Resumen del contenido incluido en la página 1
IBM Mobile Systems
ThinkPad Computer
Hardware Maintenance Manual
Resumen del contenido incluido en la página 2
Note Before using this information and the product it supports, be sure to read the general information under “Notices” on page 100. Second Edition (December 2000) The following paragraph does not apply to the United Kingdom or any country where such provisions are inconsistent with local law: INTERNATIONAL BUSINESS MACHINES CORPORATION PROVIDES THIS PUBLICATION “AS IS” WITHOUT ANY WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE LIMITED WARRANTIES OF MERCHANTA
Resumen del contenido incluido en la página 3
Contents Introduction .............1 Important service information.........1 Strategy for replacing FRUs........1 How to use error messages ........2 Diskette compatibility matrix.........2 Safety notices: multilingual translations......3 Safety information............12 General safety............12 Electrical safety ...........13 Safety inspection guide.........14 Handling electrostatic discharge-sensitive devices 15 Grounding requirements.........16 Laser compliance statement.........16 Genera
Resumen del contenido incluido en la página 4
1060 Ultrabay 2000 device........58 1070 Keyboard ...........60 1080 Keyboard CRU insulator.......63 1090 Hinge cover...........64 1100 Keyboard bezel and speaker......65 1110 Speaker cable ..........67 1120 Sub card............68 1130 PC Card slot assembly .......70 1140 Fan assembly ..........71 1150 Diskette drive ..........73 1160 Upper shield...........74 1170 System board ..........75 2010 LCD assembly..........77 2020 Front bezel...........79 2030 Inverter card ..........81 2040 LCD panel
Resumen del contenido incluido en la página 5
Introduction Important service information Important Diskette fixes are customer-installable. The diskette fixes are posted on the IBM support site (http://www.pc.ibm.com/support/). Advise customers to contact the PC Company HelpCenter at 800-772-2227 if they need assistance in obtaining or installing any diskette fixes. Customers in Canada should call IBM HelpPC at 800-565-3344 for assistance or download information. Strategy for replacing FRUs Before replacing parts Make sure that all diskette
Resumen del contenido incluido en la página 6
Important service information Attention The setup configuration on the computer you are servicing may have been customized. Running Automatic Configuration may alter the settings. Note the current configuration settings (using the View Configuration option); then, when service has been completed, verify that those settings remain in effect. Strategy for replacing a hard-disk drive Always try to run a low-level format before replacing a hard-disk drive. Attention The drive startup sequence in the
Resumen del contenido incluido en la página 7
Safety notices Safety notices: multilingual translations In this manual, safety notices appear in English with a page number reference to the appropriate translation in this section. The safety notices are provided in English, French, German, Italian, and Spanish, as follows: Safety notice 1 Before the computer is powered-on after FRU replacement, make sure all screws, springs, and other small parts are in place and are not left loose inside the computer. Verify this by shaking the computer and
Resumen del contenido incluido en la página 8
Safety notices Safety notice 2 Some standby batteries contain a small amount of nickel and cadmium. Do not disassemble a standby battery, recharge it, throw it into fire or water, or short-circuit it. Dispose of the battery as required by local ordinances or regulations. Use only the battery in the appropriate parts listing. Use of an incorrect battery can result in ignition or explosion of the battery. Certaines batteries de secours contiennent du nickel et du cadmium. Ne les démontez pas, ne l
Resumen del contenido incluido en la página 9
Safety notices Continuation of Safety notice 2 Alcune batterie di riserva contengono una piccola quantità di nichel e cadmio. Non smontarle, ricaricarle, gettarle nel fuoco o nell’acqua né cortocircuitarle. Smaltirle secondo la normativa in vigore (DPR 915/82, successive disposizioni e disposizioni locali). Quando si sostituisce la batteria dell’RTC (real time clock) o la batteria di supporto, utilizzare soltanto i tipi inseriti nell’appropriato Catalogo parti. L’impiego di una batteria non adat
Resumen del contenido incluido en la página 10
Safety notices Safety notice 3 The battery pack contains small amounts of nickel. Do not disassemble it, throw it into fire or water, or short-circuit it. Dispose of the battery pack as required by local ordinances or regulations. Use only the battery in the appropriate parts listing when replacing the battery pack. Use of an incorrect battery can result in ignition or explosion of the battery. La batterie contient du nickel. Ne la démontez pas, ne l’exposez ni au feu ni à l’eau. Ne la mettez pa
Resumen del contenido incluido en la página 11
Safety notices Safety notice 4 The lithium battery can cause a fire, an explosion, or a severe burn. Do not recharge it, remove its polarized connector, disassemble it, heat it above 100°C (212°F), incinerate it, or expose its cell contents to water. Dispose of the battery as required by local ordinances or regulations. Use only the battery in the appropriate parts listing. Use of an incorrect battery can result in ignition or explosion of the battery. La pile de sauvegarde contient du lithium.
