obstructions, Read this user guide carefully such as walls, or other elec

Resumen del contenido incluido en la página 4

Get started The headset contains the following chargers: AC-3, AC-4, AC- 5, and DC-4. following parts shown on the title page: indicator light (1), Warning: Use only multifunction key (2), charger chargers approved by connector (3), earloop (4), earpiece Nokia for use with this particular enhancement. The use of (5), volume key (6), and any other types may invalidate any microphone (7). approval or warranty, and may be Before using the headset, you dangerous. must charge the battery an

Resumen del contenido incluido en la página 5

charging. Charging the battery To switch off, press and hold the fully may take up to 2 hours. multifunction key for about 5 seconds. The headset beeps, and 3. When the battery is fully the red indicator light is briefly charged, the green indicator displayed. light is displayed. Disconnect the charger from the headset, Pair the headset then the wall outlet. 1. Ensure that your phone is on The fully charged battery has and the headset is off. power for up to 10 hours of talk 2. Press

Resumen del contenido incluido en la página 6

connection separately after When the headset is connected to pairing. your phone and is ready for use, the green indicator light flashes slowly. Basic use Place the headset on the ear Calls To use the headset with the To make a call, use your phone in earloop, attach the earloop to it the normal way when the headset (8). To detach the earloop, gently is connected to it. pull it from the headset (9). To redial the number you last Slide the earloop behind your ear called (if your phone suppo

Resumen del contenido incluido en la página 7

To answer or end a call, press the multifunction key for about 2 multifunction key. To reject a call, seconds (the headset switches on). press this key twice. Clear settings or reset To adjust the volume during a call, To delete the pairings from the slide the volume key up or down. headset or reset the headset, To mute or unmute the switch off the headset, and press microphone during a call, briefly and hold the multifunction key for press the middle of the volume over 8 seconds. key.

Resumen del contenido incluido en la página 8

If a battery is being used for the first limited in temperatures well below time or if the battery has not been freezing. used for a prolonged period, it may be Do not dispose of batteries in a fire as necessary to connect the charger, they may explode. Batteries may also then disconnect and reconnect it to explode if damaged. begin charging the battery. If the Never use any charger that is battery is completely discharged, it damaged. may take several minutes before the Important: Bat

Resumen del contenido incluido en la página 9

Care and maintenance Your device is a product of superior its normal temperature, moisture design and craftsmanship and should can form inside the device and be treated with care. The following damage electronic circuit boards. suggestions will help you protect � Do not attempt to open the your warranty coverage. device. � Keep the device dry. Precipitation, � Do not drop, knock, or shake the humidity, and all types of liquids device. Rough handling can break or moisture can contain mine