Resumen del contenido incluido en la página 1
Setup Guide
®
VersaTools MTP Series
Video and Audio Mini Twisted Pair Transmitters and Receivers
68-732-50 Rev. A
09 08
Resumen del contenido incluido en la página 2
Precautions Safety Instructions • English Warning Power sources • This equipment should be operated only from the power source This symbol is intended to alert the user of important indicated on the product. This equipment is intended to be used with a main power operating and maintenance (servicing) instructions in system with a grounded (neutral) conductor. The third (grounding) pin is a safety the literature provided with the equipment. feature, do not attempt to bypass or disable it.
Resumen del contenido incluido en la página 3
Precautions, cont’d 警告 安全须知 • 中文 电源 • 该设备只能使用产品上标明的电源。 设备 这个符号提示用户该设备用户手册中 必须使用有地线的供电系统供电。 第三条线 有重要的操作和维护说明。 （地线）是安全设施，不能不用或跳过。 拔掉电源 • 为安全地从设备拔掉电源，请拔掉所有设备后 这个符号警告用户该设备机壳内有暴 或桌面电源的电源线，或任何接到市电系统的电源线。 电源线保护 • 妥善布线， 避免被踩踏，或重物挤压。 露的危险电压，有触电危险。 维护 • 所有维修必须由认证的维修人员进行。 设备内部 注意 没有用户可以更换的零件。为避免出现触电危险不要自 阅读说明书 • 用户使用该设备前必须阅读并理 己试图打开设备盖子维修该设备。 解所有安全和使用说明。 通风孔 • 有些设备机壳上有通风槽或孔，它们是用来防止 保存说明书 • 用户应保存安全说明书以备将来使 机内敏感元件过热。 不要用任何东西挡住通风孔。 用。 锂电池 • 不正确的更换电池会有爆炸的危险。 必须使用 遵守警告 • 用户应遵守产品和用户指南上的所有安 与厂家推荐的相同或相近型号的电池。 按照生
Resumen del contenido incluido en la página 4
Resumen del contenido incluido en la página 5
Table of Contents Chapter One • Installation ................................................... 1-1 About the MTP Transmitters and Receivers ................... 1-2 Signal Jumpers for Generational Compatibility ............ 1-3 Mounting Options ................................................................... 1-4 Frame mounting (AAP models) ........................................... 1-4 Furniture or projector mounting (except AAP models) ..... 1-4 Rack mounting (all except AAP models)
Resumen del contenido incluido en la página 6
Table of Contents, cont’d All trademarks mentioned in this manual are the properties of their respective owners. 68-732-50 Rev. A 09 08 ® ii VersaTools MTP Series • Table of Contents ® Refer also to the VersaTools MTP Series User’s Manual at www.extron.com.
Resumen del contenido incluido en la página 7
VersaTools ® MTP Series Series Chapter One 1 Installation About the MTP Transmitters and Receivers Signal Jumpers for Generational Compatibility Mounting Options Panel Features and Connections
Resumen del contenido incluido en la página 8
AAP mounted RCA Captive screw Composite video S-video Installation About the MTP Transmitters and Receivers The Extron MTP transmitters and receivers provide a system for long‑distance distribution of A/V signals over Category (CAT) 5 shielded (STP), unshielded (UTP), or foil shielded (FTP) twisted ® pair cable. They are part of the Extron VersaTools line of basic distribution amplifiers, switchers, transmitters, receivers, and associated video accessories. An MTP transmit
Resumen del contenido incluido en la página 9
Signal Jumpers for Generational Compatibility The latest generation MTP transmitters convert stereo audio to mono before outputting it to the receiver. Remote powering of either the transmitter or receiver has also been eliminated. While the default setup of a new generation (mono audio) MTP transmitter/receiver is not compatible with older generation (stereo audio) units, internal jumpers provide backward compatibility and also allow new generation units to utilize the two features (
Resumen del contenido incluido en la página 10
Installation, cont’d Mounting Options Tabletop use (all except AAP models) The non‑AAP MTP units come with self‑adhesive rubber feet attached to the four corners of the bottom. Set the MTP on a horizontal surface. Rack mounting (all except AAP models) For rack mounting, use any of the rack shelves listed in the "Accessories" table in the Appendix, page A‑2. UL Guidelines Refer to the VersaTools MTP Series User's Manual for Underwriters Laboratories (UL) guidelines pertaining to the install
Resumen del contenido incluido en la página 11
Panel Features and Connections Transmitter input connections Figure 1‑1 shows the video and audio input connectors of the MTP Series transmitters. Some transmitters do not have audio connections. N INPUT INPUT LR LR cc S-VIDEO OUTPUT VIDEO OUTPUT 12V 12V 0.5a MAX 0.5a MAX MTP T SV A MTP T AV MTP T SV A, MTP T AV, Rear Panel Rear Panel a b INPUT INPUT dd LR LR S-VIDEO OUTPUT VIDEO OUTPUT 12V 12V 0.5a MAX 0.5a MAX MTP T SV A RCA MTP T AV RCA MTP T SV A RCA, MTP T AV RCA, Rear Panel Rear Panel
