Resumen del contenido incluido en la página 1
cover_NX-PN10[J].fm Page 1 Tuesday, March 3, 2009 4:23 PM
COMPACT COMPONENT SYSTEM
NX-PN10
For customer use:
Enter below the Model No. and
Serial No. which are located
either on the rear, bottom or side
of the cabinet. Retain this
information for future reference.
INSTRUCTIONS
Model No.
Serial No.
LVT2011-001A
[J]
Resumen del contenido incluido en la página 2
safety_NX-PN10[J].fm Page 1 Monday, March 2, 2009 2:29 PM Warnings, Cautions and Others Mises en garde, précautions et indications diverses CAUTION The button in any position does not disconnect the mains line. Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off). For U.S.A. The MAINS plug or an appliance coupler is used This equipment has been tested and found to as the disconnect device, the disconnect device comply with the limits for a Class B digit
Resumen del contenido incluido en la página 3
safety_NX-PN10[J].fm Page 2 Monday, March 2, 2009 2:29 PM For Canada/pour le Canada CAUTION THIS DIGITAL APPARATUS DOES NOT Do not block the ventilation openings or EXCEED THE CLASS B LIMITS FOR RADIO holes. NOISE EMISSIONS FROM DIGITAL (If the ventilation openings or holes are APPARATUS AS SET OUT IN THE blocked by a newspaper or cloth, etc., the INTERFERENCE-CAUSING heat may not be able to get out.) EQUIPMENT STANDARD ENTITLED Do not place any naked flame sources, such “DIGITAL APP
Resumen del contenido incluido en la página 4
safety_NX-PN10[J].fm Page 3 Monday, March 2, 2009 2:29 PM Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. 2. Sides/Top/Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm (3-15/16") or more. Attention: Aération co
Resumen del contenido incluido en la página 5
NX-PN10[J].BOOK Page 1 Thursday, April 9, 2009 8:55 AM Contents Introduction................................................. 2 Precautions ................................................................2 Getting Started............................................3 Connections................................................................4 Canceling the Display Demonstration (Demo) ..........6 Turning on the Power Automatically (Motion Sensor) .......................................
Resumen del contenido incluido en la página 6
NX-PN10[J].BOOK Page 2 Thursday, April 9, 2009 8:55 AM Introduction Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C (41°F and 95°F). • Install the unit in a location with adequate ventilation to prevent internal heat buildup insi
Resumen del contenido incluido en la página 7
NX-PN10[J].BOOK Page 3 Thursday, April 9, 2009 8:55 AM Getting Started Replacing the battery in the remote control • In this manual, operations using the remote Insert the battery into the remote control by control are mainly explained; however, you matching the polarity (+ and –) correctly. can use the buttons and controls on the unit • If the range or effectiveness of the remote if they have the same (or similar) name and control decreases, replace the battery. marks. Rear side • In t
Resumen del contenido incluido en la página 8
NX-PN10[J].BOOK Page 4 Thursday, April 9, 2009 8:55 AM Connections Do not connect the AC power cord until all other connections have been made. Connecting the Antenna FM antenna (supplied): Extend it so that you can obtain the best reception. Rear side For better FM reception Disconnect the supplied FM antenna and Outdoor FM antenna connect to an outdoor FM antenna using a 75 Ω (not supplied) wire with coaxial type connector. FM 75Ω COAXIAL terminal (on the rear panel) NOTES: • Make sure
Resumen del contenido incluido en la página 9
NX-PN10[J].BOOK Page 5 Thursday, April 9, 2009 8:55 AM Connecting the Video Cord to View a Video/Picture from iPod When viewing a video/picture from iPod on your TV, use a composite video cord (not supplied) to connect the VIDEO OUT jack on the unit and the composite video input on your TV. • After you have connected the unit, change the video input mode on your TV. For details, also refer to the instruction manual for your TV. Video cord (not supplied) To video input Rear side Connecting t
Resumen del contenido incluido en la página 10
NX-PN10[J].BOOK Page 6 Thursday, April 9, 2009 8:55 AM Canceling the Display Demonstration (Demo) When you connect the AC power cord for the first time, the display demonstration starts automatically. • When you operate the unit, the display demonstration stops temporarily. If no operation is done for about 2 minutes, the unit starts the display demonstration again. Button Operation On the unit Hold down until “DEMO OFF” appears on the display. • To activate again, hold down DEMO until “DEM
Resumen del contenido incluido en la página 11
NX-PN10[J].BOOK Page 7 Thursday, April 9, 2009 8:55 AM Basic Operations Main Unit Dock A Dock B Illumination panel (P.13) (P.13) (P.10) Motion sensor (P.6) Display (P.8) Remote STANDBY control lamp sensor Operating on the Main Unit Buttons Operations Turns on or off (standby) the power. Activates or deactivates Motion Sensor (P.6). 7
