Manual de instrucciones de American Standard Chandler 7048 Series

Resumen del contenido incluido en la página 1

™
M A D E W I T H
Installation
Instructions
CHANDLER™ APRON KITCHEN SINK
MODEL 7048 SERIES
Thank you for selecting American-Standard...the benchmark
Certified to comply with ANSI Z124.6
Patent Pending
of fine quality for over 100 years.
Observe local plumbing and building codes.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
790759-100 REV A
BEFORE YOU BEGIN...Unpack new sink and inspect carefully for damage. Replace the sink in

Resumen del contenido incluido en la página 2

1 SINK INSTALLATION SINK UPSIDE DOWN CENTER MARK ON C CENTER OF MOUNTING A BACKSIDE OF SINK ALIGN MARKS LOCATION MARKED ON B COUNTERTOP C Mark SIDE SINK PLACED VIEW UPSIDE DOWN X COUNTERTOP ON COUNTERTOP TOP COUNTERTOP VIEW C/L E A TRACE 22 THIS EDGE (559mm) X SHOULD BE MAXIMUM 25mm (1") D CABINET CABINET APRON FACE FACE EDGE X APRON PORTION OF SINK B A. Mark center of backside of sink. Mark center of location on counter top approx. 22in. from outside edge of countertop. B. Mark countert

Resumen del contenido incluido en la página 3

COUNTERTOP NOTCH 1b AND CABINET CUTOUT MARKED LINE OF SINK SINK CUTOUT LINE 10mm (3/8") CABINET FACE X TRACED LINE SINK CUTOUT OF SINK LINE A CUT LINES FRONT EDGE FOR NOTCH OF COUNTERTOP TOP VIEW FOLLOW THE SINK CUTOUT LINE VERTICALLY DOWN ON THE CABINET 9-1/4 (235mm) MARKED LINE OF SINK 32-1/4 MAX. 25mm (1") (819mm) B CABINET FACE COUNTERTOP CUTOUT OVERHANG-DIM "X" CABINET FACE A. The cut allows the apron portion of the sink to fit in the countertop. B. Cut the cabinet face per the diagram. C.

Resumen del contenido incluido en la página 4

Apply a generous portion of silicone sealant inside line 2 5 Mount the faucet and traced on countertop. Carefully lower sink into place drain assembly on the and press down firmly. Use guidelines for proper sink following the positioning. Using water to dampen your finger, remove excess sealant for a smooth even line. Apply manufacturer's additional sealant if necessary to provide a uniform instructions. bead from the rim of sink to the masking tape line as shown. Carefully remove tape.