Resumen del contenido incluido en la página 1
VS-100_r_e.book 1 ページ ２００９年３月２５日 水曜日 午前９時３４分
Hardware Manual
Resumen del contenido incluido en la página 2
VS-100_r_e.book 2 ページ ２００９年３月２５日 水曜日 午前９時３４分
Resumen del contenido incluido en la página 3
VS-100_r_e.book 3 ページ ２００９年３月２５日 水曜日 午前９時３４分 USING THE UNIT SAFELY About WARNING and CAUTION Notices About the Symbols The symbol alerts the user to important instructions or Used for instructions intended to alert the warnings.The specific meaning of the symbol is user to the risk of death or severe injury determined by the design contained within the triangle. In should the unit be used improperly. the case of the symbol at left, it is used for general cautio
Resumen del contenido incluido en la página 4
VS-100_r_e.book 4 ページ ２００９年３月２５日 水曜日 午前９時３４分 USING THE UNIT SAFELY • Be sure to use only the AC adaptor supplied with • Immediately turn the power off, remove the AC the unit. Also, make sure the line voltage at the adaptor from the outlet, and request servicing installation matches the input voltage specified by your retailer, the nearest Roland Service on the AC adaptor's body. Other AC adaptors Center, or an authorized Roland distributor, as may use a different pol
Resumen del contenido incluido en la página 5
VS-100_r_e.book 5 ページ ２００９年３月２５日 水曜日 午前９時３４分 USING THE UNIT SAFELY • The unit and the AC adaptor should be located • Whenever you suspect the possibility of so their location or position does not interfere lightning in your area, disconnect the AC with their proper ventilation. adaptor from the outlet. ...................................................................................................................... ...................................................
Resumen del contenido incluido en la página 6
VS-100_r_e.book 6 ページ ２００９年３月２５日 水曜日 午前９時３４分 IMPORTANT NOTES Power Supply • Depending on the material and temperature of the surface on which you place the unit, its rubber feet may discolor or mar • Do not connect this unit to same electrical outlet that is being the surface. used by an electrical appliance that is controlled by an You can place a piece of felt or cloth under the rubber feet to inverter (such as a refrigerator, washing machine, microwave prevent this from happen
Resumen del contenido incluido en la página 7
VS-100_r_e.book 7 ページ ２００９年３月２５日 水曜日 午前９時３４分 IMPORTANT NOTES Using SD Memory Cards Copyright • Carefully insert the SD memory card all the way in—until it is • Recording, duplication, distribution, sale, lease, performance, firmly in place. or broadcast of copyrighted material (musical works, visual works, broadcasts, live performances, etc.) belonging to a third party in part or in whole without the permission of the copyright owner is forbidden by law. • This product can be used t
Resumen del contenido incluido en la página 8
VS-100_r_e.book 8 ページ ２００９年３月２５日 水曜日 午前９時３４分 Contents USING THE UNIT SAFELY............................................................................................................3 IMPORTANT NOTES .....................................................................................................................6 Overview..................................................................................... 11 Overview of the SONAR V-STUDIO 100........................................
Resumen del contenido incluido en la página 9
VS-100_r_e.book 9 ページ ２００９年３月２５日 水曜日 午前９時３４分 Connections............................................................................... 37 Connections ................................................................................................................................ 38 Connecting the AC adaptor........................................................................................................38 Connecting computers and audio equipments...............................
