Resumen del contenido incluido en la página 1
XML8100
INSTALLATION/OWNER'S MANUAL
®
In-Dash AM/FM/Bluetooth Ready Docking Station
READY
Resumen del contenido incluido en la página 2
XML8100 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit, • Insert the supplied keys into
Resumen del contenido incluido en la página 3
XML8100 INSTALLATION Wiring Diagram BLACK 8-pin Female Mini-DIN BTM60 Connection (sold separately) FRONT RCA Preamp Output RCA Preamp Connections REAR/SUB Preamp Output GREEN 8-pin Male Mini-DIN (selectable) External Accessory Connection RCA Auxiliary Input iplug™ Connection Antenna Connector Steering Wheel Interface Input (PAC SWI-PS required) FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the
Resumen del contenido incluido en la página 4
XML8100 OPERATION Control Locations - Receiver (Closed) 1 2 3 4 5 6 7 8 9 16 15 14 13 12 11 10 Preset 3 Volume 1 9 Power Preset 6 2 10 Tune / Track Down Preset 5 3 11 12 Preset 4 4 Mode 5 13 End Call / Mute Audio / Menu 6 14 Display T alk 7 15 Preset 1 Tune / Track Up 8 Preset 2 16 Band / Play / Pause 4
Resumen del contenido incluido en la página 5
XML8100 OPERATION Control Locations - Receiver (Open) 1 2 3 12 11 10 9 8 7 6 5 4 Tune / Track Down LCD Display 7 1 ® Reset Dock for iPod 8 2 End Call / Mute Expansion Slot 9 3 4 Tune / Track Up 10 Volume Down 5 Mode 11 Volume Up 6 12 T alk Play / Pause / Band 5
Resumen del contenido incluido en la página 6
XML8100 OPERATION Control Locations - Remote 1 2 3 4 5 21 6 20 7 19 8 18 9 17 10 16 11 15 12 13 14 Mode Key 9 1 12 Power ( )/Select Mute / End Call 13 2 Volume Up Key 0 / Display 14 3 Audio / Menu 15 T alk 4 Tune / Track Up Key 8 5 16 Volume Down Key 7 6 17 Scan / PS / Key # Preset 4 / Play / Pause 18 7 Preset 2 / Random Preset 1 / Repeat 8 19 Preset 3 / Intro Band / ESC / Key * 20 9 Preset 6 / Folder Up Tune / Track Down 21 10 Preset 5 /
Resumen del contenido incluido en la página 7
XML8100 OPERATION General Operation Press the red power button or any other button to turn the Power On/Off unit on. Press and hold the red power button to turn the unit off. Mode Press MODE to select between AM/FM, Auxiliary input, Bluetooth and operation of iPod modes. Modes of operation are indicated in the display. Note: Operation of iPod mode will not appear unless an iPod device has been connected using the in-dash d
Resumen del contenido incluido en la página 8
XML8100 OPERATION General Operation Setup Menu Press and hold AUDIO/MENU for more than 3 seconds to access the setup menu, then press AUDIO/MENU to cycle through menu options. When desired option appears in the display, rotate the volume knob left/right to adjust or activate the desired function. Menu Exit Press BAND to exit any menu or submenu. Setup Menu Menu Function Options Action Auto Station Press the center SELECT to seek
Resumen del contenido incluido en la página 9
XML8100 OPERATION General Operation Audio Press AUDIO/MENU momentarily to select between Bass, Treble, Balance, Fader, EQ, Subwoofer* and Source Volume Level. BASS TREBLE BALANCE FADER EQ SUBWOOFER* SOURCE LEVEL Bass Press AUDIO/MENU until Bass appears, then rotate the volume knob left/right to adjust (-6 minimum / +6 maximum). Treble Press AUDIO/MENU until Treble appears, then rotate the volume knob left/righ
Resumen del contenido incluido en la página 10
XML8100 OPERATION AM/FM Tuner Operation Seek Tuning Press TUNE or TUNE for more than one second to nn ll seek the next strong station. Manual Tuning Press TUNE or TUNE momentarily to move radio nn ll frequency up or down one step at a time. Press and hold to advance quickly. Band Press BAND to select between FM1, FM2, FM3, AM1 and AM2 bands. Up to six presets can be saved for each band. Storing and Recalling Up to 18 FM stat
Resumen del contenido incluido en la página 11
XML8100 OPERATION Dock for iPod Operation To open the XML8100 and use the dock, pull outward from the top of the front panel. The front panel will rotate open. Continue rotating the front panel downward. The front panel stops when it reaches the fully open position. 11
Resumen del contenido incluido en la página 12
