Resumen del contenido incluido en la página 1
OPERATOR’S MANUAL
Premium Rider (CE)
1 15,5 HP Hydro Tractors 17,5 HP Hydro Tractors
Mfg. No. Brand Mfg. No. Brand
7800352 Snapper LT75 7800356 Snapper LT75
7800353 Snapper LT75 7800357 Snapper LT75
7800354 Simplicity Coronet 7800358 Simplicity Coronet
7800355 Simplicity Coronet 7800359 Simplicity Coronet
CAUTION: Read and
follow all instructions.
Manual Part No. 885193
Revision A
Rev. Date 01/2009
Resumen del contenido incluido en la página 2
2
Resumen del contenido incluido en la página 3
en Table of Contents Owner’s Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Safe Operation Practices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety and Operation Decals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Operation . . . . . . . . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 4
en Owner’s Information Know Your Product Responsibility of the Owner If you understand the unit and how the unit operates, you will get the best performance. As you read this WARNING manual, compare the illustrations to the unit. Learn the location and the function of the controls. To help pre- This cutting machine is capable of amputating vent an accident, follow the operating instructions and hands and feet and throwing objects. Failure to the safety rules. Keep this manual for future referen
Resumen del contenido incluido en la página 5
en Safe Operation Practices d. If fuel is spilled, do not attempt to start the For Ride-On (Riding) Rotary Mower engine but move the machine away from the Machines area of spillage and avoid creating any source of ignition until the fuel vapors have dissipated. Training e. Replace all fuel tanks and container caps 1. Read the instructions carefully. Be familiar with the securely. controls and the proper use of the equipment. 4. Replace faulty silencers. 2. Never allow children or people
Resumen del contenido incluido en la página 6
en Safe Operation Practices 9. When using any attachments, never direct the 16. Reduce the throttle setting during engine run-out discharge of material toward bystanders nor allow and, if the engine is provided with a shut-off valve, anyone near the machine while in operation. turn the fuel off at the conclusion of mowing. 17. Before and when backing, look behind and down 10. Never operate the mower with defective guards or for small children. shields, or without safety protective devices i
Resumen del contenido incluido en la página 7
en Safety and Operation Decals All safety and operation decals should be carefully NOTE: If any of these safety or operation decals are read and followed. Serious personal injury and/or lost or damaged, replace them at once. See your equipment damage can result when these decals are local dealer for replacements. not followed. Decal - Ignition Switch (1722806) Decal - Parking Decal - Cutting Brake (48x726) Height (885253) 48x4032 Decal - Operating Instructions (CE) (48x4032) Decal - Noise Level
Resumen del contenido incluido en la página 8
en Safety and Operation Decals IMPORTANT: The following sym- 1 2 3 bols are located on your unit or on literature supplied with the product. Before you operate the unit, learn and understand the purpose for each symbol. Safety Warning Symbols 1 W ARNING. 2 IMPORTANT: Read Owner’s 4 6 Manual Before Operating This 5 Machine. 3 WARNING: Thrown Objects. Keep Bystanders Away. Read User Instructions Before Oper- ating This Machine. 4 WARNING: Do Not Use This Machine On Slopes Greater Than 10 Degrees.
Resumen del contenido incluido en la página 9
en Assembly NOTES: All fasteners are in the parts bag. Do not dis- Install the Seat card any parts or material until the unit is assembled. 1. Carefully remove the plastic bag from the seat. Before doing any assembly or maintenance to the 2. Raise the seat support (1) (see F Figure 2). mower, remove the wire from the spark plug. 3. Align the holes in the seat (2) to the slots in the seat support. Install the Front Wheels 4. Install the seat (2) to the seat support (1) and 1. Make sure the val
Resumen del contenido incluido en la página 10
en Assembly Assemble the Grass Bag Assemble the Steering Wheel 1. Make sure the front wheels point forward as shown 1. Slide the bottom tube (1) onto the bagger frame (2) in F Figure 3. (see F Figure 4). 2. Slide the bellows (1, F Figure 3) over the console. 2. Align the holes in bottom tube the with hole in the bagger frame. 3. Slide the steering post (2) into the console. 3. Install the cotter pins (3) into holes and bend the ends to secure to the frame. 8 4. Slide the frame assembly onto t
Resumen del contenido incluido en la página 11
en Assembly Mount the Grass Bag Maintenance Free Battery 1. Mount the grass bag assembly onto the rear bag- IMPORTANT: Before you attach the battery cables to ger brackets as shown (see F Figure 5). the battery, check the battery date. The battery date tells if the battery must be charged. a. Use one hand to grab onto the handle at the rear of the bag frame assembly. 1. Raise the seat support (s see Figure 2). b. Use the other hand to hold the top bagger han- 2. Remove two screws (1) and bat
