Manual de instrucciones de Stiga 8211-3389-06

Resumen del contenido incluido en la página 1

D
DEUTSCH
8211-3389-06

Resumen del contenido incluido en la página 2

S SVENSKA 1. 2. 12 34 3. 4. FULL ADD 5. 6. Briggs & Stratton MAX MIN G MAX MIN B 7. Tecumseh 8. 3 ADD FULL STOP

Resumen del contenido incluido en la página 3

S SVENSKA 3x 3x 9. Briggs & Stratton 10. Tecumseh 2 3 1 11. 12. Briggs & Stratton Briggs & Stratton : 0,76 mm 0,75 mm Tecumseh: 0,6 mm A D C E 13. Tecumseh 14. 40 Nm 15. 4

Resumen del contenido incluido en la página 4

GB ENGLISH The components for assembling the upper section SYMBOLS of the steering are fitted for packing purposes. Re- move the components from the lower section of The following symbols are displayed on the ma- the steering. chine in order to remind you about the safety pre- Then attach the upper part of the handlebar with cautions and attention necessary when using the screws, washers and locking knobs (fig. 2). machine. The handlebar has four different positions. Release The symbols mean: th

Resumen del contenido incluido en la página 5

GB ENGLISH Briggs & Stratton: Keep hands and feet well away from the Remove and dry the dipstick (fig. 6). Slide it down rotating blade. Never put your hand or completely and tighten it. Unscrew and pull it up foot under the blade casing or in the again. Read-off. If the oil level is low, fill with oil grass evacuation unit while the engine is up to the “FULL/MAX” mark. running. Tecumseh: STOP OF ENGINE Clean the area round the oil plug, then remove the The engine may be very warm immedi- plug (

Resumen del contenido incluido en la página 6

GB ENGLISH Tecumseh: CLEANING Check the air filter after every 25 hours of use, After each time it is used the mower should be more often if the engine is used in dusty condi- cleaned. This is particularly important on the un- tions. If the foam filter is dirty or blocked it should derside of the mower casing. Wash out with the be replaced. garden hose. The mower will then last longer and Dismantle the cover A. Clean inside the cover A function better. and the filter support E, (fig. 13). Soak t

Resumen del contenido incluido en la página 7

GB ENGLISH When replacing the blade, the blade bolt should also be replaced. The guarantee does not cover damage to the blade, blade holder or engine caused by running into ob- stacles. When replacing the blade, the blade holder and blade bolt, always use original spare parts. Non- authentic spare parts could lead to the risk of per- sonal injury or damage, even if they fit the ma- chine. SHARPENING OF THE BLADE Sharpening of the blade must be done by wet meth- od grinding, using a whetstone or