XML8100 OPERATION Dock for iPod Operation Some iPod devices have a thinner design, and For the 1st generation, 2nd generation and 4th may require changing the rear rubber support at generation iPod Nano devices, the left side dock the back of the dock for the best fit. support can be replaced with a larger rubber support, for the best fit. To change the rear rubber support, pull upward on support to remove it. Then replace the support To change the left side rubber support, pull w
Resumen del contenido incluido en la página 13
XML8100 OPERATION Operation of iPod Using the In-Dash Insert the iPod device into the XML8100's Dock, following Dock for iPod the instructions on pages 11 and 12. Control for iPod The iPod device can be controlled directly from the iPod device's interface, or controlled using the inside panel buttons shown below: Song Select Press to skip to the beginning of the next song. ll Press to return to the beginn
Resumen del contenido incluido en la página 14
XML8100 OPERATION ® Bluetooth Operation Overview Connecting a Bluetooth device requires first installing and connecting the Dual BTM60 Bluetooth interface module (sold separately). When connected to a Dual Bluetooth ready head unit, the BTM60 supports the HFP (hands-free profile), A2DP (advanced audio distribution profile) and AVRCP (audio video remote control profile). Preparation Before you can use a mobile device with this head uni
Resumen del contenido incluido en la página 15
XML8100 OPERATION ® Bluetooth Operation Description Function Press once. "Enter Number" will be shown, then An "_" will appear on the display. Input the desired phone number using the 0-9, *, # buttons on the Making a Phone Call remote control. Press to begin dialing. A phone call may also be placed from your mobile device using the keypad, phone book or speed dial. When a call is placed from a mobile device, “DIALING” will a
Resumen del contenido incluido en la página 16
XML8100 OPERATION ® Bluetooth Operation Description Function To view the 10 most recent calls , press , then press a second time. "Recent Calls" will be displayed. A list of the most recent missed, dialed, or received calls will appear, sorted by time, beginning with the most recent call. Recent Call List Press or to cycle through the list of recent calls. When ll nn the desired number appears on the display, press the center selec
Resumen del contenido incluido en la página 17
XML8100 OPERATION ® Bluetooth Operation Bluetooth Streaming Audio Operation The XML8100 supports A2DP (advanced audio distribution profile) wireless streaming audio from your Bluetooth mobile device directly to your head unit. You can also control your music from the front panel of the head unit using AVRCP (audio video remote control profile). Notes: • To stream music to your head unit, your mobile device must support A2DP and AVRCP
Resumen del contenido incluido en la página 18
XML8100 OPERATION Limited One Year Warranty This warranty gives you specific legal rights. What to do? You may also have other rights which vary from 1. Before you call for service, check the state to state. troubleshooting guide in your owner’s manual. A slight adjustment of any custom Dual Electronics Corp. warrants this product to controls may save you a service call. the original purchaser to be free from defects in materia
Resumen del contenido incluido en la página 19
XML8100 OPERATION Troubleshooting - General Problem Cause Action Yellow wire not connected or incorrect Check connections for proper voltage Red wire not connected or Unit will not turn on voltage (11~16VDC) incorrect voltage (no power) Black wire not connected Check connection to ground Fuse blown Replace fuse Speaker wires not connected Check connections at speakers Unit has power Insulate all bare speaker wires One or more speaker wires
Resumen del contenido incluido en la página 20
XML8100 OPERATION Specifications FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz AM Tuner Tuning range: 530kHz-1710kHz Usable sensitivity: 22uV Frequency response: 30Hz-2.2kHz General Operating voltage: 11-16 VDC, negative ground Speaker output impedance: 4~8 ohms Line output voltage: 2 Volts RMS Dimensions: 7" x 7" x 2" (178 x 178 x
