Resumen del contenido incluido en la página 1
MCPN750A CompactPCI
Single Board Computer
Installation and Use
MCPN750A/IH5
September 2001 Edition
Resumen del contenido incluido en la página 2
© Copyright 2001 Motorola, Inc. All Rights Reserved. Printed in the United States of America. Motorola and the stylized M logo are registered trademarks of Motorola, Inc. PowerPC is a registered trademark of International Business Machines and is used by Motorola Inc. under license from IBM Corporation. CompactPCI is a registered trademark of PCI Industrial Computer Manufacturers Group. All other product or service names mentioned in this document are trademarks or registered trademarks of the
Resumen del contenido incluido en la página 3
Safety Summary The following general safety precautions must be observed during all phases of operation, service, and repair of this equipment. Failure to comply with these precautions or with specific warnings elsewhere in this manual could result in personal injury or damage to the equipment. The safety precautions listed below represent warnings of certain dangers of which Motorola is aware. You, as the user of the product, should follow these warnings and all other safety precautions necessa
Resumen del contenido incluido en la página 4
Flammability All Motorola PWBs (printed wiring boards) are manufactured with a flammability rating of 94V-0 by UL-recognized manufacturers. EMI Caution This equipment generates, uses and can radiate electromagnetic energy. It may cause or be susceptible to electromagnetic interference (EMI) if not ! installed and used with adequate EMI protection. Caution Lithium Battery Caution This product contains a lithium battery to power the clock and calendar circuitry. Danger of explosion if battery i
Resumen del contenido incluido en la página 5
CE Notice (European Community) This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take ! adequate measures. Warning Motorola Computer Group products with the CE marking comply with the EMC Directive (89/336/EEC). Compliance with this directive implies conformity to the following European Norms: EN55022 “Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equi
Resumen del contenido incluido en la página 6
Limited and Restricted Rights Legend If the documentation contained herein is supplied, directly or indirectly, to the U.S. Government, the following notice shall apply unless otherwise agreed to in writing by Motorola, Inc. Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (b)(3) of the Rights in Technical Data clause at DFARS 252.227-7013 (Nov. 1995) and of the Rights in Noncommercial Computer Software and Documentation clause at DFA
Resumen del contenido incluido en la página 7
Contents About This Manual Summary of Changes...............................................................................................xviii Overview of Contents ..............................................................................................xviii Comments and Suggestions .....................................................................................xviii Conventions Used in This Manual.............................................................................xix CHAPT
Resumen del contenido incluido en la página 8
CHAPTER 2 Startup and Operation Introduction ............................................................................................................... 2-1 Applying Power......................................................................................................... 2-1 Memory Maps............................................................................................................ 2-3 Processor Memory Map ......................................................................
Resumen del contenido incluido en la página 9
CHAPTER 4 CNFG and ENV Commands Overview....................................................................................................................4-1 CNFG - Configure Board Information Block............................................................4-2 ENV - Set Environment .............................................................................................4-3 Configuring the PPCBug Parameters .................................................................4-3 CHAPTER 5 Remo
Resumen del contenido incluido en la página 10
ISA DMA Channels .................................................................................. 6-10 Interval Timers .......................................................................................... 6-11 Real-Time Clock/NVRAM/Watchdog Timer Function ................................... 6-11 Replacing Lithium Batteries ..................................................................... 6-12 Hot Swap Control Circuitry ..................................................................
Resumen del contenido incluido en la página 11
TMCPN710 Transition Module COM1 Connector (J6)...................................7-19 TMCPN710 Transition Module COM2 Connector (J8)...................................7-20 TMCPN710 Transition Module COM3 Header (J11) ......................................7-20 TMCPN710 Transition Module COM4 Header (J14)......................................7-21 TMCPN710 Transition Module 10BaseT/100BaseTx Connector (J13) ..........7-22 TMCPN710 Transition Module USB Connectors (J10, J12) ........................
Resumen del contenido incluido en la página 12
xii
Resumen del contenido incluido en la página 13
List of Figures Figure 1-1. MCPN750A Base Board Block Diagram................................................1-2 Figure 1-2. MCPN750A Switches, Headers, Connectors, Fuses, LEDs ...................1-9 Figure 1-3. TMCPN710 Connector and Header Locations .....................................1-12 Figure 1-4. MCPN750A/TMCPN710 Serial Ports 1 and 2 .....................................1-14 Figure 1-5. TMCPN710 Serial Ports 3 and 4...........................................................1-15 Figure 1
Resumen del contenido incluido en la página 14
xiv
Resumen del contenido incluido en la página 15
List of Tables Table 1-1. Startup Overview ......................................................................................1-3 Table 1-2. Installing a PIM on the TM-PIMC-0001 Transition Module .................1-27 Table 2-1. Processor Default View of the Memory Map ...........................................2-3 Table 2-2. Classes of Reset and Effectiveness.........................................................2-10 Table 3-1. Debugger Commands ............................................
Resumen del contenido incluido en la página 16
Table 7-25. PMC I/O Modules 1 and 2 (PIM1 and PIM2) - PMC I/O Connector Pin Assignments..................................................................... 7-36 Table A-1. MCPN750 Specifications ...................................................................... A-1 Table B-1. Motorola Computer Group Documents ................................................. B-1 Table B-2. Manufacturers’ Documents ................................................................... B-2 Table B-3. Related Sp
Resumen del contenido incluido en la página 17
About This Manual This manual, MCPN750A CompactPCI Single Board Computer Installation and Use (MCPN750A/IH5) provides general information, hardware preparation and installation instructions, operating instructions, firmware information, functional descriptions, and pin assignments for the MCPN750A family of Single Board Computers. In addition, sufficient information is also provided for the two transition modules manufactured by Motorola for use with the MCPN750A (TMCPN710 and TM-PIMC- 000
Resumen del contenido incluido en la página 18
Summary of Changes The following is a list of changes made since the last release of this manual. Date Changes Replaces 09/01 Updated table of model numbers Previously listed model numbers. preceeding this section. Reinserted information left out of IH4 version of manual, which included information on MCPN750A, the TMCPN710 and the TM-PIMC-0001, instead of the earlier MCPN750. Also, included J8 jumper settings for Stand- Alone operation. 07/00 68-pin .08 Series Subminature D PMC I/O 68-pin
Resumen del contenido incluido en la página 19
Chapter 4, CNFG and ENV Commands, provides an explanation of two of the more important PPCBug configuration commands: CNFG and ENV. Includes information on how to configure the VMEbus and PCI bus environments using the ENV command. Chapter 5, Remote Start Via the PCI Bus, provides a description of the remote start capability that is available via the PCI bus using PPCBug commands. Chapter 6, Functional Description, provides a description of the major components and functionality of the MCP
Resumen del contenido incluido en la página 20
In all your correspondence, please list your name, position, and company. Be sure to include the title and part number of the manual and tell how you used it. Then tell us your feelings about its strengths and weaknesses and any recommendations for improvements. Conventions Used in This Manual The following typographical conventions are used in this document: bold is used for user input that you type just as it appears; it is also used for commands, options and arguments to commands, and nam
