Resumen del contenido incluido en la página 1
Operator’s Manual
SERIES 7000
COMPACT TRACTOR
MODEL 7284
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved
forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark
arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective
working order by the operator. In t
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS TO THE OWNER .................................................................................................................... 2 CALLING SERVICE INFORMATION ...................................................................................... 2 RECORDING MODEL AND SERIAL NUMBER INFORMATION ........................................... 3 IMPORTANT SAFE OPERATION PRACTICES ..................................................................... 4 SAFETY LABELS ....................
Resumen del contenido incluido en la página 3
RECORDING MODEL AND SERIAL NUMBER INFORMATION Product identification plates are provided for major components of your tractor. The numbers on these plates are important if your tractor should require dealer service, or if you need additional information on your tractor. Prior to using your tractor for the first time, record the numbers from the identification plates in the appropriate spaces provided below. The tractor model plate is located on the right frame rail behind the right front tire
Resumen del contenido incluido en la página 4
IMPORTANT SAFE OPERATION PRACTICES WARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE YOUR UNIT. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. WHEN YOU SEE THIS SYMBOL, HEED ITS WARNING. WARNING: The engine exhaust, some of its constituents, and certain vehicle components contain or em
Resumen del contenido incluido en la página 5
Keep all movement on the slopes slow and Maintain the weight balance of the tractor. gradual. Do not make sudden changes in Install front end weights to counterbalance speed or direction. Rapid engagement or heavy implements attached to the three point hitch. Do not operate the tractor with a light braking could cause the front of the machine to front end. lift and rapidly flip over backwards which could cause serious injury. Any towed vehicle with a total weight exceeding that of the trac
Resumen del contenido incluido en la página 6
Escaping hydraulic fluid under pressure can To prevent injury, do not adjust, unclog, clean, penetrate the skin. If fluid is injected into the or service PTO driven equipment while the skin, seek immediate medical attention. Do not tractor engine is running. use your hand to check for leaks. Use a piece Make certain all PTO shie lds are always installed. of cardboard or paper. Never run a machine inside a closed area. 5. SAFETY FRAME (ROPS) To reduce fire hazard, keep the tractor fre
Resumen del contenido incluido en la página 7
SAFETY LABELS STARTING INSTRUCTIONS IGNITION 1. KNOW THE OPERATING AND SAFETY INSTRUCTIONS IN THE OPERATORS'S MANUAL AND ON THE TRACTOR. 2. MOVE THROTTLE TO MID POSITION AND DEPRESS BRAKE PEDAL. 3. TURN KEY TO THE START POSITION. STOPPING INSTRUCTIONS 1. DISENGAGE PTO AND SET PARKING BRAKE. 2. MOVE THROTTLE CONTROL TO MID POSITION AND TURN KEY OFF. WARNING AVOID SERIOUS INJURY OR DEATH. • GO UP AND DOWN SLOPES, NOT ACROSS. AVOID SUDDEN TURNS. DO NOT OPERATE UNIT WHERE IT COULD SLIP OR TIP.
Resumen del contenido incluido en la página 8
SAFETY LABELS (Cont.) WARNING To avoid personal injury, keep PTO shield in place. Pull only from draw bar. pulling from any other point can cause rear overturn. Disengage PTO and stop engine before servicing tractor, or implements, or attaching or detaching implements. FAILURE TO FOLLOW ANY OF THE INSTRUCTIONS ABOVE CAN CAUSE SERIOUS INJURY TO THE OPERATOR, OR OTHER PERSONS. PTO WARNING LABEL LOCATED ON REAR PTO SHIELD WARNING BATTERIES CON TAIN ACID AN D EXPLOSIVE GAS. EXPLOSION CAN RESULT F
Resumen del contenido incluido en la página 9
SECTION 1: CONTROLS AND FEATURES FLOORBOARD AND DASH PANEL MOUNTED CONTROLS M A B C L D K E F J H G Figure 1 A Steering Wheel G Seat Adjustment Lever B PTO Switch H Differential Lock Pedal C Throttle Handle J Parking Brake Lever D Ignition Switch K Hazard Light Switch E Brake Pedal L Headlight Switch F Forward/Reverse Pedal M Instrument Panel * Steering Wheel and Seat Phantomed For Clarity 9
Resumen del contenido incluido en la página 10
OFF - The engine and electrical system is turned NOTE: References to LEFT and RIGHT indicate off. that side of the tractor when facing forward while seated in the drivers seat. Reference to FRONT ON - The electrical system and glow plugs are indicates the grille end of the tractor; to REAR, the energized. drawbar end. START- The starter motor will turn the engine. Release the key immediately when the A. Steering Wheel engine starts The steering wheel is centered on the dash panel. It E. Brake Pe
Resumen del contenido incluido en la página 11
