Resumen del contenido incluido en la página 1
Panasonic,
Ope rating
Instructions
Commercial Microwave
Oven
Model
NE-1064
r[--l]-.Tal
f l--il
l-il
t rn-rrFrd
l I
r 'd.tr4.
J
G*l
L=l
t'l
l.mru;l
lffil
L_!:lJ
t"^|'l
t_i_J
f-";l
L"::J
Before operating this oven, please
read these instructions completely.
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS PRECAUTIONS TO AVOID POSSIBLE EXPOSUFIE TO EXCESSIVE MICROWAVE ENERGY..... .......3 IMPORTANT SAFETY INSTRUCTIONS ..... ............3 lnstallation and Grounding Instructions.. ............4 How Does the Microwave Work? ............s Safety Statements..... .......6 Outline Diagram .........7 How to Operate Before Operating ........9 Heating A. Manual Single Stage Heating .........9 B. Manual 2 or 3 Stage Heating.... .............9 C. Programmed Heatin9........
Resumen del contenido incluido en la página 3
IM PORTANT $AFETY INSTRUCTIONS Your nricrowave oven is a cooking device and you should use as much you care as use with a stove or any other cooking device. When using this electric appliance, basic safety precautions should be followed, including the following: WARNING-ro reduce the risk of burns. etectric 9. This oven should be serviced qualified only by shock, fire, injury persons to or exposure to seryice personnel. Contact the nearest excessive microwave energy: authorized
Resumen del contenido incluido en la página 4
Examine Your Oven Wiring Requirements packing Unpack oven, remove all material, and examine the plugged 1 . The oven must be into at least a 15 AMP 120 oven for any damage such as dents, broken door latches or VOLT,60 Hz GROUNDED OUTLET. cracks in the door. Notify dealer immediately if oven is Where a standard two-prong is outlet encountered, it is the damaged. DO NOT install if oven is damaged. personal responsibility and obligation of have it the user to replaced with properly grounded a
Resumen del contenido incluido en la página 5
HoW'D6s$'Vffi# Microwaves are a form of high frequency radio Absorption waves similar to those used by a radio including During heating, microwaves AM, FM and CB. They will be absorbed by are, however, much shorter 3/olo food. They penetrate than radio waves; to a depth of about 1ll approximately five inches long. inches. Microwave Electricity is converted energy excites the molecules in into microwave energy by the food (especially the magnetron tube. water, fat and sugar From the mag
Resumen del contenido incluido en la página 6
Safety $tatement$ :. : L. : General Use Food 1, Do NOT tamper with or make any adjustments or 1. HEATING TIMES given in the cooking guide repairs to door, control panelhousing, safety are APPROXIMATE. Factors that may affect interlock switches or any part other of the oven. heating are: starting temperature, altitude, Do NOT remove outer panelfrom oven. Repairs volume, size, and shape of foods and utensils should only be done qualified person. by a service you used. As become fam
Resumen del contenido incluido en la página 7
Outline ftiagram (1) (see Digital Display Window below) (2) Memory Pads (3) Power LevelSelector Pad (4) Stop/Reset Time Pad (5) (x Double Quantity Pad 2) (6) Start Pad (7) ControlPanel (8) Door Safety Lock System (9) Oven Window (10) Oven Lamp (11) Splash Guard/Light Diffuser Digital Display Window Indicator Locations E E HI M.HI MED LOW DEF HOLD POWER LEVEL - E Power Level lndicator Hr(HIGH) - A Program Change Indicator HIGH) M. Hr(MEDIUM - (MEDIUM) B Double (x2) MED Quantity Heati
Resumen del contenido incluido en la página 8
How to Operate Before Operating Make sure the oven is connected to properly a grounded electrical outlet. When the door is closed, the display is still blank. When the door is opened, the display shows,,0',. For the detail operation, see the page on each feature. This preset oven is at the factory for the following: 1. Memory Pads preset to High Power at the indicated heating times for single stage heating. - - 1 10 sec. 6 1 min. 30 sec. - -2min. 2 20 sec. 7 - - 3 30 se
Resumen del contenido incluido en la página 9
i;,;:i1t'2'g' How to Operate HEATING "0" Open the door and place food in the oven cavity. Close the door. must be showing in the display window. A. Manual Single Stage Heating: This feature gives the user maximum flexibility to set the oven to desired heatingtime and power level. ldeal for menus that require various heating requirements. Example: To heat for 2 minutes at High Power Display Window .Press the Power Level Selector Pad one time. tl 2 .Press the Memory Pads 2, 0 and 0. [
Resumen del contenido incluido en la página 10
How to Operate C. Programmed Heating: Example: 1 stage; MemoryFad power 9 to heat for 3 minutes at HIGH Display Window 1. .Press the Memory Pad [Ej' Tl_l 9. In Program Lock Mode oven will start without pressing START Pad. page See 14. ,@ 'Press the START Pad. Heating willstart. The time on digitat display will count down. 3. Beep tone willsound. 'Allheating willstop. (See page 16) When opening the door, the display willstop blinking. Example: 2 stage; Memory Pad 3 (to he
