Manual de instrucciones de Revolabs Inc.75

Resumen del contenido incluido en la página 1

Revolabs Single Channel Wireless Microphone System- Tandberg Edge
75/85/95 MXP Setup Guide
NOTES AND CAUTIONS:


This setup guide will guide you through the step needed to properly connect a Revolabs
Single Channel System to a Tandberg Edge 75/85/95 MXP video codec.

1. Connecting the Cables
2. Configuring the Edge MXP Video Codec

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not

Resumen del contenido incluido en la página 2

Connecting the Cables CONNECTING A REVOLABS SINGLE CHANNEL SYSTEM TO TANDBERG EDGE 75/85/95 MXP VIDEO CODEC 1. Connect the 07-STEMIC-PPP cable between the 2.5mm analog output of the Revolabs Single Channel to the MIC 1 input of the Tandberg Edge 75/85/95 MXP

Resumen del contenido incluido en la página 3

Configuring the Edge 75/85/95 MXP Video Codec CONFIGURING THE AUDIO MENUS OF THE EDGE MXP VIDEO CODEC 1. Go to AUDIO SETTINGS 2. Select INPUTS 3. Confirm that MIC 1 is ON 4. Adjust the audio Input Type Level if necessary (recommend +8dB) 5. Speak into the Revolabs microphones that are connected to MIC 1. The audio meter should peak at about 5dB for normal speech.

Resumen del contenido incluido en la página 4

6. Return to previous menu and select ECHO CONTROL 7. Enable MIC 1 Echo Canceller (ON) 8. Return to previous menu and select AUDIO LEVELING (AGC) 9. Turn MIC Audio Leveling (AGC) OFF