Resumen del contenido incluido en la página 12
L R L R Installation, cont’d Audio input captive screw connector (MTP T SV A, c MTP T AV) — Connect a balanced or unbalanced audio input to this 3.5 mm, 5‑pole captive screw connector. Connectors are included with each MTP. See Figure 1‑2 to wire a connector for the appropriate input type. Use the supplied tie‑wrap to strap the audio cable to the extended tail of the connector. High impedance is generally over 800 ohms. Tip Tip Sleeve Ring Sleeve (s) Tip Tip Sleeve Ring Unbalanced Ste
Resumen del contenido incluido en la página 13
− + POWER OUTPUT 12V 0.5A MAX Transmitter/receiver throughput connections See Figure 1‑5 to identify the connections between the transmitter and receiver. MTP Transmitters MTP Receivers INPUT OUTPUT L R L R S-VIDEO S-VIDEO OUTPUT 12V 12V INPUT 0.5a MAX 0.5a MAX MTP R SV A RCA MTP T SV A RCA e e INPUT OUTPUT L R L R VIDEO VIDEO OUTPUT INPUT 12V 12V 0.5a MAX 0.5a MAX MTP R AV MTP T AV e Figure 1-5 — Throughput connections Do not connect these devices to a computer data or C telecommunicatio
Resumen del contenido incluido en la página 14
− + POWER OUTPUT 12V 0.5A MAX Installation, cont’d Power connection (all models) See Figure 1‑6 to identify the power connections and indicators. MTP Transmitters MTP Receivers INPUT OUTPUT LR L R gg S-VIDEO S-VIDEO OUTPUT 12V INPUT 12V 0.5a MAX 0.5a MAX MTP R SV A RCA MTP T SV A RCA f fg MTP AAP Transmitters R L VIDEO AUDIO IN IN MTP T AV f Figure 1-6 — Power connections and indicators Power connector — Plug the external 12 VDC power supply f into this 2‑pole captive screw connector on both
Resumen del contenido incluido en la página 15
The length of exposed wires is critical. Ideal length is C 3/16” (5 mm). If the stripped section of wire is longer than 3/16” the exposed wires may touch, causing a short circuit. If the stripped section of wire is shorter, wires can easily be pulled out even if tightly fastened by the captive screws. Do not tin the stripped leads! Tinned wires are not as N secure in the captive screw and direct insertion connectors and could be pulled out. Verify the polarity before connection! P
Resumen del contenido incluido en la página 16
L R Installation, cont’d Receiver output connections Figure 1‑8 shows all combinations of rear panel output connections for the MTP receivers. MTP R SV A, MTP R SV A RCA, Rear Panel Rear Panel OUTPUT OUTPUT L R k j L R h S-VIDEO S-VIDEO INPUT 12V INPUT 12V 0.5a MAX 0.5a MAX MTP R SV A MTP R SV A RCA MTP R AV, MTP R AV RCA, Rear Panel Rear Panel OUTPUT OUTPUT LR j k LR i VIDEO VIDEO INPUT 12V INPUT 12V 0.5a MAX 0.5a MAX MTP R AV MTP R AV RCA Figure 1-8 — Output connector wiring S-v
Resumen del contenido incluido en la página 17
VersaTools ® MTP Series Series Chapter Two 2 Operation Front Panel Features Troubleshooting — Skew Delay Compensation
Resumen del contenido incluido en la página 18
Front Panel Operation Front Panel Features MTP R Composite Video MTP R S-video Receiver Receiver Front Panel Front Panel acbaccb Figure 2-1 — MTP receiver front panels Power LED — When lit, this LED indicates power is applied to a the MTP. Sharpness — Adjusts output image sharpness to compensate b for long cable runs. Gain control — Adjusts the brightness of the output image to c compensate for long cable runs. S-video receivers — There are separate controls for luminance (Y) and chromi
Resumen del contenido incluido en la página 19
VersaTools ® MTP Series Series Appendix A A Reference Information Specifications Part Numbers
Resumen del contenido incluido en la página 20
Specifications, Part Numbers, and Accessories Specifications Consult the VersaTools User's Manual on the included CD ROM or at www.extron.com for a complete list of specifications. Please consult the VersaTools User's Manual found at www.extron.com or on the included CD ROM for a complete list of optional accessories, pre‑cut cables, connectors and bulk cable. For highest quality, reliability and compatibility always use Extron cable, connectors, and bulk cable. Extron provides adapters for
