Resumen del contenido incluido en la página 1
OWNER’S MANUAL
HRC216PDA
LAWN MOWER
Before operating the mower for the first time, please read this
Owner’s Manual. Even if you have operated other mowers,
take time to become familiar with how this mower works and
practice in a safe area until you build up your skills.
QUICK FIND
Air Filter.................................................. 13 Find a Dealer..........................................20 Oil Change..............................................13
Blades..........................
Resumen del contenido incluido en la página 2
WARNING WELCOME The engine exhaust from this product contains chemicals known to the State of California to cause Congratulations on your selection of a Honda lawn mower! We are cancer, birth defects, or reproductive harm. certain you will be pleased with your purchase of one of the finest lawn mowers on the market. We want to help you get the best results from your new mower and to operate it safely. This manual contains Important Message to Parents information on how to do that; plea
Resumen del contenido incluido en la página 3
Safety Label Locations PARTS AND CONTROLS These labels warn you of potential hazards that can cause serious injury. Read them carefully. If a label comes off or becomes hard to read, contact an authorized Honda servicing dealer for a replacement. BLADE CONTROL LEVER (P. 9) HANDLEBAR THROTTLE LEVER (P. 15) DISCHARGE GUARD FUEL TANK CAP SPARK PLUG CAP (P. 14) GRASS BAG (P. 13) OIL FILLER CAP (P. 8) MUFFLER REAR CUTTING HEIGHT ADJUSTMENT LEVER (2) (P. 7) RECOIL KEEP HANDS and FEET AWAY ST
Resumen del contenido incluido en la página 4
Adjust the Handlebar INITIAL MOWER SETUP 1. Pry open the right side handle support hanger, and place it over the right handle above the starter rope guide. Squeeze the ends together. Make sure the ribs are facing out, as shown. List of Parts STARTER ROPE GUIDE With help from an assistant, carefully remove the mower and loose parts from the carton and compare the loose parts against the RIBS following list. Contact the authorized Honda dealer from whom you OUT purchased the mower if any of
Resumen del contenido incluido en la página 5
7. Insert the stud on one end of one handle support plate into the 13.Install an 8 mm self-locking nut on each stud. lower hole in the right side of the housing. 14.Tighten the lock nuts on the studs at each end of both handle support plates. 15.Position cable ties at the locations shown. CABLE TIES STUD HANDLE SUPPORT PLATE 10 in (250 mm) 3 in (75 mm) 8. Insert the stud on one end of the other handle support plate into 12 in (300 mm) the lower hole in the left side of the housing. 9. Tilt
Resumen del contenido incluido en la página 6
Assemble the Grass Bag and Lid BEFORE EACH OPERATION 1. Insert the grass bag LID joint through the lid PUSH NUT (2) and grass bag frame. Your safety is your responsibility. A little time spent in preparation will Secure with a push significantly reduce your risk of injury. nut on each end of Read and understand this manual. Know what the controls do and the grass bag joint. how to operate them. Familiarize yourself with the lawn mower and its operation before you begin using it. Know ho
Resumen del contenido incluido en la página 7
Rear Shield During normal use the rear shield is subject to deterioration and wear. 4 in (100 mm) Remove the grass bag and raise the discharge guard to check the 3-1/2 in (89 mm) 3 in (76 mm) rear shield for cracks or tears. If the rear shield is excessively worn, 2-1/2 in (63 mm) have it replaced by your authorized Honda servicing dealer. 2 in (51 mm) 1-1/2 in (39 mm) 1 in (25 mm) 3/4 in (19 mm) DISCHARGE GUARD REAR WHEEL FRONT WHEEL CUTTING HEIGHT ADJUSTMENT LEVER (4) REAR SHIELD Grass Bag
Resumen del contenido incluido en la página 8
MAINTENANCE” on page 19 for information regarding fuel Check the Oil Level deterioration. 1. Unscrew and remove the filler cap/dipstick and wipe it clean. 1. Remove the fuel tank cap. 2. Insert and remove the 2. Add fuel to the bottom of the red fuel level gauge in the neck of dipstick without the fuel tank. Do not overfill. Wipe up spilled fuel before starting screwing it into the the engine. filler neck. Check the oil level shown on the RED FUEL dipstick. LEVEL 3. If the oil level is l
Resumen del contenido incluido en la página 9
Avoid Obstacles WARNING Gravel, loose stones, and landscaping material can be picked up by the mower and thrown many feet with enough force to cause serious The blades are sharp and spin at high speed. A spinning blade personal injury and/or property damage. The best way to prevent can cut you severely and can amputate fingers and toes. potential injury from thrown objects is to release the blade control • Wear protective footwear. lever to stop the blades before reaching areas with grave
Resumen del contenido incluido en la página 10
Starting the Engine Stopping the Engine The blades turn when you start the engine. Start the engine in a clear 1. Move the throttle lever to or mowed area where the blades can turn freely. the SLOW position. 2. Release the blade control 1. Turn the fuel valve to the ON lever to stop the engine. position. BLADE CONTROL LEVER ON FUEL VALVE 3. When the mower is not in OFF 2. Move the throttle lever to the use, turn the fuel valve to proper starting position. the OFF position. 4. Clean your m
