Resumen del contenido incluido en la página 1
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Otreap Or ’s Mlauna
Self Propelled Mower — Models TB230, TB260, & TB280 ES
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
TROY-BILT LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA Form No. 769-07346
(November 2, 2011)
Resumen del contenido incluido en la página 2
To The Owner 1 Thank You Thank you for purchasing a Lawn Mower manufactured by the right to change product specifications, designs and Troy-Bilt. It was carefully engineered to provide excellent equipment without notice and without incurring obligation. performance when properly operated and maintained. If you have any problems or questions concerning the machine, Please read this entire manual prior to operating the equipment. phone a authorized Troy-Bilt service dealer or contact us direc
Resumen del contenido incluido en la página 3
Important Safe Operation Practices 2 WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol. HEED ITS WARNING! CALIFORNIA PROPOSITION 65 WARNING: Engine Exhaust, some of its constituents, and certain v
Resumen del contenido incluido en la página 4
12. A missing or damaged discharge cover can cause blade 27. When starting engine, pull cord slowly until resistance contact or thrown object injuries. is felt, then pull rapidly. Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than 13. Many injuries occur as a result of the mower being pulled you can let go. Broken bones, fractures, bruises or sprains over the foot during a fall caused by slipping or tripping. could result. Do not hold on to the mow
Resumen del contenido incluido en la página 5
3. Check the blade and engine mounting bolts at frequent Service intervals for proper tightness. Also, visually inspect blade for damage (e.g., bent, cracked, worn) Replace blade with Safe Handling Of Gasoline: the original equipment manufacture’s (O.E.M.) blade only, 1. To avoid personal injury or property damage use extreme listed in this manual. “Use of parts which do not meet the care in handling gasoline. Gasoline is extremely flammable original equipment specifications may lead to i
Resumen del contenido incluido en la página 6
Notice Regarding Emissions Spark Arrestor Engines which are certified to comply with California and federal WARNING: This machine is equipped with an EPA emission regulations for SORE (Small Off Road Equipment) internal combustion engine and should not be used are certified to operate on regular unleaded gasoline, and on or near any unimproved forest-covered, brush may include the following emission control systems: Engine covered or grass-covered land unless the engine’s Modification (E
Resumen del contenido incluido en la página 7
Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manual(s) before attempting to assemble and operate DANGER — ROTATING BLADES To reduce the risk of injury, keep hands and feet away. Do not operate unless discharge cover or grass catcher is in
Resumen del contenido incluido en la página 8
8 Scetion 2 — i anmtport Seaf o tioepnra p rcatiec S 15° dashed line Slope Gauge 15° Slope 15° Slope (OK) (TOO STEEP) Figure 1 Figure 2 USE THIS SLOPE GAUGE TO DETERMINE IF A SLOPE IS TOO STEEP FOR SAFE OPERATION! To check the slope, proceed as follows: 1. Remove this page and fold along the dashed line. 2. Locate a vertical object on or behind the slope (e.g. a pole, building, fence, tree, etc.) 3. Align either side of the slope gauge with the object (See Figure 1 and Figure 2 ). 4. Adjust ga
Resumen del contenido incluido en la página 9
Assembly & Set-Up 3 Contents of Carton • One Lawn Mower • One Grass Catcher • One Bottle of Oil • One Lawn Mower Operator’s Manual • One Engine Operator’s Manual • One Side Discharge Chute NOTE: Please be aware that this Operator’s Manual covers both b. While stabilizing mower so it doesn’t move, pivot the low and high wheel models of this mower. While this manual upper handle up as shown in Fig. 3-2. Do not crimp illustrates the high wheel model, the instructions and features cable while l
Resumen del contenido incluido en la página 10
2. Remove the T-bolts from the handle brackets as shown in Fig. 3-3. C C Figure 3-5 4. The rope guide is attached to the right side of the upper handle. Loosen the wing knob which secures the rope Figure 3-3 guide. See Fig. 3-6. a. Hold blade control against upper handle. 3. Follow the steps below to complete handle assembly: b. Slowly pull starter rope handle from engine and slip a. Pull upward on the handle until holes in lower handle starter rope into the rope guide. See Fig. 3-6. (show
Resumen del contenido incluido en la página 11
b. Slip plastic channel of grass bag over hooks on the 1. On the side of the mower, lift the side mulching plug. See frame. See Fig. 3-7. Figure 3-9. Side Mulching Plug B 1 2 A Figure 3-9 Figure 3-7 2. Follow steps below to attach grass catcher: 2. Slide two hooks of side discharge chute under hinge pin on mulching plug assembly. Lower the mulching plug. Do not a. Lift rear discharge door. remove side mulching plug at any time, even when you are b. Place grass catcher into the slots in the