Resumen del contenido incluido en la página 12
en Assembly Charge the Battery Check the Tires Check the air pressure in the tires. Tires with too much WARNING air pressure will cause the unit to ride rough. Also, the wrong air pressure will keep the mower deck from cut- When you charge the battery, do not smoke. Keep ting level. The correct air pressure is: Front Tires 0,97 the battery away from any sparks. The fumes from BAR (14 PSI), Rear Tires 0,69 BAR (10 PSI). The tires the battery acid can cause an explosion. were over inflated for shi
Resumen del contenido incluido en la página 13
en Operation 3 1 4 2 5 6 11 8 7 9 10 Figure 7 Location of Controls Throttle Control Lever (1): Use the throttle control lever Reverse Speed Control Pedal (6): Use the reverse to increase or decrease engine speed (see F Figure 7). ground speed pedal to control the reverse ground Move the throttle up to increase engine speed and speed of the tractor. down to decrease engine speed. Always operate at Lift Lever (7): The lift lever controls the mower cutting FULL throttle. height. There are six cut
Resumen del contenido incluido en la página 14
en Operation Use the Blade Rotation Control Important! Before You Start Mowing Use the blade rotation control to engage the blade(s). • Check the engine oil. 1. Before you start the engine, make sure the blade • Fill the fuel tank with fuel. rotation control is in the DISENGAGE position (see • Check the air pressure of the tires. Figure 9). • Check the level of the mower housing. • Attach the battery cables. WARNING Always keep your hands and feet away from the blade, deflector opening, and the
Resumen del contenido incluido en la página 15
en Operation Attachments Install the Mulcher Cover This unit can use attachments like a dump cart and a The mulcher cover lets you mulch the grass for a clean, dethatcherizer. This unit cannot use attachments that fine cut. Install as follows. engage the ground like a plough, a disk harrow, or a 1. Follow the steps shown in F Figure 10 to remove the cultivator. rear discharge chute and chute extension. For the dump cart, the maximum weight is 90 kg (200 2. Mount the mulcher cover (1) to the mo
Resumen del contenido incluido en la página 16
en Operation Use the Speed Control Pedals The drive system uses a Hydrostatic Automatic Drive Transmission. The hydrostatic transmission is very easy to operate. This type of drive system does not re- quire a shift lever or a clutch pedal. The speed and direction of travel is controlled by a for- ward speed control pedal and reverse speed control pedal operated with your right foot. NOTE: Do not use the left brake pedal in normal opera- tion. Only use the left brake pedal to quickly stop in an
Resumen del contenido incluido en la página 17
en Operation Use the Parking Brake 1. Fully depress the clutch/brake pedal (see Figure 13). 2. Pull up the parking brake knob (F Figure 15). 3. Remove your foot from the clutch/brake pedal and then release the parking brake knob. Make sure the parking brake will hold the unit. 1 4. To release the parking brake, fully depress the clutch/brake pedal. The parking brake will automat- ically release. 2 WARNING Before you leave the operator’s position, release the speed control pedal. Set the parki
Resumen del contenido incluido en la página 18
en Operation Stop the Unit 1. Completely push the clutch/brake pedal forward to stop the unit (see F Figure 13). Keep your foot on the pedal. 2. Push the blade rotation control down to the DISENGAGE position (see F Figure 9). 3. Release the speed control pedal to the NEUTRAL position (see F Figure 14). 4. Set the parking brake (see F Figure 15). WARNING Make sure the parking brake will hold the unit. 5. Move the throttle control to the SLOW position (see F Figure 8). 6. Turn the ignition key
Resumen del contenido incluido en la página 19
en Operation 6. Move the throttle control to the FAST position (see Transport the Unit Figure 8). If you need to go faster or slower, stop To transport the unit, follow the steps below. the unit and move the speed control pedal to an- other speed setting. 1. Push the blade rotation control down to the DISENGAGE position (see F Figure 9). 7. Make sure the level of cut is still correct. After you mow a short distance, look at the area that was cut. 2. Raise the lift lever to the highest positi
Resumen del contenido incluido en la página 20
en Operation 5. Turn the ignition key to the START position (see 1 Figure 18). NOTE: If the engine does not start after four or five tries, move the throttle control to the FAST position. Again try to start the engine. If the engine will not start, see the TROUBLESHOOTING CHART. 2 6. Slowly move the throttle control to the SLOW position. 7. To start a hot engine, move the throttle control to a position between FAST and SLOW. 3 Operate on Hills WARNING Do not ride up or down slopes that are to