Resumen del contenido incluido en la página 12
Safety notices Continuation of Safety notice 4 La batería de repuesto es una batería de litio y puede provocar incendios, explosiones o quemaduras graves. No la recargue, ni quite el conector polarizado, ni la desmonte, ni caliente por encima de los 100°C (212°F), ni la incinere ni exponga el contenido de sus celdas al agua. Deséchela tal como dispone la normativa local. 8 ThinkPad A21e
Resumen del contenido incluido en la página 13
Safety notices Safety notice 5 If the LCD breaks and the fluid from inside the LCD gets into your eyes or on your hands, immediately wash the affected areas with water for at least 15 minutes. Seek medical care if any symptoms from the fluid are present after washing. Si le panneau d’affichage à cristaux liquides se brise et que vous recevez dans les yeux ou sur les mains une partie du fluide, rincez-les abondamment pendant au moins quinze minutes. Consultez un médecin si des symptômes persisten
Resumen del contenido incluido en la página 14
Safety notices Safety notice 6 To avoid shock, do not remove the plastic cover that protects the lower part of the inverter card. Afin d’éviter tout risque de choc électrique, ne retirez pas le cache en plastique protégeant la partie inférieure de la carte d’alimentation. Aus Sicherheitsgründen die Kunststoffabdeckung, die den unteren Teil der Spannungswandlerplatine umgibt, nicht entfernen. Per evitare scosse elettriche, non rimuovere la copertura in plastica che avvolge la parte inferiore dell
Resumen del contenido incluido en la página 15
Safety notices Safety notice 8 Before removing any FRU, power off the computer, unplug all power cords from electrical outlets, remove the battery pack, and then disconnect any interconnecting cables. Avant de retirer une unité remplaçable en clientèle, mettez le système hors tension, débranchez tous les cordons d’alimentation des socles de prise de courant, retirez la batterie et déconnectez tous les cordons d’interface. Die Stromzufuhr muß abgeschaltet, alle Stromkabel aus der Steckdose gezoge
Resumen del contenido incluido en la página 16
Safety information Safety information The following section contains the safety information that you need to be familiar with before servicing an IBM mobile computer. General safety Follow these rules to ensure general safety: v Observe good housekeeping in the area of the machines during and after maintenance. v When lifting any heavy object: 1. Ensure you can stand safely without slipping. 2. Distribute the weight of the object equally between your feet. 3. Use a slow lifting force. Never move
Resumen del contenido incluido en la página 17
Safety information Electrical safety Observe the following rules when working on electrical equipment. Important Use only approved tools and test equipment. Some hand tools have handles covered with a soft material that does not insulate you when working with live electrical currents. Many customers have, near their equipment, rubber floor mats that contain small conductive fibers to decrease electrostatic discharges. Do not use this type of mat to protect yourself from electrical shock. v Find
Resumen del contenido incluido en la página 18
Safety information safety sections of maintenance information. Use extreme care when measuring high voltages. v Regularly inspect and maintain your electrical hand tools for safe operational condition. v Do not use worn or broken tools and testers. v Never assume that power has been disconnected from a circuit. First, check that it has been powered off. v Always look carefully for possible hazards in your work area. Examples of these hazards are moist floors, nongrounded power extension cables,
Resumen del contenido incluido en la página 19
Safety information To determine whether there are any potentially unsafe conditions, use the following checklist at the beginning of every service task. Begin the checks with the power off, and the power cord disconnected. Checklist: 1. Check exterior covers for damage (loose, broken, or sharp edges). 2. Power-off the computer. Disconnect the power cord. 3. Check the power cord for: a. A third-wire ground connector in good condition. Use a meter to measure third-wire ground continuity for 0.1 oh
Resumen del contenido incluido en la página 20
Safety information v Prevent the part from touching your clothing. Most clothing is insulative and retains a charge even when you are wearing a wrist strap. v Use the black side of a grounded work mat to provide a static-free work surface. The mat is especially useful when handling ESD-sensitive devices. v Select a grounding system, such as those listed below, to provide protection that meets the specific service requirement. Note The use of a grounding system is desirable but not required to pr
