Manual de instrucciones de Associated Equipment 9050

Resumen del contenido incluido en la página 1

BATTERY CHARGER
OPERATOR'S MANUAL
ASSOCIATED
IMPORTANT SAFETY INSTRUCTIONS
1. SAVE THESE INSTRUCTIONS. This manual contains important safety and operating instructions for models 9006, 9010, 9014, 9050,
9060, 9070 & 9090. You may need to refer to these instructions at a later date.
2. CAUTION. To reduce risk of injury, charge only wet cell, lead-acid, automotive type rechargeable batteries. Other types of batteries may
burst causing personal injury and property damage.
3. Do not expose charg

Resumen del contenido incluido en la página 2

15. CHARGER LOCATION a. Locate charger as far away from battery as dc cables permit. b. Never place charger directly above battery being charged; gases from battery will corrode and damage charger. c. Never allow battery acid to drip on charger when reading gravity or filling battery, d. Do not operate charger in a closed-in area, or restrict ventilation in any way. e. Do not set a battery on top of charger. 16. DC CONNECTION PRECAUTIONS a. Connect and disconnect dc output clips only after sett

Resumen del contenido incluido en la página 3

20. OPERATING INSTRUCTIONS Before using review all safety and connection directions before using charger. Failure to do so can damage battery and cause serious injury or death. Manual Chargers Models: 9006, 9010 and 9050 FEATURES: All chargers come with a State of charge / Amp-meter 9006 — SELECT SETTING switch with the following selections; OFF, 6A–12V, 2A–12V and 6A–6V 9010 — SELECT SETTING switch with the following selections; OFF, 10A–12V, 2A–12V and 10A–6V 9050 — SELECT SETTING switch with

Resumen del contenido incluido en la página 4

FEATURES: All automatic chargers come with an Automatic On-off circuit (12V settings only and a State of charge / Amp-meter. 9014 — SELECT SETTING switch with the following selections; OFF, 10A–12V AUTO, 2A–12V AUTO and 10A–6V MANUAL 9060 — SELECT SETTING switch with the following selections; 55A START, 10A–12V, 2A–12V and 10A–6V MANAUL — SELECT FUNCTION switch with following selections; CHARGE and START — Charge Complete Indicator light. — Reverse connection indicator light. 9070 — SELECT SETTI

Resumen del contenido incluido en la página 5

3. ! Battery "eye" does not indicate a full charge even though charge complete indicator light is on. The battery is fully charged when the charge complete indicator light is on. Stratification of the electrolyte may prevent the battery eye from immediately indicating a full charge. Charging the battery for an additional hour with the charger SELECT FUNCTION switch set to START will in some instances restore the battery eye so it indicates a full charge. MAINTANENCE INSTRUCTIONS This charger r

Resumen del contenido incluido en la página 6

6