Manual de instrucciones de Milwaukee ToolsPH51

Resumen del contenido incluido en la página 1

BATTERY REPLACEMENT:
pH51 is supplied with BEPS (Battery Error Pre-venting
System) which avoids any erroneous reading due to low
battery level, by switching the meter off. To replace the
batteries unscrew the battery compartment cap and replace all
three 1.5V batteries while paying attention to their polarity.

Make sure the gasket is in place before screwing back the cap.
PH51 WATERPROOF METER
Batteries should only be replaced in a nonhazardous area using
OPERATORS MANUAL
the bat

Resumen del contenido incluido en la página 2

#1: CONDITIONING OF THE PH51: #3: OPERATION OF THE PH51: THIS MUST BE DONE PRIOR TO • Remove the unit from your storage container cup or jar CALIBRATION & USE OF THIS UNIT ( Remember to always store the probe wet ) Remove the cap from the end of the unit and immerse the pH51 probe into a cup or jar with 1” to 1.5” inches • Turn the pH51 on by pressing the ON key. of Bottle Drinking water, or 4.01 calibration solution, or MA9015 storage solution for a minimum of 2 to 4