Manual de instrucciones de American Standard Lakeland 4114.003

Resumen del contenido incluido en la página 1

Installation
Instructions
LAKELAND
4114.001
SINGLE CONTROL KITCHEN
4114.003
FAUCET WITH CAST SPOUT
with EverClean™ Finish
Congratulations on purchasing your American Standard faucet with
EverClean finish found only on American Standard faucets.
EverClean Finish
• One wipe effortlessly removes spots
Certified to comply with ANSI A112.18.1M
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful for the life of the faucet
• EverClean™ available on: Pol

Resumen del contenido incluido en la página 2

MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply to Hot (Marked with a Red Line) and right supply to Cold wall supply. Use 2 adjustable wrench to tighten connections. Do not over tighten. 1 Faucet supplies are 21" long from faucet base. COLD Note: If additional supply length is required, installer must purchase HOT additional pa

Resumen del contenido incluido en la página 3

SERVICE Reduced flow. If the flow gradually reduces over a number of months, the AERATOR (12) may have collected debris. To clean, remove AERATOR (12) and rinse with water and remove any debris. Turn on faucet to wash any debris out of the faucet. Thread AERATOR (12) back into spout. Operate faucet. Spout leakage. If fitting leaks above or below SPOUT HUB remove SPOUT as follows and check SPOUT O-RINGS. First turn off water supply. Remove HANDLE BUTTON (2) and loosen SET SCREW (1) with 2.5mm HEX W