Resumen del contenido incluido en la página 11
How to Operate C. Programmed Heating: Example: 1 stage; MemoryFad 9 to power heat for 3 minutes at HIGH 1. .Press the Memory Pad [Ej'T]-l 9. In Program Lock Mode oven will start without pressing START Pad. page See 14. ,@ .Press the START Pad. Heating willstart. The time on digital disptay will count down. i 3. Beep tone will sound. 'Allheating willstop. (See page 16) When opening the door, the display willstop blinking. Example: 2_stage; Memory Pad (to 3 heat for 3 minut
Resumen del contenido incluido en la página 12
Prograrnming Display Window - _ DO NOT OPEN THE DOOR The display window MYIT be blank before programming can begin. tf any indicator light is illuminated [_--l in the digital Display Window: closeihe door]press pad sioplneber ani wait 1 minute until the Display goes blank. A. Memory for Singte Stage Heatins: lads lltg1ST1llg Exampte: To program power 30 seconds pad at Medium for Nfemory Number 5 '@ .Press the PROG Pad. 'NOTE: .lf no PROG lndicator appeared "Program
Resumen del contenido incluido en la página 13
How to Operate ..,::... 'Program NOTE: the remaining Memory Pads as desired by repeating steps 1-5. You may insert up to 10 memory Programs. 'When the PROG indicator pad is blinking, the program can be cancelled and/or the erased by pressing the STOP/RESET Pad. B. Programming Memory Pads lor 2 or 3 Stage Heating: Example: To program pad for 2 minutes at DEFROST for 2 stage heating using Memory Number 5 Display Window r, 1. page Complete Steps 1 to 4 on 1 1 _j!6 I I .f n I JU
Resumen del contenido incluido en la página 14
How to Opeiab C' Programming - the Double Quantity Pad For multiple portion heating: Your oven is factory set to automatically programmed double the - time for multiple portion heating this is the correct setting for heatin_g multiple portions of most small foods items. No furthbr programming of the time is necessary for these food items. The time required to heat multiple portions of some large platters and most bulk food loads is slighily less ' than double that of a single
Resumen del contenido incluido en la página 15
How to Operate Other Features A. To Activate Program Lock: "Locks"lhe This procedure controlpanelMemory Pads into their programmed heating times power ano levels. Do Nor OPEN THE DooR. The Display window must be btink before the Oisolay Window Program Lock feature can be activated. ll '@ .Press pad and hold in the PROG "P" "L". until the display shows and (for 6 seconds) .Program Lock feature is now activated. Fn-r - [' | 'Do NoTE: press PROG Pad for longer than 30 secon
Resumen del contenido incluido en la página 16
How to Operate C. To Read Program List: Allows you to review all currently programmed Pad Number, heating power time and level for each stage. 1. Open the door. Display Window f---- n I sTot) f 2. .While pressing the STOP/RESET Pad, ul I press and hold UESETJ in the START Pad. The Bgep Tone setting will show in the + display window. Example: Stage Indicator 1: Beep tone is ON Stage.Indicator 2: Beep tone is OFF. 1y''*,J 2 seconds later, the Program Lock setting will show in the
Resumen del contenido incluido en la página 17
How to Operate D. To Select Beep Tone Options: The Beep Tone can be set, ON or OFF. Window Display 1. Open the door. i---- nl ul I '@ .Press the PROG Pad. The displav will not change. f- nl ul I 3' .Press pad. the Memory m'll_l "OFF" .Repeat pressing of O Pad. Select trFTFl of Beep Tone. Stagelndicatorl =ON oM2 r....".-...---) Stagelndicator2=OFF lbrrP I .@ .Press you the PROG Pad again. have completed programming the beep tone. t,"l-' tr "0" .2 seconds later, will
Resumen del contenido incluido en la página 18
$elf Diagnostics Failure Code Explanation This oven monitors its operation problem and displays a Failure Code in the display window when a occurs. What to do when a failure code appears: CODE CAUSE WHAT TO DO *Overcooked *Press F01 food STOP/RESET Pad to stop beep. .Temperature -Unplug of exhaust air too high. oven and wait at least 30 minutes before reconnecting. -Wait for oven to cool down and reset. -lf present, a flame is do not open oven door. "lf normal operation does not resume
Resumen del contenido incluido en la página 19
Notes -18-
Resumen del contenido incluido en la página 20
Technical $pecifications NE-1064 Power Source 120V, phase 60 Hz, single Required Power 13.4 A 1500 w Output' 1000 w Frequency 2,450 MHz Outer Dimensions 12" x20%" x 14%" (HxWxD) (306mmx51Ommx360mm) Cavity Dimensions 8%o" x'13" x 13" (HxWxD) (205mmx33Ommx330mm) Net Weight Approx. 37 lbs. (16.8 kg) Shipping Weight Approx. 42 (19.0 lbs. kg) Timer 99 min (Digital) 99 sec x 10 Memory Pads with Doubte Quantity (x2) Pad' 'lEC 705-88 Test Procedure Specifications subject to change without not
