Resumen del contenido incluido en la página 1
OPERATOR’S
MANUAL
Turboless Triple Catcher
Turboless Triple Catcher
Mfg. No. Description
1695354 44” & 50” Turboless Triple Catcher
C CA AU UT TIIO ON N:: R Re ea ad d a an nd d
ffo ollllo ow w a allll iin ns sttr ru uc cttiio on ns s..
Manual Part No. 1734740
Revision 01
Rev. Date 05/2007
TP 100-4527-01-AT-SMAN
Resumen del contenido incluido en la página 2
SAVE THESE INSTRUCTIONS READ THE MANUAL The operator’s manual contains important safety information you need to be aware of BEFORE you operate your unit as well as DURING operation. Safe operating techniques, an explanation of the product’s features and controls, and maintenance information is included to help you get the most out of your equipment investment. Failure to obey the safety rules could result in loss of control of the unit, sever personal injury or death to you, or bystanders, or da
Resumen del contenido incluido en la página 3
Normal Removal Operatror Safety Assembly & Installation Table of Contents Operator Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Operator Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Decals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Mowing with the Catcher. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Resumen del contenido incluido en la página 4
GENERAL WARNINGS • Know the unit’s controls and how to stop quickly. periodically for tears, holes, or weak spots and READ THE OPERATOR’S MANUALS. replace with a new bag that meets manufacturer’s � Read and obey all safety decals. durability standards. � Only allow responsible adults, who are familiar with � If the mower stalls or the collector chute plugs: the instructions, to operate the unit. 1. Disengage the PTO; � Disengage the PTO. Shut off the engine and wait 2. Stop the engine and remove
Resumen del contenido incluido en la página 5
Safety Before Operation Clear the lawn of all sticks, stones, wire and other debris which may be caught or thrown by the mower blades. Check grass condition. If wet, wait until later in the day. If grass is wet, the grass catcher is likely to become plugged. For efficient bagging, air circulation under the mower deck, through the chute and into the bag is very important. For this reason, BEFORE YOU BEGIN MOWING you should make certain the underside of the mower and the underside of the catcher l
Resumen del contenido incluido en la página 6
4 Safety
Resumen del contenido incluido en la página 7
Assembly Assembly INSTALL MOUNTING PLATES - A B C BROADMOOR / 1600 / 2600 / LT SERIES D Install Plates & Spacers 1. Mount the side brackets (C, Figure 1) to both sides of the frame using the holes shown. Secure with one 3/8-16 x 1 capscrew (D), 3/8 lockwasher (B), and 3/8-16 nut (A) per side. Figure 1. Install Side Brackets 2. Install the rear spacers (C, Figure 2). Secure with A. Nut, 3/8-16 two 1/2-13 x 2-1/2 capscrews (E), washers (D), B. Lockwasher, 3/8 spacers (C), and 1/2-13 nylock nuts (A
Resumen del contenido incluido en la página 8
Remove Blowout Baffle Install Baffles 1.Remove and discard short blowout baffle (C, Figure 1. Determine which baffle to use. See Figure 5 4), carriage bolts (B) and locknuts (D) from mower Chart. deck (A). 2. Lift side discharge chute (H, Figure 6). 3. Insert baffle (F) through discharge opening and position baffle into place. 4. Tighten carriage bolts (A) and nuts (E) on baffle (F). 5. Tighten carriage bolt (B) and nut (E) on baffle (F). B 6. Position baffle (G) into place. D 7. Tighten carria
Resumen del contenido incluido en la página 9
Assembly H E A A. Carriage Bolts, 5/16-18 x 5/8 E B. Carriage Bolt, E 5/16-18 x 5/8 C. Carriage Bolts, C F 5/16-18 x 5/8 D. Carriage Bolts, E B D 5/16-18 x 5/8 E E. Locknut, 5/16-18 F. Right Hand Baffle G. Left Hand Baffle G H. Discharge Chute Figure 6. Install Baffles 7
Resumen del contenido incluido en la página 10
