Resumen del contenido incluido en la página 1
GAMEBIKE FITNESS PRO™
RECUMBENT BIKE
Operation Manual
Model GB-300R
Thank you for purchasing the CATEYE GAMEBIKE FITNESS PRO RECUMBENT BIKE.
Please read the manual carefully before using this product. Safeguard the manual along with the warranty card.
Symbols Legend
Symbol marks used for safety precautions in this manual
The descriptions accompanying the following symbol marks in this manual refer to very important issues in terms of your safety and handling of
the unit. You are strongly urged t
Resumen del contenido incluido en la página 2
Cautions • While not in use, please to unplug the connection cord from connection terminal. • If any abnormal operating conditions of either the device itself or manifest themselves, stop using the equipment immediately and contact the shop where you purchased the equipment for repair. • This device is heavy, be careful when lifting and carrying it and avoid dropping it. • To plug/unplug the connection cord, be sure to hold the connector itself rather than the cord; do not pull the connector exc
Resumen del contenido incluido en la página 3
How to assemble GBF PRO RECUMBENT BIKE (1) Follow the procedure below to assemble the product. 3 Installing the steering unit • Insert the steering unit in the steering post and securely tighten 3 4 5 Brake button the “steering unit installation screw set” (4 screws). 7 Steering unit 6 11 Steering unit 2 installation screw 10 Flat washer 9 4 Installing the controller bracket 12 • Remove the M5 screws (X4) from the back of the controller unit. • Secure the controller bracket to the controller wi
Resumen del contenido incluido en la página 4
How to assemble GBF PRO RECUMBENT BIKE (2) 7 Installing the console 10 Installing the seat handle • Remove the 4 screws on the back of the console. • Place the seat handle in position on the rear of the seat base and securely tighten the “seat handle installation screw set” (2 screws). • Insert the cable connector which extends from the bracket into the cable inlet on the back of the console. Caution Make sure to install the seat handle with the ends Caution Insert the cable connector firmly as
Resumen del contenido incluido en la página 5
Adjusting the Components Before using the product, follow the procedure below and adjust the components. • Adjusting the leg adjusters • Moving the seat forward/backward • If the main unit is unstable on the floor, use the adjusters of the • Raise the seat slide adjustment lever to slide the seat forward/ rear leg to stabilize the unit. backward when sitting on the seat. With the seat at the desired position, release the lever and slightly move the seat. The position of the seat is now fixed. Ca
Resumen del contenido incluido en la página 6
Connecting the device to Playstation2 This controller is compatible with the “Playstation2”. Plug the connector of this device into the controller terminal located at the front of the “Playstation2”. Consult the operating manual of the “Playstation2” unit, if necessary. “Playstation2” unit Important: If the GBF PRO RECUMBENT BIKE does not operate after connecting it to the PlayStation2 unit, disconnect it and Controller connector reconnect it again. Reference: It is possible for two players to p
Resumen del contenido incluido en la página 7
GBF PRO RECUMBENT BIKE Console 1 5 3 2 4 6 1 Liquid crystal display 4 - button (Reset button) When pressed for three seconds, resets all data except for the 2 SELECT button (Speed Unit switch button) upper and lower heart rate limits and age. Moves the condition setting to the next item. 5 PROGRAM button Switches the speed unit. Switches the program. 3 + button 6 WATT / CALORIE button Used to increase values and load level. Switches the indication between calorie consumption and watts. 8 9 0 q w
Resumen del contenido incluido en la página 8
Mounting Batteries Open the battery cover, and mount four LR-20 (D) batteries. Watch the orienta- tion of the plus and minus poles. When they are mounted, the buzzer sounds, and all data is cleared automatically. Caution If the buzzer does not sound, the orientation of the batteries may not be correct. Check the orientation, and mount the batteries again. Changing batteries When the batteries are low, the mark lights up. When the mark lights up, change the batteries before they become exhauste
Resumen del contenido incluido en la página 9
Training with Targets Training with Targets You can specify targets for exercise time, distance and calorie consumption to set up the train- ing suitable for you. When you reach each of the target values, the buzzer sounds to notify you. After that the values start counting up. Important: In order to exercise in the HR control modes (P-7 to P-11), you need the optional chest belt heart rate sensor (the sensor by Polar can also be used). Reference: When the button is pressed, the setting screen
Resumen del contenido incluido en la página 10
How to Select a Program You can switch the exercise program in sequence during training by pressing the button. 1. Manual (P-1) • This is the most common program. You set the load level by pressing the and buttons. P-1 : Manual • You can exercise at the constant load level. 2. Program modes (P-2 to P-6) • You can view the profile of the changes in the selected load levels by pressing the button. P-2 : Fatburning • You can change the load levels of the profile by pressing the or button. P-3
Resumen del contenido incluido en la página 11
Troubleshooting The following situations are not actual malfunctions. Analyse such cases before requesting a repair. If trouble occurs, first reset the game, if the trouble continues. Please contact the service center. Problem Check items Countermeasures Steering response is slow compared to the Has the steering sensitivity been adjusted See “How to adjust the controller” and increase the steer- actual steering operation. properly? ing sensitivity. Steering response is extreme compared to Is the
Resumen del contenido incluido en la página 12
Specifications Product specifications Use Game controller for household use and for commercial use Compatible gaming devices Same as the controller included Power source / battery life LR-20 (D) (UM-1) x 4 / Approx. 4 months (Using Alkaline batteries, battery life is about 6 hours of use per day.) Display functions Function Display range Exercise Time 0:00 to 99:59 Current speed 0.0 to 99.9 km/h (Mile/h) Trip distance 0.0 to 99.9 km (Mile) Heart rate 30 to 240 bpm Calories consumption 0.0 to 999
Resumen del contenido incluido en la página 13
™ 13 JP
Resumen del contenido incluido en la página 14
1 y s 2 u 3 i 4 5 d 6 o f 7 g 8 h 9 j 0 p q w e a r t 1 78 4 6 2 3 5 9 qw e r y u t 0 h j io p a s f g d 14 JP
Resumen del contenido incluido en la página 15
3 4 5 3 7 6 11 2 10 9 4 12 1 1 5 2 6 15 JP
Resumen del contenido incluido en la página 16
7 10 11 8 9 12 16 JP
Resumen del contenido incluido en la página 17
L R STEERING LEVEL SPEED LEVEL SELECT START ANALOG 17 JP
Resumen del contenido incluido en la página 18
L R STEERING LEVEL SPEED LEVEL SELECT START ANALOG STEERING LEVEL L R STEERING LEVEL SPEED LEVEL SELECT START ANALOG SPEED LEVEL 18 JP
Resumen del contenido incluido en la página 19
1 5 3 2 4 6 1 4 2 3 5 8 9 0 q w e r 7 q t u y 6 w 7 8 e 9 r 0 t q y u 19 JP
Resumen del contenido incluido en la página 20
1 2 1 3 4 2 3 4 20 JP