The parking brake lever is located below the H. Differential Lock Pedal steering wheel in the dash panel. With the brake Diff. Lock pedal fully depressed, push the parking brake lever Pedal downward and release the brake pedal to lock the Symbol parking brake. K. Hazard Light Switch Figure 6 Located at the rear of the left floor board, the differential lock pedal engages the transmission differential lock. The differential lock is used to gain additional trac- Figure 8 tion when operating t
Resumen del contenido incluido en la página 12
M. Instrument Panel 7 4 9 3 5 12 10 10 1 2 8 11 6 Figure 10 1. Fuel Gauge 7. PTO Indicator Light The fuel gauge monitors, at 20 second intervals, Light comes on in a fixed mode whenever the PTO the fuel level in the fuel tank. The needle pointing to switch is in the ON position, with the following the right indicates a full tank. The ignition switch exceptions. must be in the ON position to read the fuel gauge. • The light will illuminate in a flashing mode if 2. Tachometer attempting to start
Resumen del contenido incluido en la página 13
FENDER MOUNTED CONRTOLS AND FEATURES O E B A G F C D G N M H H J L J K K Figure 11 A Fuel Fill Cap H Amber Hazard Lights B PTO Reverse Override Switch J Tail Lights (Red) C PTO Selection Lever K Reverse Lights (White) D Hydraulic Lift Lever L Storage Tray E Trans. Hi/Lo Shift Lever M Foldable ROPS F Cup Holder N Seat Belt G Hand Holds O Auxiliary Hydraulic Control Handle A. Fuel Fill Cap C. PTO Selection Lever The PTO selection lever is located on the left The fuel fill cap is located on the
Resumen del contenido incluido en la página 14
K. Reverse Lights E. Transmission Hi/Lo Range Shift Lever The Hi/Lo range shift lever is located on the right The reverse lights illuminate when the tractor is fender. The lever has two speed range settings and being operated in the reverse direction. a neutral position. The lever must be shifted into L. Storage Tray either the high or low range prior to depressing the The storage tray is located behind the seat. Use the forward/reverse pedal to drive the tractor. tray to carry small loose artic
Resumen del contenido incluido en la página 15
SECTION 2: OPERATION ROLLOVER PROTECTIVE STRUCTURE (ROPS) FOLDING THE ROPS This tractor is equipped with a foldable Rollover The foldable ROPS feature allows the operator to Protection Structure (ROPS) and seat belts. When quickly lower the ROPS to operate in areas where used together they are effective in reducing injuries there is low overhead clearance. However, the to the operator in the event of an accidental tractor ROPS should be used in the lowered position only rollover. The safety prov
Resumen del contenido incluido en la página 16
Do not smoke while refueling the tractor. SAFETY INTERLOCK SYSTEM Do not fill the fuel ta nk when the engine is This tractor is equipped with a safety interlock running or while the engine is hot. system for the protection of the operator. If the interlock system should ever malfunction, do not The fuel fill cap is loca ted on the fender to the operate the tractor. Contact your authorized Cub left of the seat. Unscrew the fuel cap and fill Cadet Dealer. The safety interlock system prevents
Resumen del contenido incluido en la página 17
Observe the instrument panel. If the battery STARTING THE ENGINE indicator light, oil pressure light, or coolant WARNING: Always sit in the operator’s temperature light comes on, immediately stop seat when starting the tractor, Never the engine. Have the tractor inspected by your attempt to start the engine while Cub Cadet dealer. standing beside the tractor. WARNING: Never use starting fluids, COLD WEATHER STARTING such as ether, as a starting aid. Severe Ensure that the correct viscosity gra
Resumen del contenido incluido en la página 18
Before operating the tractor on a slope, walk the Turn the ignition key to the “OFF” position and slope to look for possible hazards such as rocks, remove the key from the ignition switch. mounds, stumps, or surface irregularities which NOTE: Always remove the key from the ignition could cause the tractor to be upset. switch to prevent accidental starting or battery discharge if the equipment is left unattended. Back the tractor with attachment up the steepest portion of each slope you intend
Resumen del contenido incluido en la página 19
LOW range — Shift the lever fully rearward in slot. BRAKE PEDAL Forward speed 0 to 6.4 mph. Reverse speed 0 to 3.2 mph. FORWARD/ REVERSE Low range is recommended for use with most PTO PEDAL driven tractor attachments. Low range must be used when climbing or descending slopes. Forward NEUTRAL — Shift the lever to the center of slot. Disengages the transmission drive. PARKING Heel/Toe Use ONLY for towing or moving the tractor when BRAKE Operation LEVER not under power. Reverse USING THE DIFFERENT
Resumen del contenido incluido en la página 20
Shift the PTO selection lever rearward to select USING THE HYDRAULIC LIFT LEVER the rear PTO. The rear PTO is used to drive The hydraulic lift system provides power for raising equipment designed to operate at an input and positioning three point hitch and belly mounted speed of 540 RPM. See Figure 19. equipment. The system’s position control feature maintains the selected height or depth of the PTO REVERSE equipment. When the hydraulic lift lever is moved to OVERRIDE PTO a higher or lower set