INSTALL LOWER CHUTE ROD AND PIN TO BOOT Install Components 1. Insert the head of pin (A, Figure 8) through front INSTALL MOUNTING PLATE hole of lower chute (D). Secure with 1/4-20 x 5/8 1. Install mounting plate (A, Figure 7) to mower deck carriage bolt (B) and 1/4-20 lock nut (C) as as shown. Secure with 5/16-18 x 5/8 carriage shown. bolts (C) and 5/16-18 locknuts (A). 2. Install the rod (H) to lower chute (D) using 5/16-18 x 1 capscrew (J) and 5/16-18 locknut (G) for front holes. Use 5/16-18 x
Resumen del contenido incluido en la página 11
Assembly INSTALL HANDLE TO TUBE 1. Install handle (A, Figure 9) using 1/4-20 x 1/2 screw and 1/4-20 locknut (B) for rear hole. Use 1/4-20 x 1 screw (D) as shown. Tighten hardware. 2. Install strap (E) to screw (D) securing with 1/4-20 locknut (F). F B A E C B D Figure 9. Install Handle to Tube A. Handle B. Locknuts, KEPS, 1/4-20 C. Screw, Slotted, 1/4-20 x 1/2 D. Screw, Slotted, 1/4-20 x 1 E. Strap, Rubber F. Locknut, Center Lock, 1/4-20 9
Resumen del contenido incluido en la página 12
INSTALL BAG AND COVER SUPPORT INSTALL COVER ASSEMBLY 1. Install the bag and cover support (B, Figure 10) to 1. Attach cover assembly (B, Figure 12) to bag upright support (A) using reinforcement plate (C) support bracket (A) using hinge pivots (E). Secure and 3/8-16 x 1 capscrews (D) and 3/8-16 locknuts cover using cover hinge pins (C) and hair pins (D) (E) as shown. as shown. B B E C D E D A A C D E C Figure 10. Install Bag and Cover Support Figure 12. Install Cover Assembly A. Upright Support
Resumen del contenido incluido en la página 13
Assembly INSTALL COLLECTOR BAGS INSTALL LOWER DISCHARGE CHUTE 1. Raise the cover (A, Figure 13). 1.Lift discharge deflector up (D, Figure 14). 2. Attach collector bags (B) using grass bag hanger 2. Insert lower chute rod (A) into mounting plate (B). (C) to bag hanger post (D). 3. Pull rubber strap (C) and secure by placing hole closest to knob in strap completely over locknut (E). A C D C E D A B B Figure 13. Install Collector Bags Figure 14. Install Lower Discharge Chute A. Cover A. Lower Chut
Resumen del contenido incluido en la página 14
44” Frame Hung Mowers 50” Frame Hung Mowers 44” Free Floating Mowers D 50” Free Floating Mowers C E D F B B A C Figure 15. Install Upper Tube to Cover A. Upper Tube B. Cover C. Ridge, Upper Tube A D. Ridge Cutout INSTALLING UPPER & MIDDLE TUBES Figure 16. Install Middle Tube A. Lower Chute 1. Slide the upper tube (E, Figure 15) into cover (B) B. Strap, Rubber aligning ridge (C) with cutout (D) as shown. C. Pin 2. See Figure 16 for correct hole location and secure D. Middle Tube the upper tube (E
Resumen del contenido incluido en la página 15
Assembly 13
Resumen del contenido incluido en la página 16
Normal Removal & Installation E F R Q D C D G A B C S P H O S A. Hitch Support Assembly N J I B. Cover K. Nut & Capscrew C. Pin L. Mounting plate K D. Hair Pins M. Lower Chute Rod E. Bag N. Lower Chute F. Grass Bag Hanger O. Pin M G. Upper Tube P. Strap, Middle H. Middle Tube Q. Ridge L I. Strap, Boot R. Ridge Cutout J. Deflector S. Rear Spacers Figure 17. Normal Installation & Removal 4. Lift discharge deflector (J) up. Insert lower chute Normal Removal & Installation rod (M) into mounting plat
Resumen del contenido incluido en la página 17
Normal Removal & Installation Collector Removal WARNING OPERATION WITHOUT BAGGER For operation without bagger, the mower deflector MUST be properly installed in the down position and retained by the spring latch. 1. Unhook strap (P, Figure 17) from pin (O). Slide middle tube (H) into upper tube (G) and remove middle tube (H). Remove upper tube (G) from cover (B). 2. Lift up cover (B) remove and empty bags (E). 3. Unhook strap (I) from locknut and capscrew (K). Remove lower chute (N) from mountin
Resumen del contenido incluido en la página 18
MANUFACTURING, INC. PRODUCTS 500 N Spring Street / PO Box 997 535 Macon Street Port Washington, WI 53074-0997 McDonough, GA 30253 www.SimplicityMfg.com www.Snapper.com 500 N Spring Street / PO Box 997 500 N Spring Street / PO Box 997 Port Washington, WI 53074-0997 Port Washington, WI 53074-0997 AGCOLawn.com www.MasseyLawn.com Briggs & Stratton Yard Power Products Group Copyright © 2007 Briggs & Stratton Corporation Milwaukee, WI USA. All Rights Reserved
