Resumen del contenido incluido en la página 1
MARVEL REFRIGERATED WINE CELLAR
Installation
Operation
and
Maintenance
Instructions
Refrigerated
Wine Cellar
3SWCE, 6SWCE & 8SWCE
Resumen del contenido incluido en la página 2
UNPACKING YOUR WINE CELLAR Remove Packaging Your wine cellar has been packed for shipment with all parts that could be damaged by movement securely fastened. Be- fore using, be sure all packing materials and tape have been removed. Important Keep your carton packaging until your wine cellar has been REMINDER thoroughly inspected and found to be in good condition. If IT IS IMPORTANT THAT YOU SEND there is damage, the packaging will be needed as proof of IN YOUR WARRANTY RECORD CARD damag
Resumen del contenido incluido en la página 3
INSTALLING YOUR WINE CELLAR Select Location The proper location will ensure peak performance of your Electrical Plug Optional Location: Cutout shown for appliance. Choose a location where the unit will be out of electrical outlet which can be located in adjacent cabinetry. direct sunlight and away from heat sources. Best perfor- mance will be maintained when installed within the follow- ing parameters: Ideal Ambient Temperature Range Built-In 65-80 °F Free-Standing 65-90 °F Cabinet Clearan
Resumen del contenido incluido en la página 4
SENTRY SYSTEM™ REFRIGERATION MONITOR Sentry System™ Warmer °F/C ON Power Failure - Flashing Amber F Figure 3 High/Low Temp - Red Set Press ON/OFF - Reset 55 OFF Colder Light Alarms OFF - Steady Amber Start Your Appliance Interior Light and Switch Your appliance will start upon initial plug-in. The LED will The interior light makes it easy to view your wine labels flash amber upon initial plug-in due to your unit being and enhances the display of your collection. The light will powered-on
Resumen del contenido incluido en la página 5
3SWCE WINE CELLAR FEATURES Insert Wine Bottles Front Bottles (Necks Facing Rear) The six (6) roll-out shelves each hold four (4) bottles. See Rear Bottles (Necks Facing Front) Figure 4 for typical wine bottle spacing. Tall bottles should not be loaded on the bottom rack because they may pre- vent the door from closing. Loading Tips and Suggestions Position white wines on the middle or lower racks and red wines on the upper racks (see Figure 5). Keep wines that you plan to use for everyday
Resumen del contenido incluido en la página 6
6SWCE WINE CELLAR FEATURES Insert Wine Bottles Front Bottles (Necks Facing Rear) The six (6) roll-out shelves each hold eight (8) bottles. See Rear Bottles (Necks Facing Front) Figure 7 for typical wine bottle spacing. Tall bottles should not be loaded on the bottom rack because they may pre- vent the door from closing. Loading Tips and Suggestions Position white wines on the middle or lower racks and red wines on the upper racks (see Figure 8). Keep wines that you plan to use for everyday
Resumen del contenido incluido en la página 7
8SWCE WINE CELLAR FEATURES Insert Wine Bottles Front Bottles (Necks Facing Rear) The six (6) roll-out shelves each hold ten (10) bottles. See Rear Bottles (Necks Facing Front) Figure 10 for typical wine bottle spacing. Tall bottles should not be loaded on the bottom rack because they may prevent the door from closing. Loading Tips and Suggestions Position white wines on the middle or lower racks and red wines on the upper racks (see Figure 11). Keep wines that you plan to use for everyday
Resumen del contenido incluido en la página 8
CARE AND CLEANING OF YOUR WINE CELLAR To replace a light tube, use a hex-head driver, remove the Condenser two hex-head screws that hold a cover plate over the back The condenser tubing inside the cabinet does not require section of the light tube. Set the screws and cover plate frequent cleaning; however, satisfactory cooling depends aside for reassembly later. on adequate ventilation over the coils. Be sure that noth- ing obstructs the required air flow openings in front of the Using a
Resumen del contenido incluido en la página 9
TROUBLESHOOTING YOUR WINE CELLAR Before Calling for Service Before calling for service, check the troubleshooting table on this page. This table lists possible problems that you can remedy without difficulty to avoid an unnecessary service call. PROBLEM POSSIBLE CAUSES/SOLUTIONS Odor in cabinet 1. Interior needs cleaning 1. Cabinet not level Noisy operation 2. Weak floor 1. Cabinet not level Cabinet vibrates 2. Weak floor 1. Tube burned out Cabinet light not working 2. No power at outlet Help
Resumen del contenido incluido en la página 10
OBTAINING SERVICE FOR YOUR WINE CELLAR If You Do Need Service How to Obtain Service If you do need service, contact your dealer or Marvel Indus- Your refrigerated wine cellar requires little service because tries. In any correspondence, refer to the model number the best and most up to date materials, equipment and and serial number of your unit which is located on the quality methods are employed throughout the manufactur- upper left hand side of the wall liner. Retain your proof of ing pro
Resumen del contenido incluido en la página 11
HOUSEHOLD PRODUCT WARRANTY Entire Product Parts or Service Limited One Year Parts and Labor Warranty Not Supplied or Designated by Marvel Marvel warrants that it will supply all necessary parts and The above warranties also do not apply if: labor to repair or replace in the end user’s home or office, any component which proves to be defective in material • The original bill of sale, deliver date, or serial number or workmanship, subject to the condition and exclusions cannot be verified. stat
Resumen del contenido incluido en la página 12
www.lifeluxurymarvel.com Marvel Industries P.O. Box 997 Richmond, IN 47375-0997 800.428.6644 An AGA Company 41010401 Rev. C All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for 03.03.08 previously purchased products.
