Resumen del contenido incluido en la página 1
Safety • Set-Up • Operation • Adjustments • Maintenance • Troubleshooting • Warranty
OPERATOR’S MANUAL
Transmatic Lawn Tractor — Model 606
IMPORTANT:
READ SAFETY RULES AND INSTRUCTIONS
CAREFULLY BEFORE OPERATING EQUIPMENT.
769-02793
1.6.07
PRINTED IN U.S.A. P. O. Box 1386, KITCHENER, ONT. N2G 4J1
Resumen del contenido incluido en la página 2
This Operator’s Manual is an important part of your new equipment. It will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says. Table of Contents Slope Gauge........................................................ 3 Off-Season Storage / Attachments ................. 8 Safe Operation Practices ................................... 4 Safety Labels .................................................... 9 Setting Up Your Lawn Tractor ....
Resumen del contenido incluido en la página 3
Fold along dotted line (represents a 15° slope) Sight and hold this level with a vertical tree... or a corner of a building... or a fence post 15° Use this page as a guide to determine slopes where you may not operate safely. Do not operate your lawn mower on such slopes. 1 Slope Gauge WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury. If operating a walk-
Resumen del contenido incluido en la página 4
WARNING: Engine Exhaust, some of its constituents, and certain vehicle compo- nents contain or emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm. DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing objects
Resumen del contenido incluido en la página 5
14. Watch for traffic when operating near or crossing General Operation: roadways. This machine is not intended for use on 1. Read, understand, and follow all instructions on the any public roadway. machine and in the manual(s) before attempting to 15. Do not operate the machine while under the influ- assemble and operate. Keep this manual in a safe ence of alcohol or drugs. place for future and regular reference and for ordering 16. Mow only in daylight or good artificial light. repla
Resumen del contenido incluido en la página 6
Slope Operation: Do Not: 1. Do not turn on slopes unless necessary; then, turn Slopes are a major factor related to loss of control and slowly and gradually downhill, if possible. tip-over accidents which can result in severe injury or 2. Do not mow near drop-offs, ditches or embankments. death. All slopes require extra caution. If you cannot The mower could suddenly turn over if a wheel is over back up the slope or if you feel uneasy on it, do not mow the edge of a cliff, ditch, or if
Resumen del contenido incluido en la página 7
10. Never attempt to make adjustments or repairs to the Service machine while the engine is running. 1. Never run an engine indoors or in a poorly ventilated 11. Grass catcher components and the discharge area. Engine exhaust contains carbon monoxide, an cover are subject to wear and damage which could odorless, and deadly gas. expose moving parts or allow objects to be thrown. 2. Before cleaning, repairing, or inspecting, make certain For safety protection, frequently check components
Resumen del contenido incluido en la página 8
Attaching the Battery Cables Rubber Boot NOTE: The positive battery terminal is marked Pos. (+). The negative battery terminal is marked Neg. (–). 3 • The positive cable (heavy red wire) is secured to the Retaining Rod positive battery terminal (+) with a hex bolt and hex Setting Up nut at the factory. Make certain that the rubber boot covers the terminal to help protect it from corrosion. Your Lawn • Remove the hex bolt and wing nut from the negative cable. Tractor • Remove the black pl
Resumen del contenido incluido en la página 9
Shipping Brace Removal WARNING: Make sure the riding mower’s engine is off, remove the 3 ignition key, and set the parking brake before removing the ship- Setting Up ping brace. Your Lawn • Locate the shipping brace, if present, and accompany- ing warning tag found on the right side of the mower, Tractor between the discharge chute and the cutting deck. See Figure 3-2. • While holding the discharge chute with your left hand, remove the shipping brace with your right hand by grasping it
Resumen del contenido incluido en la página 10
Attaching The Seat Seat styles vary by tractor model and there are three different styles available: • Standard Adjustment 3 • Quick Adjustment • Knob Adjustment Setting Up If the seat for your tractor did not come attached, refer to Figure 3-4, Figure 3-5, and Figure 3-6 to identify your Your Lawn tractor’s seat style and follow the applicable instructions below to attach it. Tractor NOTE: For shipping reasons, seats are either fastened to the tractor seat’s pivot bracket with a plastic
Resumen del contenido incluido en la página 11
Identifying the Mulch Plug (if so equipped) On tractor models so equipped, a mulch plug can either be found within the cutting deck’s discharge opening or 3 packed separately with your unit. Setting Up NOTE: Refer to Mulching on page 19 for more detailed information. Your Lawn If you’d prefer to operate the cutting deck without mulch- ing, simply remove the mulch plug by unthreading the Tractor plastic wing nut which fastens it to the cutting deck. This will allow the clippings to discha
