Manual de instrucciones de Revolabs Inc.HDX 9004

Resumen del contenido incluido en la página 1

Revolabs Fusion™ Microphone System - Polycom HDX 9004 Setup Guide
NOTES AND CAUTIONS:


This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion Microphone System to a Polycom HDX 9004 video codec.

1. Connecting the Cables
2. Configuring the HDX 9004 Video Codec

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion Microphone System and/or the video codec may not function
properly. Please

Resumen del contenido incluido en la página 2

Connecting the Cables CONNECTING A REVOLABS FUSION MICROPHONE SYSTEM TO POLYCOM HDX 9004 VIDEO CODEC 1. Connect a Male RCA-RCA audio cable between the “CONF OUT” port on the Fusion and the red “AUDIO INPUT 1” port on the HDX 9004. 2. Connect a Male RCA-RCA audio cable between the “CONF IN” port on the Fusion and the red “AUDIO OUTPUT 1” port on the HDX 9004. 3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion and the Speakers.

Resumen del contenido incluido en la página 3

Configuring the HDX 9004 Video Codec CONFIGURING THE AUDIO MENUS OF THE HDX 9004 VIDEO CODEC 1. Select SYSTEM 2. Select ADMIN SETTINGS and enter the Administrator password (if needed) 3. Select AUDIO 4. Select AUDIO SETTINGS 5. Disable POLYCOM MICROPHONES by removing the check mark. Having Revolabs and Polycom microphones will increase ambient noise, add to echo cancellation problems, and reduce articulation 6. Verify LIVE MUSIC MODE is disabled by removing the check mark. Polycom