Manual de instrucciones de Bunn ULTRA-2 PAFA

Resumen del contenido incluido en la página 1

ULTRA-2 PAF
ULTRA-2 PAFA
USE & CARE INSTRUCTIONS for ULTRA-2 COLD DRINK DISPENSER WITH PAF DISPENSER
NOTICE - This guide is for quick reference only and is not intended to replace the information in the Operation Manual!
DISASSEMBLY & CLEANING
EMPTY ALL PRODUCT FROM THE ULTRA HOPPERS INTO A BUCKET OR CONTAINER BEFORE PROCEEDING!
1. Open the Cabinet Door and 2. Place the power switch in
3. Pull the Mixing Chamber out 4. Twist the Whipper Chamber
allow the support arms to lock the OFF position.

Resumen del contenido incluido en la página 2

DISASSEMBLY & CLEANING Turn cooling to OFF selection. Empty all product from the hopper(s). Turn auger to OFF selection. 2. Depress the hopper lock 3. Pull the hopper assembly 4.Pull the auger from the cool- 1. Slide PAF assembly back plunger, lift slightly. forward and remove. ing drum. until it latches before removing ULTRA Hoppers. 7. Carefully slide valve up to 8. Remove the auger nose bush- 5. Remove the hopper seal from 6. CAUTION: Faucet valve is remove spring and faucet seal. ing from

Resumen del contenido incluido en la página 3

ASSEMBLY 1. Replace the auger nose bush- 2. Install the hopper seal over the 3. Align the auger shafts with the 4. Install the hopper over the ing inside the front of the hopper. flange at the rear of the cooling augers. Push the augers as far as auger and cooling drum and drum as shown. they will go and rotate them so slide it into place. Push down the flat face of the auger shaft is until the hopper lock plunger aligned with the flat face of the snaps into place. auger nose. 5. Position t

Resumen del contenido incluido en la página 4

THOROUGH CLEANING OF THE PAF HOPPER (Once a week) 1. Open the Cabinet Door and 2. Slide the gate shut on the 3. Pull the Ejector Elbow off the 4. Remove the Wiper Blade and allow the support arms to lock powder hopper and remove the Hopper Base. Remove the Slide Drive Gear by removing the in place. hopper. Remove the Cover and Gate from the Ejector Elbow. Retaining Ring from the Wiper empty the contents. Blade Shaft. Remove Auger by pulling it out the front of Hop- per Base. 6. Wash all comp