Resumen del contenido incluido en la página 12
NX-PN10[J].BOOK Page 8 Thursday, April 9, 2009 8:55 AM Buttons Operations Activates or deactivates the display demonstration (P.6). Adds the powerfulness to the sound (P.11). Stops the timer sound and restarts it 5 minutes later (P.22). • iPod (P.14): Press: Reverse skip/forward skip. Hold down: Reverse search/forward search. • FM (P.17): Tunes in to a station. • Changes the source to iPod /iPod (P.14). • Starts playback and pauses for iPod (P.14). Changes the source to FM (P.17) or FM AUDI
Resumen del contenido incluido en la página 13
NX-PN10[J].BOOK Page 9 Thursday, April 9, 2009 8:55 AM Symbols Description ST Lights up when FM stereo broadcast is received. MONO Lights up when FM monaural reception mode is activated. TUNED Lights up when an FM station of sufficient signal strength is tuned in. FM Lights up when FM is selected as the source. 1/2/3 • Lights up when Timer is set (P.21). • 1/2/3 icon flashes while Timer is working. SLEEP Lights up when Sleep Timer is activated (P.11). Remote Control P.10 P.11 P.20, P.22
Resumen del contenido incluido en la página 14
NX-PN10[J].BOOK Page 10 Thursday, April 9, 2009 8:55 AM Buttons Main operations Changes the display information. • For iPod A/iPod B/AUDIO IN: • When the unit is turned off: Source name Clock Clock Day of the week Day of the week • For FM: Frequency Clock Day of the week Changes the source to FM (P.17) or AUDIO IN (P.19). • Changes the source to iPod /iPod (P.14). • Starts playback and pauses for iPod (P.14). Adjusts the volume level (VOL MIN/VOL 0 to VOL MAX/VOL 30). Drops the volume in a m
Resumen del contenido incluido en la página 15
NX-PN10[J].BOOK Page 11 Thursday, April 9, 2009 8:55 AM To turn off the unit after a certain period of time—Sleep Timer Press repeatedly to specify the time (in minutes) as follows: 10 20 30 60 90 OFF 180 150 120 (Canceled) • To check the time remaining before the shut-off time, press SLEEP once. If you press the button repeatedly, you can change the shut-off time. To emphasize the sound—Sound Turbo You can add the powerfulness to the sound. Press to activate Sound Turbo. “S-TURBO” appears f
Resumen del contenido incluido en la página 16
NX-PN10[J].BOOK Page 12 Thursday, April 9, 2009 8:55 AM Playing Back from iPod Devices You can connect 2 iPod devices to the unit and enjoy sound and video from them. Compatible iPod Models: iPod model Audio Video √ iPod nano 1GB/2GB/4GB — √ iPod nano (2nd Generation) 2GB/4GB/8GB — √√ iPod nano (3rd Generation) 4GB/8GB √ iPod nano (4th Generation) 8GB/16GB √ √ iPod mini 4GB — √ iPod mini (2nd Generation) 4GB/ 6GB — √ iPod (4th Generation) 20GB/40GB — * √√ iPod photo (4th Generation) 20GB/30GB
Resumen del contenido incluido en la página 17
NX-PN10[J].BOOK Page 13 Thursday, April 9, 2009 8:55 AM Connecting iPod Connect iPod to dock A or B on the unit. You can have 2 iPod devices connected at the same time. • Make sure the unit is on standby when you connect iPod. Dock adapter (supplied with iPod or sold separately) Dock A Dock B To detach the dock adapter from the dock: Pull up the dock adapter with your fingernail or a sharp-pointed tool using the slot. • Be careful not to injure your fingertips or damage the terminal of the d
Resumen del contenido incluido en la página 18
NX-PN10[J].BOOK Page 14 Thursday, April 9, 2009 8:55 AM Operations For details, also refer to the instruction manual for iPod. NOTES: • Before viewing a video/picture from iPod on your TV, make the appropriate video setting on iPod. For details of the setting, see the instruction manual for iPod. • For iPhone and iPod touch Operate iPhone or iPod touch itself in the following cases: – when operating the home button – when selecting application icons on the home screen – when dragging the sli
Resumen del contenido incluido en la página 19
NX-PN10[J].BOOK Page 15 Thursday, April 9, 2009 8:55 AM Buttons Control of Operations On the iPod On the unit remote Confirms an item on the menu/screen. Center — * button Press: Applies Shuffle Play to iPod or iPod selected as the source. Select the desired shuffle mode. “SHUFFLE” appears for a while. • The shuffle icon lights up on the display of iPod. • To cancel, press again until the shuffle icon disappears. Hold down: Applies Shuffle Play to both iPod — — and iPod if c
Resumen del contenido incluido en la página 20
NX-PN10[J].BOOK Page 16 Thursday, April 9, 2009 8:55 AM NOTES: • JVC is not responsible for any loss of or damage to iPod that might result from the use of this product. • Do not touch or hit the terminals of the dock and of iPod. It might cause damage to these terminals. • When you connect iPod to the dock, make sure the terminal on the dock is fully inserted into iPod. • Always set the volume to the minimum level when connecting or disconnecting iPod. • Do not carry the unit with iPod con
