Resumen del contenido incluido en la página 1
Crestron TMK-6X-DSW & WMKT-6X-DSW
Trim Ring Kits for the TPS-6X-DSW
Installation Guide
Resumen del contenido incluido en la página 2
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2009 Crestron Electronics, Inc.
Resumen del contenido incluido en la página 3
Crestron TMK/WMKT-6X-DSW Trim Ring Mount Kits for the TPS-6X-DSW Contents Trim Ring Mount Kits for theTPS-6X-DSW: TMK-6X-DSW & WMKT-6X-DSW 1 Introduction ...............................................................................................................................1 Setup ..........................................................................................................................................2 Supplied Hardware ...............................................
Resumen del contenido incluido en la página 4
Resumen del contenido incluido en la página 5
Crestron TMK/WMKT-6X-DSW Trim Ring Mount Kits for the TPS-6X-DSW Trim Ring Mount Kits for theTPS-6X-DSW: TMK-6X-DSW & WMKT-6X-DSW Introduction ® These Trim Ring Mount Kits are the preferred method of mounting the Crestron TPS-6X-DSW Wall Mount Docking Station when a finished appearance within a neatly trimmed cutout is required. This application is perfect for wallpapering. NOTE: If mounting into a material other than drywall (for example, wood lectern, concrete, or rock) use the cuto
Resumen del contenido incluido en la página 6
Trim Ring Mount Kits for the TPS-6X-DSW Crestron TMK/WMKT-6X-DSW Setup Supplied Hardware The TMK-6X-DSW consists of a metal trim ring that attaches to the BB-6X-DSW or PMK-6X-DSW. The WMKT-6X-DSW consists of the trim ring found in the TMK-6X-DSW as well as a mounting plate, cutout template and mounting screws. The mounting plate provides the necessary support for post-construction applications. An overlay cutout template (4506370) is supplied which is similar to a frame, the inner area
Resumen del contenido incluido en la página 7
Crestron TMK/WMKT-6X-DSW Trim Ring Mount Kits for the TPS-6X-DSW Dimensional Drawing – Mounting Plate 10.31 in (26.19 cm) 0.06 in 8.00 in (0.16 cm) (20.32 cm) 8.16 in (20.73 cm) 6.35 in (16.13 cm) Drywall Cutout Template and Dimensions (supplied with WMKT-6X-DSW only 9 1/16 in (230 mm) 7 11/16 in (196 mm) 6 1/8 in (156 mm) 6 9/16 in (167 mm) Installation Guide – DOC. 6780A Trim Ring Mount Kits for the TPS-6X-DSW: TMK/WMKT-6X-DSW • 3
Resumen del contenido incluido en la página 8
Trim Ring Mount Kits for the TPS-6X-DSW Crestron TMK/WMKT-6X-DSW Installation This section provides an installation procedure for each Trim Ring Mount Kit. The “TMK-6X-DSW Procedure” starts below and the “WMKT-6X-DSW Procedure” starts on page 6. Be sure to review each procedure before starting. TMK-6X-DSW Procedure This section provides the necessary steps for the assembly of the TMK-6X-DSW with either the BB-6X-DSW or PMK-6X-DSW. It is assumed that the BB-6X-DSW or PMK-6X-DSW has been s
Resumen del contenido incluido en la página 9
Crestron TMK/WMKT-6X-DSW Trim Ring Mount Kits for the TPS-6X-DSW 3. When the trim ring is in position, bend the top two flanges of the ring upward and the bottom two flanges downward. • If mounting into the PMK-6X-DSW, bend the flanges approximately 90 degrees. • If mounting into the BB-6X-DSW, bend the flanges back as far as they can go. 4. Run the necessary cables for the TPX-6X-DSW and secure them behind the drywall. 5. The wall mount docking station can be installed using the four t
Resumen del contenido incluido en la página 10
Trim Ring Mount Kits for the TPS-6X-DSW Crestron TMK/WMKT-6X-DSW WMKT-6X-DSW Procedure This section provides the necessary steps for the assembly and installation of the WMKT-6X-DSW into a wall. Review the procedure and complete the steps in the order provided. The only tools or materials required and not supplied are a drywall saw or equivalent and a level. CAUTION: Allow an air gap of at least 12 inches (30.48 cm) in the wall cavity above and below the TPS-6X-DSW for heat dissipation.
Resumen del contenido incluido en la página 11
Crestron TMK/WMKT-6X-DSW Trim Ring Mount Kits for the TPS-6X-DSW Insert Trim Ring into Opening MOUNTING PLATE DRYWALL (2022811 ) TRIM RING IMPORTANT (2022808 ) MAKE DRYWALL CUTOUT AS LEVEL AND CLEAN AS POSSIBLE. THE TRIM RING ONLY ALLOWS MINOR ADJUSTMENTS OF THE TPS-6X-DSW. 5. Carefully pass the mounting plate through the opening and hold it against the interior surface of the drywall. 6. When the mounting plate is in position, bend the top two flanges of the trim ring upward (approx
Resumen del contenido incluido en la página 12
Trim Ring Mount Kits for the TPS-6X-DSW Crestron TMK/WMKT-6X-DSW Bend Flanges – 1 of 4 Flanges Bent BACK OF DRYWALL 7. Run the necessary cables for the TPS-6X-DSW and secure them behind the drywall. 8. The wall mount docking station can be installed using the four tapped holes in the mounting plate. Refer to the latest revision of the TPS-6X-DSW Operations and Installation Guide (Doc. 6708) for details. Refer also to the comprehensive illustration on the following page. 8 • Trim Ri
Resumen del contenido incluido en la página 13
Crestron TMK/WMKT-6X-DSW Trim Ring Mount Kits for the TPS-6X-DSW TPS-6X-DSW Mounting Using WMKT-6X-DSW – Exploded View MOUNTING PLATE DRYWALL (2022811 ) TRIM RING (2022808 ) TPS-6X-DSW SCREWS (4) #06-32 1 1/2" PAN HEAD (2007254 ) Installation Guide – DOC. 6780A Trim Ring Mount Kits for the TPS-6X-DSW: TMK/WMKT-6X-DSW • 9
Resumen del contenido incluido en la página 14
Trim Ring Mount Kits for the TPS-6X-DSW Crestron TMK/WMKT-6X-DSW Resources Industry Compliance As of the date of manufacture, the TMK-6X-DSW and WMKT-6X-DSW have been tested and found to comply with specifications for CE marking. Reference Documents The latest version of all documents mentioned within the guide can be obtained from the Crestron website (www.crestron.com/manuals). This link will provide a list of product manuals arranged in alphabetical order by model number. List of R
Resumen del contenido incluido en la página 15
Crestron TMK/WMKT-6X-DSW Trim Ring Mount Kits for the TPS-6X-DSW Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the p
Resumen del contenido incluido en la página 16
Crestron Electronics, Inc. Installation Guide – DOC. 6780A 15 Volvo Drive Rockleigh, NJ 07647 (2023088) Tel: 888.CRESTRON 01.09 Fax: 201.767.7576 Specifications subject to www.crestron.com change without notice.
