Manual de instrucciones de Rolls HM58

Resumen del contenido incluido en la página 1

LIMITED WARRANTY
This product is warranted to the original consumer purchaser to be free from
defects in materials and workmanship under normal installation, use and service for a
period of one (1) year from the date of purchase as shown on the purchaser’s receipt.
The obligation of Rolls Corporation under this warranty shall be limited to repair
or replacement (at our option), during the warranty period of any part which proves
HM58
defective in material or workmanship under normal installation

Resumen del contenido incluido en la página 2

INTRODUCTION SCHEMATIC   Thank you for your purchase of the Rolls HM58 Headphone Monitor Remote. This    "      unit, along with either the HM60 Headphone Monitor System or HM57 Head-    
   phone Monitor Interface, allows you to mix four mono signals with two stereo           
 
signals for your own personal monitoring needs. It includes equalization and AGC          compression.              Please read the following manual carefull

Resumen del contenido incluido en la página 3

BLOCK DIAGRAM DESCRIPTION BACK PANEL EXPANSION PORTS: Male and Female 25 pin parallel port jacks. EQUALIZER COMPRESSOR FRONT PANEL MASTER Headphone FX NOTE: All HM58 controls adjust the levels of input signals connected to either the OUTPUT COMRPESSOR Output RETURN LEVEL IN/OUT HM60 or HM57. With the exception of the HM60 Effects Send controls, all other +V HM60 knobs will have no effect on the signals sent to the HM58. MAIN LEVEL DB25 MULTI-PIN EQUALIZER COMPRESSOR CONNECTOR MAIN IN:Controls th

Resumen del contenido incluido en la página 4

CONNECTION OPERATION CONNECTING THE HM58 OPERATING THE HM58 Shown below is a connection diagram for the HM58. The male Expansion jack, After proper connections are made, begin sending signals to the HM60 or HM57, shown below on the left side, is the INPUT, the female Expansion jack, shown whichever is connected to the signal sources and your HM58. here to the right, is the OUTPUT or through jack. So connect the DB25 expansion cable from the female OUTPUT Expansion jack of either the HM60 or HM57