Resumen del contenido incluido en la página 1
Panasonic,
Operati ng I nstructions
Commercial Microwave Ovens
NE-1054
Models
NB-1024
please read these instructions completely.
Before operating this oven,
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MlcRowAVE ENERGY............. ........s IMPOBTANT SAFETY INSTRUCTIONS ...................3 lnstallation and Grounding Instructions ........4 Safety Precautions.,.......... ....................5 How Does the Microwave Work? .........6 Outline Diagram (NE-f024) .......7 How (NE-f024)... to Operate .. .. ... .............7 Outline Diagram (Nn-tOS+; .....,............8 (NB-fOSl) How to Operate , Before Operating .....
Resumen del contenido incluido en la página 3
Your mtcrowave oven is a cooking devtce you and should Lrse as much care as you use with a stove or any other cooking device When using this electric appliance, basic safety precautions 9. Do not allow children to use this appliance, unless closely should be followed, including the following: supervised by an adult. .10. Do not operate this appliance if it has a damaged cord or WA R N I N G-ro reduce the risk of burns, erecrrc plug, if it is not working properly, or if it has been
Resumen del contenido incluido en la página 4
Examine Your Oven Wiring Requirements Unpack remove packing oven, all material, and examine the The plugged 1. oven must be into at least a 15 AMP 120 for oven any damage such as dents, broken door latches or VOLT, 60 Hz GROUNDED OUTLET. cracks in the door. Notify dealer immediately if oven is Where a standard two-prong outlet is encountered, it is the damaged. DO NOT install if oven is damaged. personal responsibility and obligation of the user to have it replaced with a properly grounded t
Resumen del contenido incluido en la página 5
-A Safety Precautions General Use Food 1. DO NOT tamper with or make any adjustments or repairs to 1. It is betteT to UNDERHEAT RATHER THAN OVERHEAT panel door, control housing, safety interlock switches or foods. lf food is any underheated, rt can always be returned to other part of the oven. Do NOT remove outer panel from the oven for further heating. lf food is overheated, nothing oven. Repairs should only be done qualified by a service can be done. Always start with minimum heating times
Resumen del contenido incluido en la página 6
How Does The Microwave Work? t):::1.)t::l:t:.1:.tt:: Microwaves are a form of high frequency radio waves similar Absorption to those used by a radio including AM; FM and CB. They are, During heating, microwaves will be absorbed by food. They however, much shorter than radio waves; approximately five 3/, penetrate to a depth of about to 1'lz-inches. Microwave inches long. Electricity is converted into microwave energy by energy excites the molecules in the food (especially water, fat the
Resumen del contenido incluido en la página 7
Control Panel ffi "0' Return diel to it tmd is removed betore end ol cook cyclc COOKING TIMES izi 1 noI 1t4 I oi h.ry l-t? e lrl 1 Hot Oog bS e I So.llSmtuid SSe - I L.rg.setui.h l:& 2:O - lb'Jl I hrmtuO.. r:m 2:m 18srtu.Fu.n l:U-l:S l5l (Sb) - I Cup ol tuu, r:I 2:0 tJ I C.sd. !:I-2:S - I Cup ot Wrb. 2:n 2:15 Cro) o Timer @ Oven Window @ Gontrol Panel @ Oven Lamp @ Door Safety Lock System @ Splash GuarcULight Diff user 1 . plugged Make sure unit is into a three-prong grounded 120 V 6. W
Resumen del contenido incluido en la página 8
::::::;:;:iii;:;:iti::;; NE-l0s1 Control Panel (1) Digital Display Window (see below) (21 Memory Pads (3) Power level Selector Pad (4) PROG. Pad (s) STOP/RESET Pad (6) DOUBLE QUANTIW (x 2) Pad PRESET METIU START Pad n (8) Control Panel @Er;}esl (e) Door Safety Lock System Etr;lE..=,;-l (10)Oven Window with HeaWapor Film E':--;l trrl'";l (Do Not Remove) (11) Orrcn Lamp Er=;l EF;,"n (12) Splash Guard/Light Difluser Ir I {rn I EOq',".l IIANUAL OPERATION tr I lr-t l tzl L_1 (1 1) Digital
Resumen del contenido incluido en la página 9
How to Operate Before Operating Make sure is properly grounded the oven connected to a electrical outlet. "0". When the door is closed, the Display Window is still blank. When the door is opened, the Display Window shows For the detail operation, see the page on each feature. This oven is preset at the factory for the following: preset 1. Memory Pads are to High Power for the indicated heating times for single stage heating. - - 1 10 sec. 6 1 min. 30 sec. - -2min. 2 20 sec. 7 - - 3 30 se
Resumen del contenido incluido en la página 10
"0" Open the door and place food in the oven cavity. Close the door. must be showing ln the Display window. A. Single Stage Heating: $g1ual This.feature gives the usei maximum tteliuitity to set the oven to desired heating time and power level. ldeal for menus that require various heating requirements. Example: To power heat for 2 minutes at High Display Window 1. .Press the POWER Level Selector f-trr; IPowER I Pad one time. t-l t-l -Ti- .Press the Memory Pads 2, 0 and 0. [4
Resumen del contenido incluido en la página 11