Resumen del contenido incluido en la página 11
2. Service more frequently when used in dusty areas. WARNING 3. These items should be serviced by an authorized Honda servicing dealer unless you have the proper tools and are mechanically Failure to properly follow maintenance instructions and proficient. Refer to the Honda shop manual for service procedures. precautions can cause you to be seriously hurt or killed. See Honda Publications on page 20 for ordering information. Always follow the procedures and precautions in this manual. Fai
Resumen del contenido incluido en la página 12
The blade bolts and washers are specially designed for this Blade Mounting Bolt Inspection application. When replacing bolts and washers, use only Honda Inspect the blade bolts for any signs of damage Genuine replacement parts. INSPECT WASHERS or looseness. If they are damaged, they must AND BOLT HEADS UPPER BLADE be replaced. FOR LOOSENESS If they appear loose, a torque wrench must be used to accurately tighten the blade bolts to the required torque. If you do not have a torque wrench,
Resumen del contenido incluido en la página 13
A properly maintained air filter will help prevent dirt from entering your Oil Change engine. Dirt entering the carburetor can be drawn into small passages Change the oil after the first month or 5 hours of use. Thereafter, in the carburetor and cause premature engine wear. These small change the oil every 6 months or 50 hours of use. Change the oil passages can become blocked, causing starting or running problems. more frequently when used under heavy load or high outdoor NOTICE temperat
Resumen del contenido incluido en la página 14
3. Check for carbon deposits on the spark arrester and the exhaust Spark Plug port. Use a brush to remove any carbon deposits from the Replace the spark plug every 2 years or after 150 hours of use. screen. Replace the screen if it is torn or damaged. 4. Installation is the reverse of removal. Tighten all hardware Recommended Spark Plug: NGK - BPR5ES securely. NOTICE 5. Reconnect the spark plug cap. An incorrect spark plug can cause engine damage. For good performance, the spark plug must be
Resumen del contenido incluido en la página 15
Throttle Cable Inspection STORAGE Throttle cable adjustment is necessary if the throttle lever does not operate the choke properly. You can inspect choke operation by observing the movement of the Proper storage preparation is essential for keeping your lawn mower choke arm, which is located on top of the carburetor. trouble free and looking good. To help keep rust and corrosion from impairing your lawn mower’s function and appearance, and to make 1. Move the throttle lever to the engine ea
Resumen del contenido incluido en la página 16
Grass Bag Fuel filter restricted, Take the mower to an authorized carburetor malfunction, Honda servicing dealer for repair. Remove the bag from the mower, and wash it with a garden hose or ignition malfunction, valves pressure washer. Allow the bag to dry completely before storage. stuck, etc. Drying Loss of Power After washing the lawn mower, wipe dry all accessible surfaces. Place the mower with its wheels on a level surface. Start the engine Possible Cause Correction outdoors and let i
Resumen del contenido incluido en la página 17
Emission Control System TECHNICAL INFORMATION Source of Emissions The combustion process produces carbon monoxide, oxides of Serial Number Locations nitrogen, and hydrocarbons. Control of hydrocarbons and oxides of nitrogen is very important because, under certain conditions, they react to form photochemical smog when subjected to sunlight. Carbon monoxide does not react in the same way, but it is toxic. ENGINE SERIAL NUMBER Honda utilizes appropriate air/fuel ratios and other emissions co
Resumen del contenido incluido en la página 18
Engine Design and Performance Air Index An Air Index Information hang tag/label is applied to engines certified Engine Model GSV160 to an emission durability time period in accordance with the 4-stroke, overhead-cam, requirements of the California Air Resources Board. Engine Type single-cylinder, forced air-cooled The bar graph is intended to provide you, our customer, the ability to Displacement 9.8 cu in (161 cc) compare the emissions performance of available engines. The lower the Air In
Resumen del contenido incluido en la página 19
FUEL SYSTEM MAINTENANCE When maintained properly, your Honda lawn mower should provide years of trouble-free operation. This includes the fuel system. However, gasoline can quickly deteriorate, causing starting or running problems and, in some cases, damage to the fuel system. Most fuel-related problems can be avoided by following the precautions listed below. Fuel system damage and engine performance problems resulting from deteriorated fuel are not covered by the Distributor’s Limited Warra
Resumen del contenido incluido en la página 20
How to Contact Honda CUSTOMER INFORMATION Honda Power Equipment dealership personnel are trained professionals. They should be able to answer any question you may have. If you encounter a problem that your dealer does not solve to Parts, Accessories, and Service Items your satisfaction, please discuss it with the dealership's management. The Service Manager or General Manager can help. Almost all Contact an authorized Honda servicing dealer to purchase any of problems are solved in this wa