Resumen del contenido incluido en la página 10
VS-100_r_e.book 10 ページ ２００９年３月２５日 水曜日 午前９時３４分 Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (Hardware manual p. 3; p. 6). These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Hardware manual and Getting started should be read in its entirety. The manual should be saved and kept o
Resumen del contenido incluido en la página 11
VS-100_r_e.book 11 ページ ２００９年３月２５日 水曜日 午前９時３４分 Overview 11
Resumen del contenido incluido en la página 12
VS-100_r_e.book 12 ページ ２００９年３月２５日 水曜日 午前９時３４分 Overview of the SONAR V-STUDIO 100 fig.fader.eps High-end spec audio interface functions • USB 2.0 audio interface supporting 8-in/6-out and 24-bit/96 kHz • Extraneous noise-resistant balanced input/output • Two XLR input jacks with microphone preamps and phantom power Carefully selected parts are used to ensure transparent sound, ensuring spacious and high-quality recordings • Equipped with a wide variety of input/output terminals that provi
Resumen del contenido incluido en la página 13
VS-100_r_e.book 13 ページ ２００９年３月２５日 水曜日 午前９時３４分 Overview of the SONAR V-STUDIO 100 fig.fader.eps A digital mixer that supports a range of inputs • A digital mixer with 8 channel input • High quality sound design through digital signal processing with internal 40-bit computing • A compressor and a 3-band parametric equalizer for analog input WAVE recorder function • Directly record sample or performance onto an SD card Connecting to a computer is not necessary. The SONAR V-STUDIO 100 can be
Resumen del contenido incluido en la página 14
VS-100_r_e.book 14 ページ ２００９年３月２５日 水曜日 午前９時３４分 Panel Descriptions Input/output component Front panel fig.front01.eps 1. INPUT 1L/INPUT 2R [Hi-Z] button Analog audio signal input jacks with a microphone preamp. This switch changes the input impedance. Set this switch as appropriate for the device that you’ve connected to the You can use the [SENS] knob to adjust the input level of INPUT 1L LINE jack. INPUT 1L/INPUT 2R. The level is displayed on the screen. (See p. 18.) If y
Resumen del contenido incluido en la página 15
VS-100_r_e.book 15 ページ ２００９年３月２５日 水曜日 午前９時３４分 Panel Descriptions Rear panel fig.rear01.eps 4. Cord hook 10. Grounding terminal Hook the AC adapter’s cord here, see p. 38. Depending on the circumstances of a particular setup, you may experience a discomforting sensation, or perceive that 5. Power switch the surface feels gritty to the touch when you touch this Turn the power on/off. For more information, see p. 40. device, microphones connected to it, or the metal p
Resumen del contenido incluido en la página 16
VS-100_r_e.book 16 ページ ２００９年３月２５日 水曜日 午前９時３４分 Panel Descriptions INPUT OUTPUT fig.rear02.eps fig.rear03.eps 15. MAIN OUTPUT 1 and 2 (1/4” TRS balanced output) Analog audio signal output jacks 11. INPUT 3L/MONO and 4R (1/4” TRS balanced input) These outputs deliver the signals of the MAIN MIX, WAVE Analog audio signal input jacks for line input. If you only plug recorder and USB audio playback (OUT 1/2) from the mixer. into one INPUT 3L/MONO jack, it will functio
Resumen del contenido incluido en la página 17
VS-100_r_e.book 17 ページ ２００９年３月２５日 水曜日 午前９時３４分 Panel Descriptions Digital mixer component fig.mixer01.eps Input section fig.01.eps 1. [PAN] knob (INPUT 1L/INPUT 2R) Use this knob to adjust the balance between the right and left channels of the signal that is input from the INPUT 1L/2R. 2. [COMP/EQ] button Use this button to turn the compressors and equalizers on and off for each channel. For more information, see “Using the compressors and equalizers” (p. 48). 3. Level knob Us
Resumen del contenido incluido en la página 18
VS-100_r_e.book 18 ページ ２００９年３月２５日 水曜日 午前９時３４分 Panel Descriptions System section fig.02.eps 5. Compressor/equalizer setting button 8. Display screen Use this button to switch the display on the setting screen This screen displays a range of information. When you press between the compressor and the equalizer when using these the [DISPLAY] button, the level meter screen is displayed. effects. Level meter screen fig.lvl-meter.eps For more information about using
Resumen del contenido incluido en la página 19
VS-100_r_e.book 19 ページ ２００９年３月２５日 水曜日 午前９時３４分 Using the control surface component fig.mixer03.eps The button is off Computer If you connect SONAR V-STUDIO 100 to a computer and turn the power on, the section within the bounding rectangle in this illustration functions as the control surface for SONAR VS. Control surface screen fig.ctrl-disp1.eps Level meter screen Control surface screen When you are using SONAR, pressing the [DISPLAY] button switches between the level meter screen and
Resumen del contenido incluido en la página 20
VS-100_r_e.book 20 ページ ２００９年３月２５日 水曜日 午前９時３４分 Channel strip section fig.daw01.eps This section controls SONAR’s track or bus parameters. 1. Track selection button Use this button to select the track (or bus) to control. [SHIFT] + track selection buttons Press this key combination to switch the current strip between the track and the bus. Track selection button + [VALUE] knob Press and hold the track selection button while you turn the [VALUE] knob to select the track to cont