How to Operate C. Programmed Heating: g power Example: 1 stage; Memory Pad to heat for 3 minutes at HIGH Display Window 1. .Press the Memory Pad 9. /Pffil . In Program Lock Mode oven will iq I pressing start without START l-l page Pad. See 15. ,@ .Press the START Pad. Heating will start. The time in the Display Window will count down. trq .All 3. Beep tone will sound heating will stop. f-n.-l When opening the door, the display l"l willstop blinking. t I zi Example: 2 stage; Mem
Resumen del contenido incluido en la página 12
Programming Display Window _ _ DO NOT OPEN THE DOOR The Display Window MUST programming be blank before can begin. lf any indicator light is illuminated in the digital press tl Display Window: Close the door, STOP/RESET Pad and wait 1 IJ minute goes until the Display Window blank. A. Programming Memory Pads for Single Stage Heating: Example: To program 30 seconds at Medium Power for Memory Pad Number 5 Display Window .Press the PROG. Pad. __*_:pe__ NOTE: .lf no PROG Indicator appeared in
Resumen del contenido incluido en la página 13
.:.:.::::::: ,:,, ... ..:. ,,,.,:..r, HOW tO Operate 'Program NOTE: the remaining Memory Pads programs. as desired by repeating 1-5. steps You may insert up to 10 memory 'When the PBOG indicator is blinking, the program can be cancelled and/or the Pad erased by pressing the STOP/RESET Pad. B. Programming Memory Pads lor 2 or 3 Stage Heating: Example; program To for 2 minutes at DEFROST for 2 stage heating using Memory Pad Number 5 Display Window Pffi! 1. Complete Steps 1 to 4
Resumen del contenido incluido en la página 14
:i .::.1. i:I :'l l ::::::::: - Programming c. the Double Quantity Pad For multiple portion heating: Your oven is factory set to automatically - double lhe programmed time for multiple portion heating this is the correct setting portions for heating multiple of most small foods items. No further programming of the time is nelessary for these food ilems. The time required to heat multiple portions of some large platters and most bulk food loads is slightly less than double that of a
Resumen del contenido incluido en la página 15
How to Operate Other Features To A. Activate Program Lock: Display Window "Locks" procedure This the control panel programmed Memory Pads into their heating power times and levels. DO NOT OPEN THE DOOR. The Display Window musl be r------l blank before the Program Lock feature can be activated. it .Press '@ and hold in PROG. Pad the until the display shows "P" "L". (for and 6 seconds) .Program Lock feature is now -l activated. ttr=*- , L l, I z 'Do NOTE: not press PROG. Pad for lo
Resumen del contenido incluido en la página 16
How to Operate To Read C. Program List: Allows you to review all currently programmed Pad Number, heating power time and level for each stage. Display Window 1. Open -l the door. l------n L'J I .While pressing the STOP/RESET Pad, press and hold in the START Pad. The Beep Tone setting will show in the + Display Window. [bFrFl Example: Stage Indicator 1: Beep tone is ON G;;'l Stage Indicator 2: Beep tone is OFF 2 seconds later, the Program Lock PBM ?i r--) rtf) | setting will show
Resumen del contenido incluido en la página 17
How to Operate D. To Select Beep Tone Options: Display Window The Beep Tone can be set, ON or OFF. [------r,l 't. Open L'l the door I .Press 2. the PROG. Pad. t-----,? I The display will not change. L'l I @ .Press 3. the Memory Pad 0. m "OFF" ET-PI .Repeat pressing of 0 Pad. Select ol Beep Tone. PRM 2 El;I l-.:-----=-.1 Stagelndicatorl=ON izt I \l i Stagelndicator2=OFF I I lbrrP l('|i .Press 4. l.tri the PROG. Pad again. You have completed programming beep the tone. @ ELA .2 seconds
Resumen del contenido incluido en la página 18
Self Diagnostics Failure Gode Explanation This oven monitors its operalion and displays a Failure Code in the Display Window when probrem a occurs. What to do when a failure code appears: CODE CAUSE WHAT TO DO .Overcooked -Press F01 food STOP/RESET Pad to stop beep. .Temperature *Wait of exhaust air too high. for oven to cool down and reset. -lf a flame is present, not do open oven door. "lf normal operation does not resume, call the service aoent with information of failure c
Resumen del contenido incluido en la página 19
Tech n ieal Specifications NE-r024 NE-r0s4 Power Source 60 Hz, single phase 120V, Reouired Power n 1500w 13.4 Output. 1000 w Frequency 2,450 MHz Outer Dimensions 12" x20'1"" x14'/"" (HxWxD) x mm 306 mm x 5l0 mm 360 Cavity Dimensions 8'/,e" x 13" x 13" (HxWxD) 205 mm x 330 mm x 330 mm Net Weight Approximately 34 lb (15.4 kg) Shipping Weighl Approximately 39 lbs (17.7 kg) Timer 99 min 99 sec (Digital) 5 minules Rotary x'l 0 Memory Pads with Double Quantity (x2) Pad -lEC 705-88 Test Procedur
Resumen del contenido incluido en la página 20
COMPANY PANASONIC CONSUMER ELECTONIC OF MATSUSHITA COMPANY, DIVISION ELECTRIC CORPORAT]ON OF AMERICA One Panasonic Way, 4A-4, Secaucus, NJ 07094 T00036P00AP , (2011348-5377 Printed in Taiwan