Resumen del contenido incluido en la página 12
Know Your Lawn Tractor 4 † B Operating G A Your Lawn H Tractor † B I NOTE: Any reference in this manual to the RIGHT or LEFT P side of the tractor J is observed from operator’s position. K C NOTE: This Opera- D tors Manual covers N a range of product E L specifications for various models. M Characteristics and features discussed F and/or illustrated in this manual may not be applicable to all models. MTD LLC NOTE: Steering wheel not shown for clarity. reserves the right to chan
Resumen del contenido incluido en la página 13
Throttle Control Lever The throttle control lever is located on the right side of the tractor’s dash panel. This lever controls the speed of the engine and, on some models, when pushed all 4 the way forward, the choke control also. When set in a given position, the throttle will maintain a uniform engine speed. See Figure 4-1. Operating IMPORTANT: When operating the tractor with the cutting deck engaged, be certain that the throttle lever is always Your Lawn in the FAST (rabbit) p
Resumen del contenido incluido en la página 14
the MAINTENANCE section of this manual for the proper battery charging procedure or have the charging system checked by your service dealer. The ammeter (if so equipped) measures the electrical 4 output of the engine’s charging system. Under normal operating conditions, with the engine at full throttle, the ammeter’s needle should measure a positive charge. The hour meter (if so equipped) operates whenever the Operating engine is running and records the actual hours of tractor operation
Resumen del contenido incluido en la página 15
Found on your tractor’s right fender, the deck lift lever is Cargo Net (optional) used to change the height of the cutting deck. To use, Conveniently located on the tractor’s dash panel, the move the lever to the left, then place in the notch best cargo net can be used to store personal items while suited for your application. operating the tractor. 4 Parking Brake Button Safety Interlock Switches To set the parking brake, fully This tractor is equipped with a safety interlock system depr
Resumen del contenido incluido en la página 16
WARNING 4 AVOID SERIOUS INJURY OR DEATH • GO UP AND DOWN SLOPES, NOT ACROSS. • AVOID SUDDEN TURNS. Operating • DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR TIP. Your Lawn • IF MACHINE STOPS GOING UPHILL, STOP BLADE(S) AND BACK DOWNHILL SLOWLY. Tractor • DO NOT MOW WHEN CHILDREN OR OTHERS ARE AROUND. • NEVER CARRY CHILDREN, EVEN WITH BLADES OFF. • LOOK DOWN AND BEHIND BEFORE AND WHILE BACKING. Figure 4- • KEEP SAFETY DEVICES (GUARDS, SHIELDS, AND The REVERSE CAUTION MODE positi
Resumen del contenido incluido en la página 17
WARNING: Keep hands and feet Stopping the Engine away from the discharge opening WARNING: If you strike a foreign of the cutting deck. object, stop the engine, discon- 4 NOTE: The deck wheels are an anti-scalp feature of the nect the spark plug wire(s) deck and are not designed to support the weight of the and ground against the engine. cutting deck. Thoroughly inspect the machine Operating Refer to Leveling the Deck on page 20 of this manual for any damage. Repair the for more detail
Resumen del contenido incluido en la página 18
Driving On Slopes Engaging the Blades Refer to the SLOPE GAUGE on page 3 to help deter- Engaging the PTO (Blade Engage) transfers power to the mine slopes where you may operate the tractor safely. cutting deck or other (separately available) attachments. To engage the blades, proceed as follows: 4 WARNING: Do not mow on 1. Move the throttle control lever to the FAST (rabbit) inclines with a slope in excess position. of 15 degrees (a rise of approxi- Operating Models with Manual PTO mately 2
Resumen del contenido incluido en la página 19
• Do not mow at high ground speed, especially if a mulch kit or grass collector is installed. • For best results it is recommended that the first two laps be cut with the discharge thrown towards the 4 center. After the first two laps, reverse the direction to throw the discharge to the outside for the balance of cutting. This will give a better appearance to the lawn. Operating • Do not cut the grass too short. Short grass invites weed growth and yellows quickly in dry weather. Your Lawn
Resumen del contenido incluido en la página 20
1. With the tractor parked on a firm, level surface, place the deck lift lever in the top notch (highest position) and rotate the blade nearest the discharge chute so that it is parallel with the tractor. 2. Measure the distance from the front of the blade tip to the ground and the rear of the blade tip to the ground. Adjusting The first measurement taken should be between 1/4” and 3/8” less than the second measurement. Deter- Your Lawn mine the approximate distance necessary for prope