Resumen del contenido incluido en la página 12
NOTE: For mowers with low wheels, the height adjustment 2. Position the handle in one of the three positions that is most levers move in the opposite direction to adjust; for those comfortable. See Fig. 3-11 inset. with high wheels, the levers move in the same direction. 3. Secure into position with wing nuts and carriage bolts removed earlier. Drive Control 2 The adjustment wheel is located in the drive control handle Higher housing and is used to tighten or loosen the drive belt. You will
Resumen del contenido incluido en la página 13
Controls and Features 4 Blade Control Drive Control Electric Start Ignition Switch Recoil Starter Side Discharge Chute Deck Wash Cutting Height Adjustment Lever Cutting Height Adjustment Lever Figure 4-1 Blade Control Deck Wash (If Equipped) The blade control is attached to the upper handle of the mower. Your mower’s deck is equipped with a water port on its surface Depress and squeeze it against the upper handle to operate the as part of its deck wash system. Use the deck wash to rinse g
Resumen del contenido incluido en la página 14
Operation 5 Starting Engine WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower. Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas. Keep hands, feet, hair and 1 loose clothing away from any moving parts on engine and lawn mower. Follow the set of instructions pertaining to your unit. Refer to 2 engine manual for help with the engine. Bri
Resumen del contenido incluido en la página 15
Using Your Lawn Mower Using Grass Catcher Be sure lawn is clear of stones, sticks, wire, or other objects You can use the grass catcher to collect clippings while you are which could damage lawn mower or engine. Such objects could operating the mower. be accidently thrown by the mower in any direction and cause 1. Attach grass catcher following instructions in the serious personal injury to the operator and others. “Assembly & Set-Up” section. Grass clippings will 1. Once the engine is runni
Resumen del contenido incluido en la página 16
Maintenance & Adjustments 6 2. The transmission is pre-lubricated and sealed at the factory Maintenance and does not require lubrication. General Recommendations 3. Follow the accompanying engine manual for lubrication schedule and instruction for engine lubrication. • Always observe safety rules when performing any maintenance. Deck Care • The warranty on this lawn mower does not cover items that Clean underside of the mower deck after each use to prevent have been subjected to operator ab
Resumen del contenido incluido en la página 17
Deck Wash (If Equipped) Engine Care Your mower’s deck may be equipped with a water port on its A list of key engine maintenance jobs required for good surface as part of its deck wash system. performance by the mower is given below. Follow the accompanying engine manual for a detailed list and instructions. Use the deck wash to rinse grass clippings from the deck’s underside and prevent the buildup of corrosive chemicals. • Maintain oil level as instructed in engine manual. Complete the follo
Resumen del contenido incluido en la página 18
Service 7 WARNING: An unbalanced blade will cause Blade Care excessive vibration when rotating at high speeds. It WARNING: When removing the cutting blade for may cause damage to mower and could break sharpening or replacement, protect your hands with causing personal injury. a pair of heavy gloves or use a heavy rag to hold the 5. Lubricate the engine crankshaft and the inner surface of the blade. blade adapter with light oil. Slide the blade adapter onto Periodically inspect the blade
Resumen del contenido incluido en la página 19
Replacing Battery (If Equipped) Charging Battery (If Equipped) WARNING: Batteries contain sulfuric acid which WARNING: The battery contains corrosive fluid may cause burns. Do not short circuit or mutilate and toxic material; handle with care and keep away batteries in any way. Do not put batteries in fire as from children. Do not puncture, disassemble, these may burst or release toxic materials. mutilate or incinerate the battery. Explosive gases could be vented during charging or dischargi
Resumen del contenido incluido en la página 20
Replacing Fuse (If Equipped) Off-Season Storage The electric starter circuit and battery are protected by a 40 The following steps should be taken to prepare your lawn mower ampere fuse. If the fuse burns out, the electric starter will not for storage. operate. If the unit fails to start with the electric starter, perform • Clean and lubricate mower thoroughly as described in the the following steps to check the fuse inside the battery housing: lubrication instructions. 1. Open the battery co
