Manual de instrucciones de Stiga SILENT COMBI 45SE

Resumen del contenido incluido en la página 1

D
DEUTSCH
SILENT COMBI
8211-3442-06
45
45S
45SE

Resumen del contenido incluido en la página 2

S SVENSKA A B 1. 2. 3. 4. 3 2 4 1 FULL ADD 6. LS45 0,15 l. 6 5 5. 7. ES45 3 ADD FULL ADD FULL

Resumen del contenido incluido en la página 3

S SVENSKA 3x 3x 8. LS45 9. ES45 G I* 10. 11. A A F A 12. 13. LS45 F 14. ES45 15. LS45 4 STOP

Resumen del contenido incluido en la página 4

S SVENSKA 16. ES45 17. Left 18. Right 19. LS45 20. ES45 0,75 mm 21. 22. 23. 5

Resumen del contenido incluido en la página 5

S SVENSKA 24. 25. 45 Nm 26. 27. P S 28. 6

Resumen del contenido incluido en la página 6

GB ENGLISH SYMBOLS ASSEMBLING The following symbols are displayed on the ma- HANDLEBAR chine in order to remind you about the safety pre- Fold up the handle. By tightly screwing the lower cautions and attention necessary when using the part of the handle into the steering sockets’ lower or machine. upper holes (A or B), the steering height can be The symbols mean: adapted to suit the operator (fig. 1). Warning! Read the Instruction Book and Tighten the locking knobs to fix the upper part of the

Resumen del contenido incluido en la página 7

GB ENGLISH 2. COLLECTION STARTING THE ENGINE Assemble the enclosed grass collector (fig. 5). 1. Place the lawn mower on flat, firm ground. Do Open the cover, remove the plug and this time not start in high grass. hook the collector in place onto the back of the ma- 2. Make sure the spark plug lead is connected to chine. the spark plug. During cutting, the grass is collected in the collec- 3. Move the throttle control (*) to the full throttle tor. Empty the grass on the compost heap or spread pos

Resumen del contenido incluido en la página 8

GB ENGLISH 2. If the lawn mower is left unattended to, remove If grass has dried on to the cutterhead casing it can the lead from the spark plug. Also remove the be removed by scraping. If necessary, give the un- starter key (*). derside a touch of paint to prevent rusting. If the start/stop loop no longer works, Clean the silencer and the surrounding stop the engine by removing the lead area regularly to remove grass, dirt and from the spark plug. Immediately take flammable waste products. the

Resumen del contenido incluido en la página 9

GB ENGLISH CHANGING OIL BATTERY (*) Replace the oil when the engine is warm Electrolyte in the battery is toxic and and the fuel tank is empty. Take care corrosive. It can cause serious corrosion whiledraining astheoilishot,thisisto damage etc. Avoid all contact with skin, prevent burns. eyes and clothing. Change the oil the first time after 5 hours of oper- In normal use during the season, the battery is ation, and subsequently after every 50 hours of op- charged by the engine. If the engine ca

Resumen del contenido incluido en la página 10

GB ENGLISH To change blades, loosen the blade bolt. Mount the new blade so that it sits in the same way as the old one and tighten the blade bolt (fig. 26). Tightening torque: 45 Nm. When replacing the blade, the blade bolt should also be replaced. The guarantee does not cover damage to the blade, blade holder or engine caused by running into ob- stacles. When replacing the blade, the blade holder and blade bolt, always use original spare parts. Non- authentic spare parts could lead to the risk