Manual de instrucciones de Dixon ZTR 428 D 429

Resumen del contenido incluido en la página 1

TECHNICAL DATA BROCHURE - ZTR 428 d 429 Page 1
IMPORTANT - READ OPERATOR'S MANUAL BEFORE OPERATING OR MAKING ADJUSTMENTS
Deluxe Seat Adjustment
Easy hand lever action allows forward and backward movement of seat. No bolts to loosen or
tighten.
Mower Blade Operation
1. To start mower blades, pull up slightly on blade drive switch handle and move it
forward to the "ON" position. 2. To stop mower blades, move switch
handle to the "OFF" position.

Resumen del contenido incluido en la página 2

Resumen del contenido incluido en la página 3

Resumen del contenido incluido en la página 4

Resumen del contenido incluido en la página 5

Resumen del contenido incluido en la página 6

Resumen del contenido incluido en la página 7

v~ \

Resumen del contenido incluido en la página 8

Resumen del contenido incluido en la página 9

THE FOLLOWING INSTRUCTION REFER TO 1989 PTOFUVYION 42” MOERT FRVKD Installation: 1. Position mower deck assembly under frame, raise front of mower deck assembly enough to allow cross shaft (P/N 1332) to slide through frame guides and mower deck guides. Install (1) washer (P/N 3094) and (1) hair pin cotter (P/N 3072) on each end of the cross shaft. 2. Attach short L-rod (P/N 1355) to lift a

Resumen del contenido incluido en la página 10

Page 10 4. Note: It is possible to install the engine to mower deck drive belt CP/N 6111) at this time; however, our engine manufacturers have suggested that this belt be installed after the engine has been fully serviced per manufacturers' suggestions and allowed to operate at 1/2 to 3/4 throttle settings for approximately C3) minutes. This will place the initial start up of the engine in a no load situation and allow complete